Manuel d’utilisation Hunter Fan 81003

14 pages 3.58 mb
Télécharger

Aller à la page of 14

Summary
  • Hunter Fan 81003 - page 1

    41937-01 10/26/2010 1 Bath V entilator with Light Owner ’ s Manual Ashbury 41937-01 20101026 ©2010 Hunter Fan Co. Model 81003 English ...

  • Hunter Fan 81003 - page 2

    41937-01 10/26/2010 2 DISCONNECT ELECTRIC POWER SUPPL Y AND LOCK OUT SER VICE P ANEL BEFORE SER VICING UNIT W ARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJUR Y TO PERSONS, OBSERVE THE FOLLOWING: 1. For general ventilating use only . Do not use to exhaust hazard- ous or explosive materials and vapors. 2. T o avoid motor bearing damage an ...

  • Hunter Fan 81003 - page 3

    41937-01 10/26/2010 3 E F G H I L M N 95047-03-000 77481-01-000 03242-07-133 95261-02-000 74508-03-133 96397-01-214 for model 81001 96397-02-444 for model 81003 75184-01-133 86812-01-000 J 77522-01 K 65219 O 75733-01-214 for model 81001 75733-01-444 for model 81003 x4 * * * NOTE: Strain relief cable connector must be installed. Not Included. A B C ...

  • Hunter Fan 81003 - page 4

    41937-01 10/26/2010 4 5 4 7 G 8 F Remove the motor/blower from the housing. H E 3 Remove the pre-loaded screw tip covers. Remove the wiring cover screw. 6 Back out the pre-loaded screw tips until flush with the side of the housing. Remove the wiring cover . Remove packing material. ...

  • Hunter Fan 81003 - page 5

    41937-01 10/26/2010 5 9 E Pop out the first wiring access slug. Use second if needed. Insert the strain relief (not included) into the housing and secure with washer . Position the correct depth mark at the bottom edge of the joist based on the thickness of your sheetrock. New Construction 1 0 B C Choose Installation Option For New Construction - g ...

  • Hunter Fan 81003 - page 6

    41937-01 10/26/2010 6 A 3 Pin 2 Pin Fan Motor Light Light Green Black Black White Black Black White White Bare Copper Ground A 1 4 Main Switch 1 (AC In) Switch 2 (AC In) *Option Fan & Main Light T ogether *Option Connect wires as shown. A 1 3 Route wires through the strain relief. For supply connection, use wires suitable for at least 90º C (1 ...

  • Hunter Fan 81003 - page 7

    41937-01 10/26/2010 7 A 1 9 I A 2 0 Reinstall the motor by inserting the tabs and pushing up into position. Make sure the wires are not pinched between the motor and the housing. Secure the motor by tightening the 2 screws. T urn on the power source. Connect wiring harness. DO NOT ALLOW THE MOTOR TO HANG FROM THE WIRING HARNESS. 0 0 0 0 0 0 0 0 A 1 ...

  • Hunter Fan 81003 - page 8

    41937-01 10/26/2010 8 EXISTING F AN B 1 1 E B 1 2 Existing Construction B 1 3 2 1 B 1 4 Route wires through the strain relief. For supply connec- tion, use wires suitable for at least 90º C (194º F). Remove an existing fan and check to make sure the opening is large enough to accommodate the new motor housing (7 1/4”x 7 3/4”). Move the housin ...

  • Hunter Fan 81003 - page 9

    41937-01 10/26/2010 9 H B 1 8 H B 1 9 B 2 0 I Reinstall the motor by inserting the tabs and pushing up into position. Make sure the wires are not pinched between the motor and the housing. Connect wiring harness. DO NOT ALLOW THE MOTOR TO HANG FROM THE WIRING HARNESS. Secure the motor by tightening the 2 screws. A 3 Pin 2 Pin Fan Motor Light Light ...

  • Hunter Fan 81003 - page 10

    41937-01 10/26/2010 10 O N O FF B 2 2 B 2 3 C1 Go to step on page 10 to attach grille . B 2 1 T est the motor . If the motor does not run, check the plug connection. T urn on the power source. L O C 2 N M C 1 Attaching the Grille Remove the thumbscrews. Remove glass dome. ...

  • Hunter Fan 81003 - page 11

    41937-01 10/26/2010 1 1 C 4 K C 5 J C 6 Remove the strain relief bracket screw. Position the strain relief bracket under the motor as shown. Insert the strain relief bracket’s dog-leg tab so that it hooks over the lip of the motor . Reinstall the strain relief bracket screw. L C 3 Connect wiring harness. DO NOT ALLOW THE FIXTURE TO HANG FROM THE ...

  • Hunter Fan 81003 - page 12

    41937-01 10/26/2010 12 C 9 C 1 0 N O C 1 1 Align glass dome and push up. Install 2 Max 60 Watt A15 bulbs (Not Included). Screw glass dome into position. ...

  • Hunter Fan 81003 - page 13

    41937-01 10/26/2010 13 T rouble Shooting Problem: Fan does not come on. Solution: • Hunter Fan Bath V entilators are extremely quiet. T o conrm that the fan is running, place your hand near the vents to feel the air movement. • T urn power on, replace fuse, or reset breaker . • Check all plug connections to be sure they are secure. • Che ...

  • Hunter Fan 81003 - page 14

    41937-01 10/26/2010 14 7130 Goodlett Farms Pkwy Suite 400, Memphis, T ennessee 38016 Printed in China © 2010 Hunter Fan Company W arranty Hunter Fan Company Bath Exhaust Fan LIMITED W ARRANTY Hunter Fan Company makes the following limited warranty to the original user or consumer purchaser of this Hunter bath exhaust fan: If any part of your Hunte ...

Fabricant Hunter Fan Catégorie Ventilation Hood

Les documents que nous recevons du fabricant de l'appareilHunter Fan 81003 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Hunter Fan
- manuels d’utilisations 81003
- fiches produit Hunter Fan
- dépliants
- ou étiquettes-énergie Hunter Fan 81003
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Hunter Fan 81003.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Hunter Fan 81003, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Hunter Fan 81003. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Hunter Fan 81003.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Hunter Fan 81003, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Hunter Fan 81003 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Hunter Fan 81003.

Le manuel d’utilisation complet Hunter Fan, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Hunter Fan 81003 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Hunter Fan 81003, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lHunter Fan 81003 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Hunter Fan 81003 - qui devraient nous aider dans les premières étapes lors de l'utilisation Hunter Fan 81003
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Hunter Fan 81003
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Hunter Fan 81003 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Hunter Fan 81003?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Hunter Fan 81003, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Hunter Fan 81003 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)