-
Hoover 1100 - page 1
Instructions for YOUR NEW HOOVER DIAL-A-MATIC CLEANER Model 1100 ...
-
Hoover 1100 - page 2
HANDLE GRIP OPENING FOR HANGING CLEANER IN STORAGE AREA ON/OFF SWITCH / COVER LATCH NOZZL HOSE MODEL 1100 G HANDLE ...
-
Hoover 1100 - page 3
TO ATTACH HANDLE TO CLEANER I. Remove tape and screw from handle socket and set aside for later use. 2. Connect electric plug from bottom of handle to electric plug projecting from handle socket. Make sure plug assembly is positioned as shown in illustration. 3. Push handle into place in handle socket. The excess wire and electric plugs are guided ...
-
Hoover 1100 - page 4
, THIS IS THE ttHEART” OF Y THE DIAL-A-MAT/C GIVES THE BEST AND MOST E/=F/C/E) SET THE DIAL FOR CARPET AND RUG CLEANING Your new HOOVER DIAL-A MATIC is the most powerful up- right cleaner ever built. Proper suction control for your floor coverings is most important for cleaning effectiveness and ease of operation. FIRST, set the dial between “M ...
-
Hoover 1100 - page 5
l V HOOVER DIAL-A-MATIC CLEANER SE OF A VACUUM CbEANER THAT YAS EVER BEEN DEVISED. SET THE DIAL FOR CLEANING TOOLS The handle of the cleaner should be in storage position (See page 2) when cleaning tools are used. When the handle is in this position, the nozzle is raised and the agitator does not come in contact with the rug. Attach hose and cleani ...
-
Hoover 1100 - page 6
THE CLEANING TOOLS MODEL 1101 (See Page 5 for setting Suction Control Dial when using tools.) The cleaning tools have many uses. Some are listed below: 1. TUFFLEX HOSE Double vinyl reinforced with nylon mesh for long, trouble-free life. The light flexible hose has a vinyl tab, so it can be hung on the cleaner or on a hook in a closet. 2. TELESCOPIN ...
-
Hoover 1100 - page 7
TO STORE TOOLS While moving furniture, hose can be conveniently hung on handle. The vinyl tool kit has been,designed so the tools can be packed inside and the hose attached, by strap, on outside. The kit has two slots located near the top for ease in hanging on the cover latch of the cleaner or on a hook in the closet. TO CLEAN TOOLS To clean the h ...
-
Hoover 1100 - page 8
HELPFUL HINTS EASY TO CARRY Use the comfort- able handle grip for carrying your Hoover cleaner, or move it from room to room by tipping it back on wheels and pushing it. DON’T PICK UP TACKS Hard, sharp objects should not be picked up by the cleaner. They may damage the hose and the throw-away bag. TAKE CARE OF CORD It should be wound loosely on c ...
-
Hoover 1100 - page 9
Check Nozzle Hose (cont.) throw-away bag being full of fluff from a new carpet, put a new throw-away bag on the cleaner. Then place handle in storage position, turn cleaner on, and move lever on Suction Control Dial back and forth. This will clear the hose. 2. Check Secondary Filter The secondary filter protects the motor from dirt. Before installi ...
-
Hoover 1100 - page 10
TO REPLACE THROW- AWAY BAG Tip cleaner over, resting handle on the floor. @pen bag cover of cleaner by turning latch in either direction. Lift bag cover. Hold throw-away bag by cardboard cover, twist out- ward, and remove. Discard used bag. To attach new throw-away bag, hold bag with cardboard collar down and with arrows pointing toward front of cl ...
-
Hoover 1100 - page 11
1. 2. 3. 4. 5. 6. 6 HOW TO REPLACE THE BELT Turn cleaner over. Remove metal plate on bottom of cleaner by pushing latches toward the out- side of cleaner. Lift plate to re- lease it from wire holders. Push latches, that hold agitator, in and toward center of cleaner until they are free. Lift out agitator and remove old belt. Place new belt over mot ...
-
Hoover 1100 - page 12
WHAT YOU SHOULD KNOW ABOUT THE BELT The belt of your Hoover cleaner controls the speed of the agitator and is important for the efficient operation of your cleaner. Be- cause of this, when buying a new belt, you should always insist on a genuine Hoover belt. Some other belts on the market, not manufactured under Hoover design and quality controls, ...
-
Hoover 1100 - page 13
2. After plate is removed, pry out the end section as shown in illustration. 3. After plate is removed, tap the shaft gently with a hammer. 4. Pull other plate and the shaft from agitator. 5. Remove brushes by pull- ing them from agitator. If they do not come out easily, pull them out with pliers. &Install new brushes by sliding them into the c ...
-
Hoover 1100 - page 14
SERVICING YOUR HOOVER APPLIANCE Service and genuine Hoover replacement parts may be obtained from Hoover Factory Branch Service Stations or consult the Yellow Pages of your Telephone Directory under Vacuum Cleaners-Hoover. For Service in Warranty Period follow instructions set forth in Guarantee. When ordering new parts make sure that you always me ...
-
Hoover 1100 - page 15
WORLD FAMOUS HOOVER APPLIANCES DIAL-A-MATIC PORTABLE CLEANER FLOOR WASHER LARK CLEANER SHAMPOO-POLISHER ILISHER-SCRUBBER PIXIE CLEANER DUSTETTE STEAM-DRY IRON SHAMPOO WAX WASHER-SPIN DRYER CAN OPENER COMMERCIAL HAIR DRYER VACUUM CLEANER COMMERCIAL FLOOR MACHINE 75 ...
-
Hoover 1100 - page 16
GXJARANTEE Your Hoover appliance is guaranteed against original defects in material and workmanship for a Period of one year from the date of purchase under normal use at the voltage marked thereon. Please read the in- structions carefully on the use and care of your Hoover appliance because damage caused by failure to follow instructions is not co ...
Avez-vous une question à propos de Hoover 1100?
Utiliser le formulaire ci-dessous
Si vous n’avez pas résolu votre problème avec Hoover 1100, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Hoover 1100 il est probable qu’il a envie de partager la façon de le résoudre.