Manuel d’utilisation American Dryer Corp. CG20

16 pages 0.97 mb
Télécharger

Aller à la page of 16

Summary
  • American Dryer Corp. CG20 - page 1

    Ser vice Pr ocedur es f or the Model 20 Dr y er s (AD-20, SL20, CG20, D20, and STI-8 Dryers GEN II) ADC Part No. 450261 ...

  • American Dryer Corp. CG20 - page 2

    IMPORT ANT NO TE T O PURCHASER Information must be obtained from your local gas supplier on the instructions to be followed if the user smells gas. These instructions must be posted in a prominent location near the dryer . FOR Y OUR SAFETY Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other ...

  • American Dryer Corp. CG20 - page 3

    IMPORT ANT Y ou must disconnect and lockout the electric supply and the gas supply or the steam supply before any covers or guards are removed from the machine to allow access for cleaning, adjusting, installation, or testing of any equipment per OSHA (Occupational Safety and Health Administration) standards. Please observe all safety precautions d ...

  • American Dryer Corp. CG20 - page 4

    4 American Dryer Corp. 450261-2 Pa r t Locations and R emo val UPPER FRONT PANEL REMOV AL: Remove the four screws located just above the loading door . T ilt the bottom of the panel out and lif t the panel up and away from the dryer . LOWER FRONT PANEL REMOV AL: Remove the lint drawer . Remove the four screws located just below the loading door . T ...

  • American Dryer Corp. CG20 - page 5

    450261-2 www .amdry .com 5 BACK GUARD REMOV AL: Remove all facing visible screws. TOP COVER REMOV AL: With the back guard removed, the top is removed by pulling it toward the rear of the dryer and up. LINT BOX / BLOWER ASSEMBL Y REMOV AL: Unplug wires from Direct S park Ignition (DSI) module. Remove screws and nuts at the rear of the lint box. Unpl ...

  • American Dryer Corp. CG20 - page 6

    6 American Dryer Corp. 450261-2 LINT BOX / BLOWER ASSEMBL Y REMOV AL (continued): Pull the lint box down from the front and out slightly . T o remove motorized impellor assembly , remove five screws and four nuts shown at the arrows. Unplug three connections at the left of the lint box. The lint box may now be pulled out through the front of the dr ...

  • American Dryer Corp. CG20 - page 7

    450261-2 www .amdry .com 7 GAS V AL VE REMOV AL: Be sure to shut off the gas main and then proceed to remove electrical connections and screws indicated. Disconnect union and U-Bolt located just behind the union and the oven base. The U-Bolt is more easily accessed through the rear of the dryer . The gas valve and burner orifice can now be pulled o ...

  • American Dryer Corp. CG20 - page 8

    8 American Dryer Corp. 450261-2 TUMBLER SUPPORT WHEEL ASSEMBL Y REPLACEMENT : The front wheel assemblies can be replaced with the lower front panel removed. Remove the three bolts by reaching upward with a socket or box wrench. The illustration on the right is provided to show the location of these wheels as the wheels cannot easily be seen while s ...

  • American Dryer Corp. CG20 - page 9

    450261-2 www .amdry .com 9 TUMBLER ALIGNMENT : Proper alignment is achieved by making the gap between the tumbler and openings in the front and rear bulkheads equal on all sides. The gap may be checked for accuracy by using a thickness gauge. Adjust the tumbler position by loosening the three bolts and forcing the wheel assembly toward the center o ...

  • American Dryer Corp. CG20 - page 10

    10 American Dryer Corp. 450261-2 Electrical Component Locations ELECTRICAL P ANEL: The electrical panel is located behind the front upper panel. OVEN CONT ACTOR: Lower right front of the dryer (electric oven models). DOOR SWITCH: On upper front panel. J5 P14 T erminal Block A B C F1 J1 1 Oven Contactor Relay 1 Door Switch Relay 2 Blower Relay 3 Dri ...

  • American Dryer Corp. CG20 - page 11

    450261-2 www .amdry .com 11 FIRE SUPPRESSION SYSTEM ITEMS AND SAIL SWITCH: Rear of the dryer . DIRECT SP ARK IGNITION (DSI) MODULE: Lower right front of the dryer to left of the lint box. FLAME-PROBE: Under the gas oven and accessed from the rear of the dryer . Screw locations at arrows. FLAME-PROBE POSITIONING: Viewed from the rear of the dryer wi ...

  • American Dryer Corp. CG20 - page 12

    12 American Dryer Corp. 450261-2 EXHAUST PROBE, EXHAUST HI-LIMIT , AND LINT DRA WER SWITCH: T emperature probe and exhaust hi-limit are accessible once the lint box is removed. The lint drawer switch can be removed after the cover has been removed. ROT A TION SWITCH: Just behind the upper front panel, as viewed from the rear of the dryer with top r ...

  • American Dryer Corp. CG20 - page 13

    450261-2 www .amdry .com 13 Belt Installation Remove the back guard, front upper panel, and front lower panel. Cut the locking end off the plastic wire tie and use a piece of electrical tape to secure the wire tie to one end of the 4-foot section of electrical wire (Fig. 1). Push the wire tie between the tumbler felt and the middle front panel ring ...

  • American Dryer Corp. CG20 - page 14

    14 American Dryer Corp. 450261-2 Pull the belt up through the tumbler felt until there is enough belt to begin to loop the belt around the tumbler (Fig. 7 and 8). T ape the belt to the outside of the tumbler with duct t ape approximately 2-inches from the outside edge of the tumbler (Fig. 9). Rotate the tumbler slowly in the clockwise direction, wh ...

  • American Dryer Corp. CG20 - page 15

    450261-2 www .amdry .com 15 Pulling the belt through the tumbler felt gap will tend to flip the felt. Before pulling the last few inches out of the tumbler , lace the electrical wire back through the loop in the belt (Fig. 13 on the previous page). Pull the remaining belt and a couple of inches of wire out of the tumbler and into the area above the ...

  • American Dryer Corp. CG20 - page 16

    ADC Part No. 450261 2 - 09/15/05 - 1 ...

Fabricant American Dryer Corp. Catégorie Clothes Dryer

Les documents que nous recevons du fabricant de l'appareilAmerican Dryer Corp. CG20 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques American Dryer Corp.
- manuels d’utilisations CG20
- fiches produit American Dryer Corp.
- dépliants
- ou étiquettes-énergie American Dryer Corp. CG20
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation American Dryer Corp. CG20.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation American Dryer Corp. CG20, manuels d’entretien, brefs manuels ou manuels de l’utilisateur American Dryer Corp. CG20. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit American Dryer Corp. CG20.

Manuel d’utilisation complet de l’appareil American Dryer Corp. CG20, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser American Dryer Corp. CG20 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs American Dryer Corp. CG20.

Le manuel d’utilisation complet American Dryer Corp., devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel American Dryer Corp. CG20 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières American Dryer Corp. CG20, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lAmerican Dryer Corp. CG20 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil American Dryer Corp. CG20 - qui devraient nous aider dans les premières étapes lors de l'utilisation American Dryer Corp. CG20
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de American Dryer Corp. CG20
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service American Dryer Corp. CG20 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de American Dryer Corp. CG20?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec American Dryer Corp. CG20, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec American Dryer Corp. CG20 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)