-
Sanyo CLT-A5822 - page 1
1 5.8 GHz Cordless Telephone with Caller ID & Visual Call Waiting INSTR UCTION MANU AL CLT-A5830 Dual Handset Models CLT-A5822 CLT-A5832 Important Charge the ha ndset battery for 12 continuous hours prior to first use. The picture depicts dual handset model SANYO Canada Inc. www.sanyo.ca sy5822 10 april.p65 2006/5/12, ¤U¤È 02:52 1 ...
-
Sanyo CLT-A5822 - page 2
2 INTRODUCTION ................................................................................................. 4 GETTING ST ARTED ......................................................................................... 5 Checking pa ckage contents ................................................................................ 5 Modular ja ck .. ...
-
Sanyo CLT-A5822 - page 3
3 Low battery warning .............................. ..................................................... 1 4 V oice mail indicator ...................................................................................... 1 5 CALLER ID FEA TURES ................................................................................. 1 5 Caller ID with Call ...
-
Sanyo CLT-A5822 - page 4
4 Congratulations on your purcha se of this SANYO cordless telephone. Y our SANYO 5.8 GHz cordle ss telephone is a fine-quality home communications product. It is carefully designed and produced by a world leader of consumer and industrial electronic equipment. With proper maintenance and care, it will provide you with years of enjoyment and conven ...
-
Sanyo CLT-A5822 - page 5
5 Modular jack Y ou need an RJ1 1 type modular phone ja ck. If you do not have a modular ja ck, call your local phone company to find out how to get one installed. Checking package contents Make sure your package includes the items shown here. GETTING ST ARTED Installation tips Some cordless telephones operate at frequencies that may cause interfer ...
-
Sanyo CLT-A5822 - page 6
6 Battery setup 1. Remove the battery compartment cover on the handset, insert the battery, plug the cord into the jack (inside the compartment) and replace the cover. 2. Set the handset RINGER switch to ON , and place handset in the base. Slide down the battery cover Place the battery in the slot Plug the wire into the jack Slide up the battery co ...
-
Sanyo CLT-A5822 - page 7
7 T one/pulse setting 1. If you have Pulse (rotary) service, you will need to set the dial mode to pulse. If you have T ouch-T one service, do nothing a s your phone ha s been set to T one prior to shipment. If you do not know which type of service you have, contact your local telephone company. 2. T o cha nge to Pulse or T one service, See Tone/pu ...
-
Sanyo CLT-A5822 - page 8
8 Handset NAMES AND CONTROLS 1. Belt clip 2. REDIAL key 3. Headset ja ck 4. * TONE/EXIT key 5. MEM (memory) key 6. CH (channel)/DEL key 7. Charging conta cts 8. Incoming call/in use LED 9. Earpiece 10. LCD screen 1 1. T ALK key (also used to end a call) 12. MUTE/FORMA T key (MUTE/FORMA T/TRANSFER key) 1 3. Ringer switch 14 . CID/VOL (volume) up/dow ...
-
Sanyo CLT-A5822 - page 9
9 Ba se Unit NAMES AND CONTROLS Charger (For CL T -A5822 and CL T -A5832) 1. Handset Cradle 2. Page Key 3. Charge/In Use LED 4. Charge LED 5. Charging conta cts 1 2 3 1 4 5 5 sy5822 10 april.p65 2006/5/12, ¤U¤È 02:52 9 ...
-
Sanyo CLT-A5822 - page 10
10 Before using this telephone, 4 initial settings must be completed on the handset: Language, Area code (this is required to use Caller ID service from your tele- phone compa ny), Ringer tone, and T one/Pulse setting. Language setting 1. Make sure the phone is OFF (not in T ALK mode). 2. Press FLASH/PROG until “ 1 ENG 2 FRA 3 ESP ” shows on sc ...
-
Sanyo CLT-A5822 - page 11
11 Resetting to default Y ou ca n reset the phone progra mming to the initial fa ctory default settings. The default settings are: Language English Area Code - - - Ringer T one 1 T one/Pulse Setting T on e 1. Make sure the phone is OFF (not in T ALK mode). 2. Pres s FLASH/PROG repeatedly until “ DE FA U LT 1 N O ” shows on screen. 3. Press CID ...
