-
Airlink101 AP311W - page 1
802.11g Universal Wireless Repeater Model # AP311W User’s Manual Ver. 1C ...
-
Airlink101 AP311W - page 2
2 Table of Contents 1. Introduction ................................................................................................................................. 3 2. Using the Setup Wizard ...................................................................................................... ........ 4 3. Connecting to the Wireless Repeater ... ...
-
Airlink101 AP311W - page 3
3 1. Introduction Congratulations on your purchase of this 802.11g Universal Wireless Repeater. The Wireless Repeater extends the range of your access point/wireless router by repeating the signal to wireless clients that are beyond the broadcasting range of the access point/wireless router. This provides the wireless client s with greater flexibil ...
-
Airlink101 AP311W - page 4
4 2. Using the Setup Wizard Step 1 Verify the Repeater is powered on, inse rt the provided CD, and wait for the autorun screen to appear. Step 2 Click on Setup . Note: If the autorun screen does not appear automatically, go to Start , Run , type D:setup.exe (where D is the letter of your CD drive) and click OK . Step 3 Click Next and wait for the ...
-
Airlink101 AP311W - page 5
5 Step 4 Select the SSID (Network Name) of your access point / wireless router from the Selection list. Click Yes if you see your SSID in the list and you don’t have encryption enabled for your wireless network. Skip to Step 8 . Click Yes if you see your SSID and you have encryption enabled. Skip to Step 6 . Click Manual if you don’t see your S ...
-
Airlink101 AP311W - page 6
6 WEP Step 6a Select the same level of WEP encryption ( 64-Bits / 128-Bits ) of your wireless network from the drop-down menu. Step 6b Enter the same WEP key (password) of your wireless network in the Key 1 field and click Next . Skip to Step 8 . ...
-
Airlink101 AP311W - page 7
7 WPA-PSK Step 7a Enter the same Pre-Shared Key (passphrase) of your wireless network in the Pre-Shared Key field and click Next . Step 8 Select the Repeater from the list, verify the Repeater Name is AP311W , and click Yes . ...
-
Airlink101 AP311W - page 8
8 Step 9 The default password for entering the R epeater’s Web Config uration Utility is admin . To change the password, enter the new password in the Password field and click Enter . Step 10 If you know your Network IP Address settings, enter them in the applicable fields. If you are not sure, just click Next . ...
-
Airlink101 AP311W - page 9
9 Step 11 Review your new settings and click Yes continue. Step 12 Click Exit to exit the Setup Wizard. ...
-
Airlink101 AP311W - page 10
10 Step 13 For best result, place the Repeater at a central location between the wireless router and your wir eless computers. ...
-
Airlink101 AP311W - page 11
11 3. Connecting to the Wireless Repeater Once you have properly configured the R epeater, your wireless computers should be able to detect its signal. Use your wireless network adapter’s utility to detect and connect to the Repeater. You can identify the Repeater by its MAC Address , which is displayed in the BSS ID field of your wireless networ ...
-
Airlink101 AP311W - page 12
12 Step 3 The Repeater’s MAC Address is displayed on the Basic Setup page. If the signal is weak, try reorienting the R epeater’s antenna or relocate the Repeater to a different place. ...
-
Airlink101 AP311W - page 13
13 4. W eb Configuration Utility The Wireless Repeater comes with a built-in Web Configuration Utility that allows you to easily setup the Repeater with your web browser. This section describes how to use the Web Configuration Utility. 4.1 Basic Setup Step 1 Open your Web Browser (Internet Explor er or Netscape), enter the default IP Address of the ...
-
Airlink101 AP311W - page 14
14 The Basic Setup tab is the main screen for c onfiguring the Wireless Repeater. Firmware Version: Displays the current firmware version number. Name: Displays the name of the Wireless Repeater. IP Address: Assign an appropriate IP A ddress for the Repeater. Subnet Mask: Assign an appropriate Subnet Mask for the Repeater. Gateway : Assign an appro ...
-
Airlink101 AP311W - page 15
15 4.1.2 Configuring Wireless Security To enable Wireless Security, select Enable and click on Edit Security Settings . This Repeater supports both WEP and W PA Pre-shared Key encryption. It is recommended that use WPA Pre-shared Key encryption if your wireless network supports it. ...
-
Airlink101 AP311W - page 16
16 WEP The default security screen is the WEP scr een. Here you can setup the WEP settings for your wireless network. Note that these se ttings must be exactly the same as your access point/wireless router. Security Mode: Choose between WEP and WPA Pre-shared Key . Default Transmit Key: Select a key to be the active key. WEP Encryption: Choose betw ...
-
Airlink101 AP311W - page 17
17 WPA Pre-shared Key To use WPA Pre-shared key, choose WPA Pre-shared key from the Security Mode drop-down menu. WPA Shared Key : Enter a passphrase for your wireless network. Group Key Renewal : Enter the desired key renewal time in seconds. Note that these settings must be exactly the same as your access point/wireless router. Click on Save Sett ...
-
Airlink101 AP311W - page 18
18 4.2 Password The Password tab allows you to change the Repeater ’s login password as well as other administrative functions. Password: Enter the new login password and re- enter to confirm the new pas sword. Click Save Settings to apply the changes. Restore Factory Defaults: Select Yes and click on Save Settings to reset all of the Repeater’ ...
-
Airlink101 AP311W - page 19
19 4.3 Firmware The Firmware tab allows you to upgrade the Repeat er’s firmware. You can download the updated firmware from our web site at www.airlink101.com Step 1 Unzip the new firmware and then click on the Firmware Upgrade button. Step 2 Click on Browse to locate the new firmware and click on Upgrade to update the firmware. ...
-
Airlink101 AP311W - page 20
Federal Communication Commission Interference S t atement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limit s are designed to provide reasonable prot ection against harmful interference in a residential installation. This equi pment generates, uses and ...
-
Airlink101 AP311W - page 21
20 T echnical Support E-mail: support@airlink101.com Toll Free: 1-888-746-3238 Web Site: www.airlink101.com *Theoretical maximum wireless signal rate based on IEEE standard 802.11g specifications. Actual data throughput will vary. Network conditions and environmental factors, including volume of network traffic, bu ilding materials and c onstructio ...
Avez-vous une question à propos de Airlink101 AP311W?
Utiliser le formulaire ci-dessous
Si vous n’avez pas résolu votre problème avec Airlink101 AP311W, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Airlink101 AP311W il est probable qu’il a envie de partager la façon de le résoudre.