Français dropdown-ico

Manuel d’utilisation Hobart ML-136500

24 pages 1.43 mb
Télécharger

Aller à la page of 24

Summary
  • Hobart ML-136500 - page 1

    INSTALLATION & OPERATIONAL MANUAL 1HFD & HFC SERIES ELECTRIC FRYERS With KleenScreen PLUS ® Filtration Systems MODELS: 1HF50D ML-136500 1HF85CF ML-136819 1HF85CF Shown - Computer Control ENERGY STAR® Qualified For additional information on Hobart or to locate an authorized parts and service provider in your area, visit our website at www. ...

  • Hobart ML-136500 - page 2

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -2- IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL ELECTRIC EQUIPMENT, WHO SHOULD PER FORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABL ...

  • Hobart ML-136500 - page 3

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -3- TABLE OF CONTENTS IMPORTANT FOR YOUR SAFETY……………………………… ………. 2 INTRODUCTION…………………… …………………………………… … 4 GENERAL…………………………… ……………………………… 4 ORDERING PARTS…? ...

  • Hobart ML-136500 - page 4

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -4- INTRODUCTION GENERAL Hobart Fryers are produced wit h quality workmanship and mate rial. Proper installation, usage and maintenance will result in year s of satisfactory performance. Before installing the fryer, thoroughly read th is manual and carefully fo llow all instructio ...

  • Hobart ML-136500 - page 5

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -5- Do not use the door or its handle to lift the fryer. MODEL - GMO Kw per Fry Tank Width Inch (cm) Total System Shortening lbs. (kg) Each Fry Tank 1HF50D 17 15.5" (39) 50 (23) 1HF85CF 24 21.0" (53) 85 (39) Voltage ranges are: 208, 3 Phase - 50 – 60 Hz 240, 3 Phase - ...

  • Hobart ML-136500 - page 6

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -6- CODES AND STANDARDS The fryer must be instal led in accordance with: In the United States:  State and local codes, or in the absence of local codes, with:  National Electrical Code, ANSI/NFPA-70 (latest edition). Copies may be obtained from The National Fire Protection A ...

  • Hobart ML-136500 - page 7

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -7-  Australia, use only the caster suppl ied by the manufactu rer for the fryer device. The fryer must be installed usi ng a hose assembly restraining device to limit the movement of the appli ance in accordance with AS1869.  The fryer must be installed with a connector (no ...

  • Hobart ML-136500 - page 8

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -8- LEVELING THE FRYER Check the level of the fryer by placing a level on top of the fr yer after electrical connections have been made. Ensure that the fryer is level front-to-back and side-to-side in the final installed position. If using casters, lock the wheels after unit is l ...

  • Hobart ML-136500 - page 9

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -9-  Wipe tank completely dry with a soft, clean cloth. FILLING TANK WITH SHORTENING  Close the drain valve.  Fill the fryer tank with shortening. Hobart recommends using liquid shortening.  Shortening level should be between the MIN and MAX lines in the fryer tank. ? ...

  • Hobart ML-136500 - page 10

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -10-  Batter covered foods should be dropped carefully , one by one, into shortening or basket. If you use the basket, first dip the basket into the shortening to reduce batter-build up on basket surfaces.  When frying is completed, remove ba sket or product. Hang basket on ...

  • Hobart ML-136500 - page 11

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -11- Programming the Solid State Control ...

  • Hobart ML-136500 - page 12

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -12- Programming the Computer Control ...

  • Hobart ML-136500 - page 13

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -13- TURNING OFF THE FRYER  Open the door to the fryer. Press t he power switch to the OFF position. EXTENDED SHUTDOWN 1. Open the door to the fryer. Press the power switch to the OFF position. 2. Thoroughly drain the fryer. Refer to DRAINING THE FRYER. 3. Clean the fryer accor ...

  • Hobart ML-136500 - page 14

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -14- DRAINING THE TANK 1. Open the door to the fryer. The power must remain ON for the fryer to filter correctly. 2. Insert the drain extension into t he drain valve. Tighten only hand tight. 3. Direct the drain spout into the container that you want to drain the shortening into. ...

