-
Eiki LC-XG300L* - page 1
English Deutsch Fr ançais Italiano Español (*Models without lens.) Multimedia Pr oject or Quick Reference Guide MODEL LC-XG30 0/LC-XG250 LC-XG30 0L * /LC-XG250L * Use this book as a reference guide when set ting up the projector . F or detailed information about installation, setup, and operation of the projector , refer to the owner ’ s manual ...
-
Eiki LC-XG300L* - page 2
- 2 - CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE EXCEPT LAMP REPLACEMENT. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A RISK OF ELECTRIC SHOCK IS PRESENT WITHIN THIS UNIT. THIS SYMBOL INDICATES THAT THERE ARE IMPORTANT O ...
-
Eiki LC-XG300L* - page 3
- 3 - English All the safety and operating instructions should be read before the product is operated. Read all of the instructions given here and retain them for later use. Unplug this projector from AC power supply before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning. Follow all warnings and instructions marked on ...
-
Eiki LC-XG300L* - page 4
- 4 - Openings in the cabinet are provided for ventilation. To ensure reliable operation of the product and to protect it from overheating, these openings must not be blocked or covered. CA UTION Hot air is exhausted from the exhaust vent. When using or installing the projector, the following precautions should be taken. – Do not put any flammabl ...
-
Eiki LC-XG300L* - page 5
- 5 - English 10˚ 10˚ 10˚ 10˚ Do not tilt the projector more than 10 degrees from side to side. In upward projection, do not tilt the projector over 10 degrees right and left. Do not put the projector on either side to project an image. 10˚ 10˚ In downward projection, do not tilt the projector over 10 degrees right and left. Use the projector ...
-
Eiki LC-XG300L* - page 6
- 6 - Use the hand grip when moving the projector. Replace the lens cap and retract the adjustable feet to prevent damage to the lens and cabinet when carrying. When the projector is not in use for an extended period, put it into a suitable case to protect the projector. CA UTION IN CARR YING OR TRANSPORTING THE PR OJECT OR – Do not drop or bump ...
-
Eiki LC-XG300L* - page 7
- 7 - English Bot tom Bac k q Filter w Speaker e Lens Release Button r Top Controls and Indicators t Maintenance Cover WARNING: FOR MAINTENANCE USE ONLY. DO NOT OPEN. y Lens Cap (for LC-XG300/XG250) !7 !4 !6 !5 !2 !3 CAUTION Hot air is exhausted from the exhaust vent. Do not put heat-sensitive objects near this side. o !1 Infrared Remote Receiver ( ...
-
Eiki LC-XG300L* - page 8
- 8 - Rear T er minal q w e r t y i u t USB CONNECTOR (Series B) Use this connector when controlling a computer with the remote control of the projector. Connect the USB terminal of your computer to this connector with the supplied USB cable. y S-VIDEO INPUT JACK Connect the S-VIDEO output signal from video equipment to this jack. i AUDIO 2 JACK Co ...
-
Eiki LC-XG300L* - page 9
- 9 - English !0 R/C JACK When using the wired remote control, connect the wired remote control to this jack with a remote control cable (not supplied). !2 MONITOR OUTPUT TERMINAL (ANALOG) This terminal outputs the video signal from computer to external video equipment. ✽ RESET button A built-in micro processor which controls this unit may occasi ...
-
Eiki LC-XG300L* - page 10
- 10 - q w e t u i o w LAMP REPLACE indicator Lights yellow when the projection lamp reaches its end of life. q WARNING TEMP. indicator Blinks red when the internal temperature of the projector exceeds the operating range. e ON/STAND-BY button Turn the projector on or off. r INPUT button Select an input source. !1 INFO. button Display the input sou ...
-
Eiki LC-XG300L* - page 11
- 11 - English q STAND-BY button Turn the projector off. t ON button Turn the projector on. y INPUT 1 – 3 buttons Select a input source (INPUT 1 – INPUT 3). u AUTO PC button Automatically adjusts the computer image to its optimum setting. i FREEZE button Freeze the picture on the screen. o Point ed 7 8 ( VOLUME + / – ) buttons – Select an i ...