-
Sanyo CLT-A5822 - page 12
12 Making a call 1. Press T ALK . Note : If ha ndset is in the ba se cradle, re move it from ba se before pressing the T ALK key . 2. Dial the phone number. 3. Press T ALK to end your call. V olume adjustment The VOLUME key adjusts the volume level of the earpiece. There are 4 volume levels. 1. Ma ke sure the phone is in T ALK mode. 2. Press the CI ...
-
Sanyo CLT-A5822 - page 13
13 Pre-dialing (up to 32 digits) 1. Make sure the phone is OFF (not in T ALK mode). 2. Enter the telephone number. The number is displayed as you enter it. 3. Press T ALK . Note: Pressing *TONE will exit pre-dialing. Changing the pre-dial number 1. Make sure the phone is OFF. 2. Enter the telephone number. 3. Press CH/DEL to delete digits one by on ...
-
Sanyo CLT-A5822 - page 14
14 * TONE key This feature ena bles Pulse service phone users to acce ss touch-tone services offered by banks, credit card companies, etc. 1. Dial the desired number. 2 . Press *TONE after your call is answered. 3. Follow the voice instructions to complete your desired action. 4. Hang up when finished. The phone returns to Pulse service. Handset lo ...
-
Sanyo CLT-A5822 - page 15
15 This phone receives and displays incoming call information transmitted by your local phone company, provided you subscribe to Caller ID, and/or Call Waiting services. This information can include the phone number and/or the name, date and time. The phone can store up to 40 calls for later review. Caller ID with Call Waiting When you subscribe to ...
-
Sanyo CLT-A5822 - page 16
16 Caller ID list The incoming caller information transmitted from the phone company is received by your phone between the first and second ring and stored in the Caller ID list. If you answer a call before the second ring the caller information may not be stored. When the Caller ID list memory is full, a new call automatically replaces the oldest ...
-
Sanyo CLT-A5822 - page 17
17 Storing Caller ID entries in the directory Before storing a caller ID number , make sure the number a ppears in proper digits for your di aling area. If not, cha nge it using the MUTE/FORMA T key . For exa mple, if the Caller ID number appears 1-416-222-5555 but it is not a long distance number , press MUTE/FORMA T until it shows 416-222-5555 (w ...
-
Sanyo CLT-A5822 - page 18
18 Deleting all entries 1. Make sure the phone is OFF (not in T ALK mode). 2 . Use the CID/VOL or keys to display any entry. 3. Press a nd hold CH/DEL , until “DELETE ALL?” shows on screen. 4. Press CH/DEL again to confirm. “NO CALLS” shows on screen. Y ou can store up to 10 n a mes (up to 15 chara cters) and numbers (up to 24 digits) in th ...
-
Sanyo CLT-A5822 - page 19
19 a nd not a pause. Ea ch pause counts a s 1 digit in the dialing sequence. Or you can store redial number in the directory by pressing REDIAL (Note: If the redial number is longer than 24 digits, it cannot be stored into the memory.). 8. Press MEM again to store the number to memory . If you are repla cing a number, “REPLACE MEMO?” shows on s ...
-
Sanyo CLT-A5822 - page 20
20 Chain dialing from the directory Use this feature to ma ke calls that require a sequence of numbers such a s using a calling card for a frequently called long dista nce number . Y ou can di al ea ch part of the sequence from a different entry of the directory. The following example shows how you can use chain dialing to make a call through a lon ...
-
Sanyo CLT-A5822 - page 21
21 Make sure the telephone is off before you replace the battery. 1. Slide off the battery compartment cover. 2. Disconnect the battery plug from the ja ck in the compartment a nd remove the battery pack. 3. Insert the new battery pack and connect the cord into the jack. Note: Please refer to the pictures on page 6, “Battery setup” for guide. 4 ...
-
Sanyo CLT-A5822 - page 22
22 HEADSET JACK AND BEL T CLIP Headset connection (Headset not included) For hands free conversation, connect the headset (not included) to the HEADSET jack. The handset earpiece and microphone are disabled when the headset is connected. Press T ALK to answer or pla ce a call while using the hea dset. For purcha sing, servicing or repla cement ple ...
-
Sanyo CLT-A5822 - page 23
23 LCD SCREEN MESSAGES The following indicators show the status of a message or of the phone. BLOCKED NUMBER/ NAME/CALLER TRANSFERRING.. EMPTY ERROR ENTER NAME ENTER TEL NUMBR DELETE ALL? DELETE? END OF LIST HANDSET 1 HANDSET 2 P AGING INCOMPLETE DA T A MESSAGE WAITING NEW CALL NO CALLS NO DA T A REPT UNK NOW N NUMBER/ NAME/CALLER P AGING RINGER=OF ...
