Manuel d’utilisation Ariens 921032

27 pages 3.85 mb
Télécharger

Aller à la page of 27

Summary
  • Ariens 921032 - page 1

    Quick St art Guide Delux e 30 (921 032 s/n 101 & up) • Step 1: Assemble Handlebars • Step 2: Connect Headlight Wire Harness • Step 3: Install Discharge Chute • Step 4: Install Discharge Chute Crank • Step 5: Install Remote Deflector Control Cable • Step 6: Install Skid Shoes • Step 7: Check Functi on of Dual Handle Interlock • S ...

  • Ariens 921032 - page 2

    Step On e: Assemble Handlebar s (Unf old Lower Handlebar) IMPORT A NT : Be sure to block wheels or secure unit so it does not move during assembly . 1. Rotate lower handlebar out from unit so low er handlebar mounting holes align w ith mounting holes on the unit f rame. 2. Secure lower handlebar to unit using two 3/8 in. x 3/4 in. hex head serrated ...

  • Ariens 921032 - page 3

    Step On e: Assemble Handlebar s (A t tach Upper Hand lebar Assembly) 1. Attach upper handlebar assembly to lower handlebar using two sets of the handleb ar hardware. One set to att ach each side of the handlebar s. NOTE: DO NOT tighten hardw are. Allow upper handlebar assembly to hang from the lower handlebar s for the nex t st ep. ...

  • Ariens 921032 - page 4

    Step On e: Assemble Handlebar s (A t tach Con tr ol Cables) 1. Hook spring end of attachme nt c ontrol cable to the clutch arm. 2. Hook spring end of the traction c ontrol cable to the cable eyelet on back of frame. NOTE: Make sure cable remains in groove of pulley . ...

  • Ariens 921032 - page 5

    Step On e: Assemble Handlebar s (Unf old Upper Handlebar) Assembly) 1. Rotate handlebar into operating position. NOTE: Be careful not to damage cable spring hooks when rotating handlebar upward. 2. Install the remaining handlebar hardware attaching the upper handlebar as sembly to the low er handlebar . 3. T ighten all hardw are. 4. Remov e packagi ...

  • Ariens 921032 - page 6

    Step T wo: Connect Headligh t Wir e Harness NOTE: The headlight w ire harness comes attached to the upper handlebar as sembly . 1. Route the wire harness along the interior of the right side handlebar . 2. Connect to the engine elec trical plug. 3. Press cable anc hor into mounting hole in the frame near the engine electrical plug. 4. Secure the w ...

  • Ariens 921032 - page 7

    Step Thr ee: Ins t all Discharg e Chut e 1. Grease underside of discharge chute ring (if not already greased). 2. Remov e mounting hardware from auger housing. 3. Install discharge c hute over opening in the auger housing. Finger tighten the mounting hardware remov ed above. NOTE: Leav e disc harg e chute pedestal loose to help ins tall the chute c ...

  • Ariens 921032 - page 8

    Step F our: Ins t all Discharg e Chut e Cr ank 1. Remov e the gear cov er from top of chute pedest al. 2. Insert the short end of the c hute crank into the hole in the front of the control panel. NOTE: Be careful not to damage ny lon bushing when attaching crank to the dash. 3. Connect the chute crank to the pinion gear on chute with hairpin. 4. Re ...

  • Ariens 921032 - page 9

    Step Fiv e: Inst all Remot e Deflect or Con trol Cable NOTE: Connect the barrel cable end to the chute deflector cable anchor before clipping the cable to the discharge chute cable bracket. 1. Route deflector remote cable along the left side of the chute pedestal. 2. Insert the barrel on the cable end into the bracket on left side of chute deflecto ...

  • Ariens 921032 - page 10

    Step Six: Ins t all Skid Shoes 1. Remove hardware from skid shoes. 2. Install hardware through blower housing and skid shoe as shown. 3. Adjust skid shoes, see Skid Shoes in Owners Manual. Spacer ...

  • Ariens 921032 - page 11

    St ep Sev en: Check Function of Dual Handle In terlock Without the en gine running , press dow n (engage ) both clu tch levers. Relea se attachment clutch lever . Attachment clu tch should remain engage d until traction clutch lever is released , then both clutches must d isenga ge. If they do not, contact your dealer for repairs. ...

