-
Sub-Zero 315W - page 1
I NST ALLA TION &O PERA TION M ODEL 315W W INE C OOLER ...
-
Sub-Zero 315W - page 2
SUB-ZERO ® is a registered trademark of Sub-Zero Freezer Company , Inc. As you follow these instructions, you will notice W ARNING and CAUTION symbols. This blocked information is important for the safe and efficient installation of Sub-Zero equipment. There are two types of potential hazards that may occur during installation. Another footnote we ...
-
Sub-Zero 315W - page 3
3 THANK Y OU Congratulations on the purchase of your Sub-Zero Model 315W wine cooler . This unit is designed and manufactured in the Sub-Zero tradition of superior quality and reliability . The importance of the installation of the Model 315W wine cooler cannot be overemphasized. Installation should be done by a qualified installer . Before you beg ...
-
Sub-Zero 315W - page 4
4 MODEL 315W FEA TURES Undercounter wine cooler with 26 (750 ml) bottle capacity Overlay and stainless steel design options Ideal humidity and temperature range of 45˚F (7˚C) to 55˚F (13˚C). Sturdy , rustproof wire shelves accommo- date standard 750 ml bottles, half-bottles, as well as magnums Roller -glide shelves faced with natural cherry woo ...
-
Sub-Zero 315W - page 5
5 Dimensions in parentheses are in millimeters unless otherwise specified. INST ALLA TION SPECIFIC A TIONS MODEL 315W DIMENSIONS Overall Width 15 1 / 8 " (384) Overall Height 34 1 / 16 " (865) Overall Depth – 315W/S 23 5 / 32 " (588) Overall Depth – 315W/O 22 3 / 8 " (568) Rough Opening Width 15 1 / 4 " (387) Rough Open ...
-
Sub-Zero 315W - page 6
Dimensions in parentheses are in millimeters unless otherwise specified. 6 SUB-ZER O MODEL 315W INST ALLA TION INST ALLA TION SPECIFIC A TIONS AREA REQUIREMENTS Before moving the unit into place, be sure that the rough opening dimensions, electrical location, and minimum door clearances are accurate. Refer to the illustration below . Also Refer to ...
-
Sub-Zero 315W - page 7
7 SUB-ZER O MODEL 315W INST ALLA TION KICKPLA TE AIRFLO W The wine cooler uses a fan to take in room air through vents in the left side of the kickplate, and discharges warm air through vents in the right side. These vents must be kept clear of obstructions or decorative panels. Blocking or obstructing the kickplate will restrict air flow and cause ...
-
Sub-Zero 315W - page 8
Dimensions in parentheses are in millimeters unless otherwise specified. 8 SUB-ZER O MODEL 315W INST ALLA TION LEVELING THE UNIT BLOCKING FOR SAFETY A metal antip-tip bracket and screws are provided with the unit. Attach the anti-tip bracket to the top of the unit, opposite the hinge side. The bracket offset flange should be facing up with the two ...
-
Sub-Zero 315W - page 9
9 SUB-ZER O MODEL 315W INST ALLA TION P ANEL CONSIDERA TIONS The Model 315W offers two door panel design alternatives; stainless steel (/S) or overlay (/O). Both of these design options are available with glass (G) doors. Model 315W/S (classic stainless steel) is shipped from the factory with the decorative stainless steel door panel and matching h ...
-
Sub-Zero 315W - page 10
Dimensions in parentheses are in millimeters unless otherwise specified. 10 SUB-ZER O MODEL 315W INST ALLA TION Inspect the door panel for the minimum 5 / 8 " (16) thickness, the finished inside edge and the 10 lbs (5 kg) weight limit. See the Wine Storage section of the Sub-Zero Design Guide for additional panel information. Check our website ...
-
Sub-Zero 315W - page 11
O VERLA Y P ANEL INST ALLA TION A decorative panel is attached to the Model 315W door using # 8 x 5 / 8 " (16) square drive screws passing through the door frame from the rear , behind the gasket into the panel. The door panel is marked for screw locations by the use of 'tenon centers', which are temporar- ily inserted into the 1 / 4 ...
