-
SWR 2X10C - page 1
SWR • CORONA, CA • USA W orkingman’s 2X10C OWNER’S MANUAL ...
-
SWR 2X10C - page 2
2 • WORKINGMAN’S 2X10C INTRODUCTION Congratulations on your purchase of the W orkingman's 2x1 0C Bass Combo Amplifier! Y ou now own the most powerful combo amp in SWR's world-renowned W orkingman's Line of products, a line designed for bassists who expect typical SWR professional quality at affordable prices. In today's crow ...
-
SWR 2X10C - page 3
WORKINGMAN’S 2X10C • 3 WORKINGMAN'S 2X10C - FRONT PANEL FEATURES • Discrete Solid State Front End • Balanced XLR Output • Tuner Out Jack • High and Low Sensitivity 1/4" Input Jacks • Gain Control with LED peak clipping indicator • Aural Enhancer Control • Bass Level Control • Lo Mid Level Control • Mid Level Control ...
-
SWR 2X10C - page 4
4 • WORKINGMAN’S 2X10C Cabinet Construction and Features 5/8" 7-ply , Maple or Birch plywood construction, waterproof glue. All joints Dado and Rabbet, glued and nailed. Front Slot Port designed to eliminate unwanted noise Heavy Duty Removable Casters Heavy Duty Spring Handles Midnight Blue Carpeting with Stack Lock Corners Midnight Blue S ...
-
SWR 2X10C - page 5
WORKINGMAN’S 2X10C • 5 WORKINGMAN'S 2X10C - FRONT PANEL FEATURES BALANCED D.I. (XLR) OUTPUT The Balanced XLR output is a true balanced output. No front panel controls affect its signal. The tone and output levels are controlled only by the instrument plugged into one of the input jacks. T o use this feature, run an XLR cable from the Balan ...
-
SWR 2X10C - page 6
6 • WORKINGMAN’S 2X10C GAIN CONTROL The Gain control adjusts the volume of the preamp section. Since the Gain control is similar to a "pad," a small amount of sign al will be heard even with the Gain control rotated fully counter-clockwise ("MIN") if the Master V olume is up. After all EQ settings and the Aural Enhancer are ...
-
SWR 2X10C - page 7
WORKINGMAN’S 2X10C • 7 WORKINGMAN'S 2X10C - 5-BAND GRAPHIC EQ SECTION OVERVIEW Y our W orkingman's 2x1 0C comes equipped with a 5-band graphic equalizer for versatile, active tone shaping in an easy-to-use int er- face. Each of the five bands utilizes a slider control that can cut or boost its designated frequency range by up to 1 5db ...
-
SWR 2X10C - page 8
8 • WORKINGMAN’S 2X10C EFFECTS BLEND CONTROL The Effects Blend Control "blends" the signal sent from your instrument with the signal coming from an outboard effects unit of your choice. With the Effects Blend fully counter-clockwise ("DRY"), no signal from your outboard effects unit will be heard. As you turn this control cl ...
-
SWR 2X10C - page 9
WORKINGMAN’S 2X10C • 9 MASTER (VOLUME) CONTROL The Master (meaning "Master V olume") control adjusts the level being sent to the power amplifier in your W orkingman's 2x1 0C − it controls the overall volume of the unit. T urning the control counter-clockwise reduces the overall level, while turning the con trol clock- wise boos ...
-
SWR 2X10C - page 10
10 • WORKINGMAN’S 2X10C WORKINGMAN'S 2X10C - REAR PANEL FEATURES (chassis and cabinet) EFFECTS LOOP (for outboar d ef fects devices) As mentioned previously in the "Effects Blend Control" section of the manual, the Effects Blend circuit in your W orkingman's 2x 1 0C is similar to that used on recording consoles, with the eff ...
-
SWR 2X10C - page 11
WORKINGMAN’S 2X10C • 11 NOTE : Inserting a plug into the Effects Receive jack activates the Effects Blend control. The control receives this command through the ground created by the phone plug making contact with the jack. The plug must be a mono plug (tip and ground). If yo u have a stereo plug only, it will be necessary to tie the ring and t ...
-
SWR 2X10C - page 12
12 • WORKINGMAN’S 2X10C section of the W orkingman's 2x1 0C may occur if speaker enclosures with total impedances less than the minimum loads listed above are connected to the speaker output section. The owner's manual that came with your speaker cabinet should state its tota l impedance. On SWR speaker enclosures, the total impedance ...
-
SWR 2X10C - page 13
WORKINGMAN’S 2X10C • 13 NOTE : The frequency response of the Workingman's 2x10C is far greater than usually found in musical instrument amplifiers (20 Hz to 40K Hz). This was engineered in order to give the bass player the same punch and clarity on stage as found in the studio or concert P.A. systems. Therefore, it is doubly important that ...
-
SWR 2X10C - page 14
14 • WORKINGMAN’S 2X10C TWEETER MODE SWITCH Also located on the small panel on the rear of the W orkingman's 2x1 0C's speaker cabinet, this three-position switch gives you three different options for operation of the piezo tweeter . In the Full Range (top) position, the tweeter will reproduce an unattenuated sig- nal of ever y frequen ...
-
SWR 2X10C - page 15
WORKINGMAN’S 2X10C • 15 ...
-
SWR 2X10C - page 16
WORKINGMAN’S 2X10C LIMITED WARRANTY The WORKINGMAN’S 2X10C from SWR is war ranted to the original consumer pur chaser for ONE YEAR fr om the date of pur chase against defects in materials and workmanship, provided that it is pur chased fr om an Authorized SWR dealer . This war ranty applies only to pr oducts pur chased in the USA or Canada. Thi ...
¿Tienes una pregunta acerca de SWR 2X10C?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con SWR 2X10C, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con SWR 2X10C probablemente compartirá una forma de solucionarlo.