  • Ariens 921032 - page 12

    St ep Eigh t: Check Tir e Pr essur e Check tire pressu re and adjust to the pressure listed on tire sidew all. ...

  • Ariens 921032 - page 13

    Check oil le vel in auger gearcase (see Check Auger Gearcase in Ow ners Manual). St ep Nine: Check Aug er Gear case Oil ...

  • Ariens 921032 - page 14

    IMPORT A NT : The engin e is shipped with 5W-30 oil in crankcase. Refer to engine manual for detailed instructions. St ep T en: Check Engine Cr ank case Oil (Ariens AX) ...

  • Ariens 921032 - page 15

    Fill fuel tank. DO N OT OVERFILL! See FILLING FUEL T ANK in Ow ners Manual. St ep T welv e: Fill Engine Fuel T ank (Ariens AX) ...

  • Ariens 921032 - page 16

    St ep Thirt een: St arting the Engine (Arie ns AX) ...

  • Ariens 921032 - page 17

    St arting Engine / Step A: Chok e T urn throttle al l the way up. T urn choke ON. ...

  • Ariens 921032 - page 18

    St arting Engine / Step B: R ock er Swit ch Push rocker switch to RUN position. ...

  • Ariens 921032 - page 19

    St arting Engine / Step C: Fuel Shut Off V alv e T urn fuel petcock to ON position. ...

  • Ariens 921032 - page 20

    St arting Engine / Step D: K ey Install Safety K ey Switch. Insert ignition key into slot but DO NOT turn the key . Be sure ignit ion key snaps into place. ...

  • Ariens 921032 - page 21

    St arting Engine / Step E: Prime Prime sy stem: 3 primes maxi mum. DO NOT over prime system. Make sure to cover the v ent hole on primer bulb before the primer bulb is compressed. Hold the primer bulb in the compressed pos ition for one full second each time you press it. Repeat for a total of 3 primes. ...

  • Ariens 921032 - page 22

    St arting Engine / Step F: (Manual St art) Grasp rope handle. Pull slowly until resistance is felt, then pull rope firmly and quickly to start engine and avoid kickback. ...

  • Ariens 921032 - page 23

    St arting Engine / Step F: (Electric St art) Use a 3-wire ex tension cord and plug cord into starter motor adaptor first. Then plug cord into wall receptacle. Use appropriately siz ed extension cord (10A WG or larger) to prevent damage to electric starter . ...

  • Ariens 921032 - page 24

    St arting Engine / Step G: (Electric St art) Press and hold starter button. Note : Do not hol d the electric starter button down for more than 5 seconds. W ait at least 1 minute before additional starting attempts. ...

  • Ariens 921032 - page 25

    St arting Engine / Step H: W arm up Allow the engine to warm up for 1- 2 minutes, move the choke control to the CHOKE OFF position. ...

  • Ariens 921032 - page 26

    St ep F ourt een: St opping the Engine (Ariens AX) Under normal condition s: 1. T urn throttle dow n. 2. Push rocke r sw itch to STOP position. 3. Pull safety key OUT . T o s top engine in a n emergency , fli p the Rocker Sw itch to the ST OP p osition, OR Pull Safety Key from Engine. ...

  • Ariens 921032 - page 27

    Additional R eso ur ces • R ef er to O wner s Manual and Engine Manual • Con t ac t Ariens Compan y www .ariens.com Phone: 920- 756 - 4688 E-mail: inf o@ariens.com 2013 The Ariens Company . All rights r eser ved. ...

Fabricant Ariens Catégorie Snow Blower

Les documents que nous recevons du fabricant de l'appareilAriens 921032 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Ariens
- manuels d’utilisations 921032
- fiches produit Ariens
- dépliants
- ou étiquettes-énergie Ariens 921032
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Ariens 921032.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Ariens 921032, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Ariens 921032. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Ariens 921032.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Ariens 921032, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Ariens 921032 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Ariens 921032.

Le manuel d’utilisation complet Ariens, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Ariens 921032 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Ariens 921032, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lAriens 921032 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Ariens 921032 - qui devraient nous aider dans les premières étapes lors de l'utilisation Ariens 921032
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Ariens 921032
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Ariens 921032 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Ariens 921032?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Ariens 921032, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Ariens 921032 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)