Manuel d’utilisation Kenwood KAC-8401

12 pages 0.91 mb
Télécharger

Aller à la page of 12

Summary
  • Kenwood KAC-8401 - page 1

    KA C-8401 © B64-2575-00/00 (MV) 4-CHANNEL POWER AMPLIFIER INSTR UCTION MANU AL KAC-8401(M) 1English 02.11.14 10:38 AM Page 1 ...

  • Kenwood KAC-8401 - page 2

    2 English Safety precautions To prevent injury or fire, take the following precautions: •W hen extending the ignition, battery, or ground wires, make sure to use automotive- grade wires or other wires with a 5 mm 2 (AWG 10) or more to prevent wire deterioration and damage to the wire coating. • To prevent a short circuit, never put or leave any ...

  • Kenwood KAC-8401 - page 3

    English 3 Installation • Do not install in the below locations; (Unstable location, In a location that interferes with driving, In a location that gets wet, In a dusty location, In a place that gets hot, In a place that gets direct sunlight, In a location that gets hit by hot air) • Do not install the unit under the carpet. Otherwise heat build ...

  • Kenwood KAC-8401 - page 4

    4 English Controls / Indicator 23 5 1 (W) 20 40 10 4 6 This is a 4 channel amplifier including 2 stereo amplifiers in a body. One amplifier is referred to as amplifier A and the other is amplifier B. This unit is compatible with a large variety of systems by combining the switches and functions described in the following. 1 INPUT SENSITIVITY contro ...

  • Kenwood KAC-8401 - page 5

    English 5 6 FILTER FREQUENCY control When the FILTER switch is set to the HPF (High-Pass Filter) or LPF (Low-Pass Filter) position, the threshold frequency can be adjusted with this control. 7 Power indicator When the power is turned on, the Power indicator lights. If the Power indicator does not light when the power is turned on, the protection fu ...

  • Kenwood KAC-8401 - page 6

    6 English Connection 40 89 0 ! @ ^ $ % # 8 Fuse (40 A) If you can’t find the specified capacity fuse at your store etc., consult your Kenwood dealer. 9 Battery terminal 0 Ground terminal ! Power control terminal Controls the unit ON/OFF. Controls the unit power. Be sure to connect it with all the systems. @ Speaker output terminals • Stereo Con ...

  • Kenwood KAC-8401 - page 7

    English 7 ■ Installation procedure Since there are large variety of settings and connections possible according to applications, read the instruction manual well to select the proper setting and connection. 1. Remove the ignition key and disconnect the negative - terminal of the battery to prevent short circuits. 2. Set the unit according to the ...

  • Kenwood KAC-8401 - page 8

    $ ^ # GND # CENTER UNIT (CD receiver, etc.) RCA cable ground terminal 8 English RCA cable* Connection Power control wire (Blue/ White) ■ RCA cable or Speaker level input connection Genuine-accessory car stereo (No line output center unit etc.) ACC Battery Car fuse box White White/Black Gray Gray/Black Green Green/Black Purple Purple/Black A chann ...

  • Kenwood KAC-8401 - page 9

    40 40 @ @ @ English 9 ■ Speaker wire connection Lead terminal* (Stereo Connections) A channel Left speaker A channel Right speaker B channel Right speaker B channel Left speaker (Bridged Connections) A channel Speaker (Bridged) B channel Speaker (Bridged) 40 90 ! Battery Ground wire* Battery wire* Protective Fuse* Lead terminal* ■ Power wire co ...

  • Kenwood KAC-8401 - page 10

    10 English System examples 4 5 6 23 6 23 6 23 L R L R L R A A L R B B L R A L R B L R A L R B 4 5 4 5 4 5 4 5 L R L R A B L R L R A B L R L R A B L R L R A B CENTER UNIT CENTER UNIT ■ 4-channel system ■ 3-channel system Right speaker (Bridged) Left speaker (Bridged) ■ 2-channel system Subwoofer (L + R) (Bridged) CENTER UNIT CENTER UNIT CENTER ...

  • Kenwood KAC-8401 - page 11

    English 11 L C C L C C L R L R L R L R A B 4 5 23 ■ Tri-mode CENTER UNIT (High pass) Subwoofer (L + R) (Bridged) (High pass) Subwoofer (L + R) (Bridged) ● Principle of Tri-mode Method of frequency band division using a coil and capacitor…in case of 6dB/oct. slope L C 0 dB -3 dB Coil (L): Passes low frequencies and blocks high frequencies. (Lo ...

  • Kenwood KAC-8401 - page 12

    12 English Tr oubleshooting Guide What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. PROBLEM POSSIBLE CAUSE SOLUTION No sound. (No sound from one side.) (Blown fuse.) The output level is too small (or too large) ...

Fabricant Kenwood Catégorie Car Stereo System

Les documents que nous recevons du fabricant de l'appareilKenwood KAC-8401 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Kenwood
- manuels d’utilisations KAC-8401
- fiches produit Kenwood
- dépliants
- ou étiquettes-énergie Kenwood KAC-8401
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Kenwood KAC-8401.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Kenwood KAC-8401, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Kenwood KAC-8401. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Kenwood KAC-8401.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Kenwood KAC-8401, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Kenwood KAC-8401 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Kenwood KAC-8401.

Le manuel d’utilisation complet Kenwood, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Kenwood KAC-8401 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Kenwood KAC-8401, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lKenwood KAC-8401 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Kenwood KAC-8401 - qui devraient nous aider dans les premières étapes lors de l'utilisation Kenwood KAC-8401
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Kenwood KAC-8401
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Kenwood KAC-8401 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Kenwood KAC-8401?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Kenwood KAC-8401, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Kenwood KAC-8401 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)