-
Sanyo CLT-A5822 - page 24
24 SOUND SIGNALS A long warbling tone Signals an incoming call Single T one A key is pressed Three short beeps Error tone T wo long beeps Confirmation tone One short beep and one long beep Page signal Three beeps every 2 seconds Transf er s ignal T wo short beeps every 15 seconds Low battery warning CALLER ID No display • Is battery fully charged ...
-
Sanyo CLT-A5822 - page 25
25 • When you press a button from the keypad, you should hear the confirmation "beep" from the handset. Try dialling more slowly and ensure you hear beep sounds. If not try pressing the sa me number again. My handset(s) have static noise • Try re-registering the ha ndset to the main ba se unit a s described in the manual. TELEPHONE No ...
-
Sanyo CLT-A5822 - page 26
26 If you hear 3 short bee ps when you press T ALK , you are out of ra nge. • Does the ba se need to be relocated? • Charge battery. • Make sure ba se is not plugged into a n outlet with another household a pplia nce. Phone beeps • Place ha ndset in ba se f or a minimum of 20 seconds to reset the security code. If that does not work, charge ...
-
Sanyo CLT-A5822 - page 27
27 Can’t hear the ring signal • Check the ringer volume controls; verify that the switch is not set to "Off". • Check that the AC power ada pter is plugged into a working AC power outlet. • Check all telephone cord connections or try a nother wall jack. Can’t receive or make phone calls • Check if the phone is set to the corre ...
-
Sanyo CLT-A5822 - page 28
28 I a m having diff iculty in pla cing and/or re ceiving calls. • If you experience difficulty with pla cing or receiving calls, a lost security code may be the cause of the problem. When this occurs, the handset can no longer communicate with the ba se. Reset by pla cing the ha ndset on the ba se for 5-10 se conds. If that does not work, unplug ...
-
Sanyo CLT-A5822 - page 29
29 MAXIMIZE BA TTER Y PERFORMANCE The freedom that your cordless telephone can offer is fully dependent on the performa nce of the rechargea ble battery in the handset. T o maximize the battery performance, follow these guidelines: Charge it for a full 12 hours Before initial use of your new battery, charge it for 12 hours continuously. The proper ...
-
Sanyo CLT-A5822 - page 30
30 TECHNICAL INFORMA TION REN Number: The Ringer Equivalence Number (REN) assigned to each terminal’s device provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The REN number of this phone is located on the bottom of the base unit. The termination on an interface may consist of any combinat ...
-
Sanyo CLT-A5822 - page 31
31 TECHNICAL INFORMA TION NOTICE: Privacy of communications may not be ensured when using this telephone. Other devices, including other cordless telephones, may interfere with the operation of this cordless telephone or cause noise during operation. Units without coded access may be accessed by other radio communication systems. Cordless telephone ...
-
Sanyo CLT-A5822 - page 32
32 Equi pment T echnical Specif ications. This is confirmed by the registration number. The abbreviation, IC, before registration number signifies that registration was performed based on a Declaration of Conformity indicating TECHNICAL INFORMA TION that Industry Canada technical specifications were met. It does not imply that Industry Canada appro ...
-
Sanyo CLT-A5822 - page 33
33 SANYO COMFORT W ARRANTY ORIGINAL RET AIL PURCHASER’S RESPONSIBILITY Y ou, the original retail purcha ser , must present your original, dated bill-of- sale together with this warranty to SANYO Canada Inc. or to an autho- rized SANYO Service Depot when you make a claim under this warranty. Y ou, the original retail purcha ser , are responsible f ...
-
Sanyo CLT-A5822 - page 34
34 At SANYO, fulfilling the needs of our customers is a priority. That’s why we created our SOS customer service progra m that guara ntees satisfa ction. NA TION WIDE CUSTOMER SUPPORT SOS is there to help you. Our friendly and knowledgeable product specialists will quickly answer your questions about setup and use of SANYO telephone products. Sim ...
¿Tienes una pregunta acerca de Sanyo CLT-A5822?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Sanyo CLT-A5822, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Sanyo CLT-A5822 probablemente compartirá una forma de solucionarlo.