-
Meade te346w - page 1
TE346W Slim W eather For ecaster with Indoor/ Outdoor T emperatur e, Indoor Humidity and Atomic Clock USER MANUAL ...
-
Meade te346w - page 2
INTRODUCTION Thank you for selecting a Meade Instruments W eather Forecaster . This device combines precise time keeping, monitoring and displaying of current temperature data from up to three remote locations (additional sensors are required). Meade Instruments is the world’ s leading designer and manufacturer of telescopes for professional and ...
-
Meade te346w - page 3
INST ALLA TION Communications between the main unit (receiver) and the remote sensor (transmitter) is wireless. This allows you to greater flexibility in choosing the location of remote sensor . The remote transmits data up to 164 feet (50 meters) over an open, unobstructed area. The remote sensor can be located either indoors or outdoors, allowing ...
-
Meade te346w - page 4
REMOTE TEMPERA TURE SENSOR (TS01) FEA TURES • Remote data transmission to the main unit via 433 MHz frequency • Single transmission channel • Case can be wall mounted using accessory hanger A. BA TTERY COMP ARTMENT • Holds two AAA-size batteries B. W ALL-MOUNT RECESSED HOLE • Mounts the remote sensor on the wall BA TTERY INST ALLA TION NO ...
-
Meade te346w - page 5
PLACEMENT • The remote sensor should be placed under eaves or a similar location with free air circulation, sheltered from direct sunlight and extreme weather . • Ideally , place the remote sensor over soil, rather than asphalt, which would cause false readings. • A void placing the remote sensor near sources of heat, such as chimneys and hea ...
-
Meade te346w - page 6
FRONT REAR A J K L C B F E D H I G 6 ...
-
Meade te346w - page 7
A. WEA THER/ OUTDOOR TEMPERA TURE window B. INDOOR TEMPERA TURE/ HUMIDITY window C. CLOCK window D. DOWN (? ) button • Select the next available mode • Press and hold for 2 seconds to search for wireless signal from remote sensor . • Decrease parameters. G. ALARM button • When time mode has been selected, press once to display the alarm tim ...
-
Meade te346w - page 8
BA TTERY INST ALLA TION • Remove the battery door located at the back of the main unit. • Insert two (2) CR2032 lithium cell batteries and replace the battery compartment door . PLACEMENT • When mounting the main unit on the wall or vertical surface, fold the table stand back into the unit. • Make sure that the main unit is locating within ...
-
Meade te346w - page 9
SEARCH FOR REMOTE SENSORS • The main unit can be manually activated to search for the signals from remote sensors by pressing and holding DOWN (? ) button. OPERA TION • T o select the indoor/ outdoor temperature mode, press UP (? ) or DOWN (? ) until the icon flashes with a beep sound alert. VIEWING REMOTE (CHANNEL) TEMPERA TURE Static Display: ...
-
Meade te346w - page 10
CLOCK WINDOW WWVB RADIO CONTROLLED TIME The NIST (National Institute of Standards and T echnology) radio station (WWVB) is located in Ft. Collins, Colorado. It transmits an exact time signal continuously throughout the most of the continental United States at 60 KHz frequency . The main unit can receive this WWVB signal through the internal antenna ...
-
Meade te346w - page 11
• The atomic clock receiver is programmed that it will search for the time signal daily for 0:00, 3:00, 6:00, and 12:00 am. • T o enable or disable the atomic time receiver , press and hold UP (? ) button for 3 seconds. If time reception is activated, a tower icon will start flashing. If reception is disabled, the tower icon will disappear . ? ...
-
Meade te346w - page 12
SETTING THE ICE W ARNING ALARM (PRE-AL) If W eekday (W) or Single day (S) alarm is MODE, the Ice W arning Alarm (Pre-AL) can be programmed. • Press ALARM button once to enter into the Ice W arning Alarm setting mode. The abbreviation OFF with a PRE-AL next to it will be displayed. • Press and hold ALARM button for two seconds. The number 30 wil ...
-
Meade te346w - page 13
PRECAUTIONS This product is engineered to give you years of satisfactory service if handled carefully . Here are a few precautions: • Do not immerse the units in water . • Do not clean the units with abrasive or corrosive materials. They may scratch the plastic parts and corrode the electronic circuits. • Do not subject the product to excessi ...
-
Meade te346w - page 14
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modification to this unit not expressly ...
-
Meade te346w - page 15
Battery Safety Instructions • Always purchase the correct size (2 x 1.5V AAA, 15A/15AC ANSI, LR6 IEC), (2 x ANSI/NEDA-5004LC, IEC-CR2032) and grade of battery most suitable for the intended use. • Replace all batteries of a set at the same time. • Clean the battery contacts and also those of the device prior to battery installation. • Ensur ...
-
Meade te346w - page 16
Meade Instruments Corp. 27 Hubble Irvine, CA 92618 U.S.A. © 2011 Meade Instruments Corp. All Rights Reserved. All user manual contents and information are subject to change. ...
¿Tienes una pregunta acerca de Meade te346w?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Meade te346w, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Meade te346w probablemente compartirá una forma de solucionarlo.