-
Jacuzzi Z101 - page 1
Z101/301 ™ WHIRLPOOL BA TH R Owner's Manual ...
-
Jacuzzi Z101 - page 2
IMPORT ANT SAFETY INFORMA TION READ AND FOLLOW ALL INSTRUCTIONS Read manufacturer’s safety information provided with all optional equipment. Warning — Risk of injury: Children, the elderly, and the infirm should not use the spa unless they are super- vised at all times. Infants should not be permitted in the spa at water temperatures over 100 ? ...
-
Jacuzzi Z101 - page 3
Contents Specifications ___________________________________________________ 2 Installation Inspection and Shipping Claim _______________________________________ 3 Positioning Your Spa _______________________________________________ 3 Electrical Requirements ____________________________________________ 3 Outdoor/Indoor Installation _________________ ...
-
Jacuzzi Z101 - page 4
SPECIFIC A TIONS Product specifications are subject to change without notice. DIMENSIONS 74-1/4" (1886 mm) L 62-5/16" (1582 mm) W 29" ( 737 mm) H PRODUCT WEIGHT 371 lb (169 kg) ELECTRICAL REQUIREMENTS* 115 VAC, 15 AMP, 60 Hz Requires Dedicated Separate Circuit. Equipped with GFCI Incorporated in Line Cord OPERATING GALLONAGE 192 U.S. ...
-
Jacuzzi Z101 - page 5
INST ALLA TION Inspection and Shipping Claim Check for shipping damage upon receipt of the spa. Jacuzzi Whirlpool Bath is not responsible for damage to the spa sustained during shipping. If damage is evident before unpacking, refer to instructions regarding ship- ping claims on the outside of the carton and immediately file a claim with the carrier ...
-
Jacuzzi Z101 - page 6
INST ALLA TION Outdoor Installation If you install the spa outdoors, we recommend that you provide a concrete pad for it to rest on. To do this, construct forms for a 4" thick level pad. Install a #10 gauge wire mesh 6" x 6" steel reinforced grid. Attach a #8 solid copper wire to the grid with a ground clamp. This wire should be long ...
-
Jacuzzi Z101 - page 7
INST ALLA TION Equipment Set-Up 1. Remove the plastic sheet covering the spa. NOTE: Stepping into the spa with shoes will scratch the acrylic surface. 2. Remove any packing materials from the spa. 3. Remove the filter cartridge from its plastic bag. 4. Pull open the skimmer/filter door by the handle lo- cated in the middle of the door and remove th ...
-
Jacuzzi Z101 - page 8
OPERA TION Operating Instructions Initial Instructions Using a garden hose, fill the spa with water to the water line indicator mark on the skimmer frame. WARNING: Do not provide power to the spa unless it is filled with water to the normal water level. Refer to water line indicator mark on skimmer frame. When- ever the power is ON, the system will ...
-
Jacuzzi Z101 - page 9
OPERA TION 7 Normal Operation/Whirlpool Sys- tem You can enjoy the spa with or without activating the whirlpool. Either way, bathing in your spa can be pleasurable, as well as therapeutic. After a busy, stressful day, you can look forward to soaking in your spa in still water with no turbulence—only the gentle warmth of the soothing and relaxing ...
-
Jacuzzi Z101 - page 10
MAINTEN ANCE 8 W ater Quality and W ater Chemistry Maintaining water quality and water chemistry in your spa is extremely important and should be a regular part of your spa maintenance program, as a neglected spa can be a breeding place for dangerous bacteria. The water quality of your spa is maintained by a combination of filtration and chemistry. ...
-
Jacuzzi Z101 - page 11
MAINTEN ANCE Balancing pH For good hygiene and equipment longevity, main- tain the pH of your spa water according to the instruc- tions provided. pH is the measure to determine if the spa water is too acidic (low pH), or too alkaline (high pH). The ideal range for spa water is 7.4 to 7.6 pH. For excessive acidity (below 7.2 pH) add soda ash or sodi ...
-
Jacuzzi Z101 - page 12
MAINTEN ANCE The suction cover located in the foot well area should be checked at least once a week for collected debris, such as leaves, hair, etc., and cleaned as necessary. It may not be necessary to remove the suction cover to clean it, but if you need to, remove the center screw with a Phillips screwdriver and clean the cover by flushing with ...
-
Jacuzzi Z101 - page 13
MAINTEN ANCE Automatic Filtration/Maintenance If you plan to be away, minimum water quality will be maintained by running the filter system. If you will be away for an extended period, however, we recommend that you drain the spa (following the procedure described under Winterizing on this page), as long periods without maintenance of water quality ...
-
Jacuzzi Z101 - page 14
MAINTEN ANCE 12 Covering Y our Spa An optional rigid spa cover for your spa is available from your Jacuzzi Whirlpool Bath dealer. Use of this cover will help to reduce energy costs by minimizing heat loss and evaporation. In addition, the attractive cover is an effective means of preventing debris such as leaves and dirt from entering your spa when ...
-
Jacuzzi Z101 - page 15
Jacuzzi Whirlpool Bath Limited W arranty Z101/301 Spa Jacuzzi Whirlpool Bath P .O. Drawer J W alnut Creek, CA 94596-9885 WARRANTY COVERAGE Jacuzzi Whirlpool Bath (the “Company”) offers the following express limited warranty to the original purchaser of any Jacuzzi Whirlpool Bath Spa Line Product (“unit”) who purchases the product for person ...
-
Jacuzzi Z101 - page 16
RESPONSIBILITIES OF OTHERS Inspecting the unit prior to installation is the responsibility of the installer or building contractor who acts on behalf of the user. They are responsible for ensuring the unit is free of defect or damage. Notices are placed on and in the unit and on the shipping carton advising the installer of this responsibility. In ...
Avez-vous une question à propos de Jacuzzi Z101?
Utiliser le formulaire ci-dessous
Si vous n’avez pas résolu votre problème avec Jacuzzi Z101, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Jacuzzi Z101 il est probable qu’il a envie de partager la façon de le résoudre.