  • Hobart ML-136500 - page 15

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -15- 9. Drain the tank according to DRAINING TH E TANK. Rinse thoroughly with clear, hot water. All traces of cleaner must be removed. Dry the tank thoroughly. 10. Close the drain valve and add shorteni ng. Follow the FILLING TANK WITH SHORTENING procedure in this manual. The frye ...

  • Hobart ML-136500 - page 16

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -16- KleenScreen Plus ® Filtration System Installation and Operational Manual for “HFF” Models 1HF85CF Shown Electric KleenScreen PLUS® Models 8 1HF85CF ML-136819 ...

  • Hobart ML-136500 - page 17

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -17- Filtering Instructions for KleenScreen PLUS ® Fryers General The KleenScreen PLUS ® filtration system filters the oil as it is pumped back into its’ respective tank(s). Only one tank can be drained and filter ed at a time. Under no circumstances should both tanks be drain ...

  • Hobart ML-136500 - page 18

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -18- Fully assembled filter screen assembly: F i g . 2 Secure Tube with Suction Tube Clip Filter Screen Lays Flat On Bottom of Filter Pan Fig. 3 Micro-Filtration Fabric Envelope Assembly: Same Suction Tube F a b r i c E n v e l o p e I n s e r t (Different from Screen Assembly) Fa ...

  • Hobart ML-136500 - page 19

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -19- INSTRUCTIONS TO REMOVE & REPLACE KLEENSCREE N PLUS ® FILTER ENVELOPE FOR ABSOLUTE FILTRATION & MAXIMUM FLOW RATE WE RECOMME ND YOU CHANGE YOUR FI LTER ENVELOPES AT EVERY OIL CHANGE (10-14 DAYS DEPENDING ON OIL USAGE). Step 1 Discard all oil from the filter vessel, (s ...

  • Hobart ML-136500 - page 20

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -20- Operation Hot oil and parts can cause burns. Use care when operating, cleaning and servicing the fryer. Spilling hot frying compound can cause severe burns. Do not move fryer wi thout draining all frying compound from the tank. Never run water or boil out solution thr ough fi ...

  • Hobart ML-136500 - page 21

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -21- Filtering Instructions for KleenScreen PLUS ® Fryers with Computer Controls ...

  • Hobart ML-136500 - page 22

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -22- FILTERING TIP: Open the filtering drawer approximately 1” to allow any oil in the re turn line to run back into the filter pan. This will take about 30 seconds to complete. Then open the drawer completely to clean filter components. REMOVING EXCESS DEBRIS FROM THE SCREEN FI ...

  • Hobart ML-136500 - page 23

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -23- BOIL OUT PROCEDURE: Use the Boil Out By-Pass™ drai n extension allowing the boil out solution to exit the fry t ank without using the filtering system. Do not allow water to run through the motor / pump. Drain the boil out solution into a bucket or place a hose on the end o ...

  • Hobart ML-136500 - page 24

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -24- MAINTENANCE Hot oil and hot parts can cause burns. Use care when operating, cleani ng, and servicing the fry er. Spilling hot fryer com pound can cause severe burns. Do not move fryer without draining all frying com pound from the tank. Service in the US and Canada Contact yo ...

Fabricant Hobart Catégorie Clothes Dryer

Les documents que nous recevons du fabricant de l'appareilHobart ML-136500 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Hobart
- manuels d’utilisations ML-136500
- fiches produit Hobart
- dépliants
- ou étiquettes-énergie Hobart ML-136500
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Hobart ML-136500.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Hobart ML-136500, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Hobart ML-136500. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Hobart ML-136500.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Hobart ML-136500, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Hobart ML-136500 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Hobart ML-136500.

Le manuel d’utilisation complet Hobart, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Hobart ML-136500 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Hobart ML-136500, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lHobart ML-136500 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Hobart ML-136500 - qui devraient nous aider dans les premières étapes lors de l'utilisation Hobart ML-136500
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Hobart ML-136500
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Hobart ML-136500 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Hobart ML-136500?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Hobart ML-136500, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Hobart ML-136500 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Captcha
Nouvelle image

Commentaires (0)