-
MK Sound VX-7 MK II - page 1
Miller & Kreisel Sound Corporation 10391 Jefferson Boulevard Culver City, CA 90232 USA (310) 204-2854 FAX (310) 202-8782 © 1997 Miller & Kreisel Sound Corp. operation manual MX-SERIES: MX-300, MX-200, MX-125 Mk II, MX-105, MX-70B V -SERIES: V -125, V -75 Mk II, VX-7 Mk II powered subwoofers ...
-
MK Sound VX-7 MK II - page 2
page 2 powered subwoofers T ABLE OF CONTENTS 1 . SAFETY INSTR UCTIONS ................................................................................3 2. INTRODUCTION........................................................................................4 3. WHERE T O LOCA T E Y OUR SUBW OOFER....................................................4 4 ...
-
MK Sound VX-7 MK II - page 3
page 3 powered subwoofers 1. SAFETY INSTRUCTIONS 1. READ INSTRUCTIONS - All safety and operating instructions should be read before this product is operated. 2. RETAIN INSTRUCTIONS - The safety and operating instructions should be retained for future reference. 3. HEED WARNINGS - All warnings on this product and in the operating instructions should ...
-
MK Sound VX-7 MK II - page 4
page 4 powered subwoofers 2. INTRODUCTION Congratulations! You have just made perhaps the most exciting and dramatic addition that you could make to your audio or audio/video system. The new dimension of deep and powerful bass provided by your M&K Deep Bass Powered Subwoofer will thrill and excite you. We encourage you to read this owner's ...
-
MK Sound VX-7 MK II - page 5
page 5 powered subwoofers ST AND ARD AMPLIFIER/SPEAKER WIRE CONNECTIONS Many M&K subwoofer owners hook up their Subwoofer by connecting it to their receiver or amplifier using speaker wires. To do so, you make the same kind of connections that you would use for your Satellite (or main) speakers, except that both the left and right channels go t ...
-
MK Sound VX-7 MK II - page 6
page 6 powered subwoofers You now have two options for connecting your Satellite speakers. SA TELLITE SPEAKER WIRING OPTION 1 NOTE: For the MX-105, MX-70B, V-125, V-75 Mk II, or VX-7 Mk II, see below. With this option, you connect the wiring for the Satellites directly to the Subwoofer. There is no performance advantage with this method, but it may ...
-
MK Sound VX-7 MK II - page 7
page 7 powered subwoofers FIGURE 2 - SA TELLITE SPEAKER WIRING OPTION 1 (ALSO SHOWS USE OF THE SPEAKER-LEVEL HIGH-PASS FILTER) If your Amplifier has two sets of speaker outputs (e.g., A and B), you can connect the Satellites to one set and the Subwoofer to the other. But if you get weak or no output when you connect your speaker this way, connect b ...
-
MK Sound VX-7 MK II - page 8
page 8 powered subwoofers In the MX-300, MX-200, and MX-125 Mk II, a full-range signal (including deep bass) is fed to your Satellites. To roll off (filter) the signal fed to the Satellite speakers for biamplification, you must: 1. Have a separate amp and preamp OR a receiver or integrated amp that allows you to separate its amp and preamp stages. ...
-
MK Sound VX-7 MK II - page 9
page 9 powered subwoofers If you are using two Subwoofers, run the left channel interconnect cable to the left Subwoofer and the right channel cable to the right Subwoofer. USING THE HP-80 OR VF-80 ELECTR ONIC HIGH-P ASS FIL TERS The M&K HP-80 and VF-80 Electronic High-Pass Filters can improve the performance of any system that allows for separ ...
-
MK Sound VX-7 MK II - page 10
page 10 powered subwoofers play. Set the "BASS LEVEL" control where the Subwoofer sounds in balance with the Satellite speakers. If the system is not working properly, unplug the Subwoofer and check all of your connections. Call your dealer or the factory if you cannot solve any problem. The best way to set the level of the Subwoofer is t ...
-
MK Sound VX-7 MK II - page 11
page 11 powered subwoofers 6. USE OF THE "LO W P ASS FIL TER" CONTROL The back panel control "LOW PASS FILTER" sets the upper rolloff point of the Subwoofer, eliminating mid-bass and midrange that are being reproduced by your Satellite speakers. The control is a means of fine-tuning the transition between your Subwoofer and Sate ...
-
MK Sound VX-7 MK II - page 12
page 12 powered subwoofers A simple rule to remember is that you get more bass when you move the Subwoofer towards any wall or corner. Moving it away from a wall or corner gives you less bass. Remember that the floor also loads the Subwoofer, and that maximum bass is found with the woofer on the floor in a corner. The Subwoofer will probably sound ...
-
MK Sound VX-7 MK II - page 13
page 13 powered subwoofers front Left and Right channel speaker outputs (do not use the Center channel speaker output). VERY IMPORTANT: When the Subwoofer is connected to the Left and Right amplifier outputs (this means using speaker wires), and the controller is in Pro-Logic mode, the Center channel WIDE/ NORMAL switch MUST be set to the NORMAL mo ...
-
MK Sound VX-7 MK II - page 14
page 14 powered subwoofers . MX-70B: The MX-70B gives a very high level of performance in a compact cabinet. Therefore, it is likely to be installed in both vertical and horizontal locations. To avoid having its inverted driver exposed in installations where the cabinet is horizontal, the MX-70B has two speaker grills. If your MX-70B has a solid gr ...
-
MK Sound VX-7 MK II - page 15
page 15 powered subwoofers Make sure that the input cables are in phase. Reverse the (+) and the ( — ) connections for ONE CHANNEL ONLY at the "FROM AMPLIFIER" terminals. If the problem remains, put the cables back as they were. Then perform the test in Step 4. 4. If the midbass range (the area of transition between Subwoofer and Satell ...
-
MK Sound VX-7 MK II - page 16
page 16 powered subwoofers rev 15.0897 IF YOU NEED TO REPLACE THE EXTERNAL FUSE: Disconnect supply cord before changing fuse. Replace fuse only with same type. Remove the fuse cap. If the fuse cap has an arrow printed on it, push the cap in and turn it counterclockwise. If the fuse cap has a slot in it, use a flat head screwdriver to turn it counte ...
Avez-vous une question à propos de MK Sound VX-7 MK II?
Utiliser le formulaire ci-dessous
Si vous n’avez pas résolu votre problème avec MK Sound VX-7 MK II, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec MK Sound VX-7 MK II il est probable qu’il a envie de partager la façon de le résoudre.