-
Eiki LC-XG300L* - page 12
- 12 - Remot e Control !3 MENU button Open or close the On-Screen Menu. !6 ZOOM ed buttons Zoom in and out the images. !5 D.ZOOM button Select the Digital zoom +/- mode and resize the image. @0 FOCUS button Adjust the focus. !8 MUTE button Mute the sound. !4 P-TIMER button Operate the P-timer function. @1 NO SHOW button Temporarily turn off the ima ...
-
Eiki LC-XG300L* - page 13
- 13 - English Projection angle can be adjusted up to 5.0 degrees with the adjustable feet. Rotate the adjustable feet and tilt the projector to the proper height; to raise the projector, rotate the both feet clockwise. To lower the projector or to retract the adjustable feet, rotate the both feet counterclockwise. To correct keystone distortion, p ...
-
Eiki LC-XG300L* - page 14
- 14 - When replacing the lens or using an optional lens, install the lens by following the instructions below. Ask the sales dealer for detailed information of the optional lens specifications. Fit the lens to the projector by aligning the red dot on the lens with the red dot of the projector. Remove the lens mount cover. 1 2 At taching the lens t ...
-
Eiki LC-XG300L* - page 15
- 15 - English ✔ Notes: • The brightness in the room has a great influence on picture quality. It is recommended to limit ambient lighting in order to obtain the best image. • All measurements are approximate and may vary from the actual sizes. For projector positioning, see the figures below. The projector should be set perpendicularly to th ...
-
Eiki LC-XG300L* - page 16
- 16 - This projector uses nominal input voltages of 100–120 V or 200–240 V AC and it automatically selects the correct input voltage. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce the risk of electrical shock, do not plug into any other type of power system. If you are not sure of the typ ...
-
Eiki LC-XG300L* - page 17
- 17 - English Connecting t o a Computer (Digital and Analog R GB) Cables used for connection • VGA Cable (HDB 15 pin)* • USB Cable • DVI-Digital Cable • Audio Cables (Mini Plug [stereo] x 2) • BNC Cable (*One cable is supplied; other cables are not supplied with the projector.) External Audio Equipment DVI-Digital cable USB cable Audio c ...
-
Eiki LC-XG300L* - page 18
- 18 - Connecting t o Video Equipment (V ideo, S-V ideo) Cables used for connection • Video Cables (RCA x 1) • Audio Cables (Mini Plug [stereo] x 2) • S-VIDEO Cable • BNC Cable • Audio Cable (RCA x 2) (Cables are not supplied with the projector.) External Audio Equipment Audio cable (stereo) VIDEO S-VIDEO S-video cable Video and audio cab ...
-
Eiki LC-XG300L* - page 19
- 19 - English Connecting t o Video Equipment (Component and RGB Scar t) Cables used for connection • Audio Cables (Mini Plug [stereo] x 2) • Scart-VGA Cable • BNC Cable • DVI-Digital Cable (Cables are not supplied with the projector.) External Audio Equipment Audio cable (stereo) Audio Input Component Video Output (Y, Cb/Pb, Cr/Pr) RGB Sca ...
-
Eiki LC-XG300L* - page 20
- 20 - Connect the projector’s AC power cord into an AC outlet. The POWER indicator lights green. Press the ON/STAND-BY button on the top control or the ON button on the remote control. The LAMP indicator lights red and the cooling fans start to operate. The preparation display appears on the screen and the count down starts. 2 3 1 The preparatio ...
-
Eiki LC-XG300L* - page 21
- 21 - English Press the ON/STAND-BY button on the top control or the STAND-BY button on the remote control, and “Power off?” appears on the screen. Press the ON/STAND-BY button or the STAND-BY button on the remote control again to turn off the projector. The LAMP indicator turns off and the POWER indicator starts to blink green. After the proj ...
-
Eiki LC-XG300L* - page 22
- 22 - T op Contr ol Menu bar Pointer (red framed ) Menu icon Item data Press the Point 7 8 buttons to adjust the value. SELECT button Pointer (red framed ) Press the Point ed buttons to move the pointer. Item Ho w to Oper ate the On-Scr een Menu MENU button SELECT button POINT buttons On-Scr een Menu Quit Exit this menu. The projector can be adjus ...
¿Tienes una pregunta acerca de Eiki LC-XG300L*?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Eiki LC-XG300L*, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Eiki LC-XG300L* probablemente compartirá una forma de solucionarlo.