-
Sub-Zero 315W - page 12
12 SUB-ZER O MODEL 315W INST ALLA TION O VERLA Y P ANEL INST ALLA TION IMPORT ANT NOTE: Install screws in all the mounting holes in the door frame. The nature of the door panel with a narrow outer rim and no connecting center member requires the support provided by the glass door . After the door panel installation is complete, apply the cover patc ...
-
Sub-Zero 315W - page 13
13 SUB-ZER O MODEL 315W INST ALLA TION If you are storing or disposing of your old refrigerator or freezer , please do it safely . Remove the doors or tightly secure the doors closed. Child entrapment accidents can be tragic. CONT ACT INFORMA TION Sub-Zero Customer Service: 800-222-7820 Website: subzero.com INST ALLA TION CHECKLIST IMPORT ANT NOTE: ...
-
Sub-Zero 315W - page 14
14 SUB-ZER O MODEL 315W OPERA TION When fully loaded with room temperature wine, the Model 315W will operate continu- ously for as long as 24 hours to reach the desired temperature. After reaching the set temperature, the unit will begin to cycle on and off. IMPORT ANT NOTE: A unit fully loaded with wine will run less than a unit which is partially ...
-
Sub-Zero 315W - page 15
15 SUB-ZER O MODEL 315W OPERA TION WINE SHELF REMO V AL T o remove a wine shelf, pull the shelf out to its full extension, gently and evenly lift up on both sides of the front of the shelf and remove. Reverse the procedure to reinstall the shelf. IMPORT ANT NOTE: Wine shelf removal will be more difficult if the door cannot open to a minimum of 120? ...
-
Sub-Zero 315W - page 16
16 SUB-ZER O MODEL 315W OPERA TION CLEANING THE CONDENSER The air -cooled condenser should be vacuumed two to three times per year to remove any lint that may have been drawn into the condenser . T o access the condenser , use a phillips head screw driver to remove the kickplate as shown in the illustration below . Then using a soft bristle brush, ...
-
Sub-Zero 315W - page 17
17 SUB-ZER O TROUBLESHOO TING GUIDE TROUBLESHOO TING GUIDE PR OBLEM POSSIBLE CAUSE POSSIBLE SOLUTION Cabinet too warm Unit switched off Check temperature control Cabinet temperature T emperature control setting Check temperature setting changed changed Excessive operating time Dirty condenser Clean condenser Cabinet full of warm wine Unit must oper ...
-
Sub-Zero 315W - page 18
18 SER VICE INFORMA TION If you do need service, be sure to have the model and serial number of your unit when you call. Y ou’ll find these numbers on the model and serial number plate located on the underside of the top wall. For warranty purposes, you will also need the date of installation and the name of your Sub-Zero dealer . Record this inf ...
-
Sub-Zero 315W - page 19
19 S UB- Z ERO F REEZER C OMP ANY P RODUCTS L IMITED W ARRANTY RESIDENTIAL USE ONL Y FULL FIVE YEAR SEALED SYSTEM W ARRANTY LIMITED SIXTH THROUGH TWELFTH YEAR W ARRANTY ON THE SEALED SYSTEM FULL TWO YEAR W ARRANTY ON TOT AL PRODUCT* FULL FIVE YEAR SEALED SYSTEM W ARRANTY For five y ears from the date of original installation, y our Sub-Zero warrant ...
-
Sub-Zero 315W - page 20
17 3 0 8 001 8 / 2005 S UB-ZERO FREEZER COMP ANY , INC. P . O . BO X 441 3 0 MADI S ON, WI 5 3 744-41 3 0 8 00-222-7 8 20 S UBZERO .COM ...
Avez-vous une question à propos de Sub-Zero 315W?
Utiliser le formulaire ci-dessous
Si vous n’avez pas résolu votre problème avec Sub-Zero 315W, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Sub-Zero 315W il est probable qu’il a envie de partager la façon de le résoudre.