Français dropdown-ico

Manuel d’utilisation United States Stove HOTBLAST 1950

20 pages 0.98 mb
Télécharger

Aller à la page of 20

Summary
  • United States Stove HOTBLAST 1950 - page 1

    INSTALLATION AND OPERATING INSTRUCTIONS FOR THE HOTBLAST 1950 EPA WOOD BURNING FURNACE Verified and tested following CSA B366.1 M91, UL 391-95, 99 by : Intertek Testing Services Distributed by: UNITED STATES STOVE COMPANY 227, INDUSTRIAL PARK ROAD P.O. BOX 151 SOUTH PITTSBURG TN 37380 Tel: (423) 837-2100 Fax : (423) 837-2109 8BDC3 Tm( )TjET? ...

  • United States Stove HOTBLAST 1950 - page 2

    Please keep this document TABLE OF CONTENTS INTRODUCTION ...................................................................................................................... 2 1. CHIMNEY AND DRAFT .................................................................................................... 2 2. SAFETY RULES ................................ ...

  • United States Stove HOTBLAST 1950 - page 3

    INTRODUCTION Take note that this furnace operates like an EPA wood bu rning stove. This applies to the lighting, the embers and the minimum combustion air intake which depends on the type and the grade of the combustible. This model line is certified as meeting the emissi ons limits in 40 C.F.R. part 60, section 60.532 (B) per EPA methods 28 and 5G ...

  • United States Stove HOTBLAST 1950 - page 4

    W A R N I N G -THE ASH DRAWER AND EXCHANGERS ACCESS PA NEL GET VERY HOT. -DO NOT MANIPULATE WITH BARE HANDS. 2.2 ODOUR FROM THE PAINT It is normal that a smoke odour emanate from the unit when y ou first light it. It is recommended to burn it at high rate and ventilate the building until the odour resorbs. 2.3 ASH DISPOSAL Ashes must be placed in a ...

  • United States Stove HOTBLAST 1950 - page 5

    2.5 SMOKE DETECTOR We highly recommend the use of a smoke det ector. It must be installed at least 15 feet (4,57 m) from the appliance in order to prev ent undue triggering of the detector wh en reloading. 2.6 DOOR GLASS To maintain a clean and safe installation, do not build your fire too close to the glass or allow the fire logs to lean on the gl ...

  • United States Stove HOTBLAST 1950 - page 6

    3. APPLIANCE INSTALLATION 3.1 UNIT LOCATION The furnace must be installed where outsi de air supply is sufficient for prop er combustion. In airtig ht houses, it might be necessary to install an outside air inlet (see details in section 3.4). The furnace must be positioned so that the connec tor is as short as possible; minimize the use of 90 o elb ...

  • United States Stove HOTBLAST 1950 - page 7

    3.3 PIPE CONNECTOR AND DAMPER Before proceeding to connection, remove all accessories such as scraper, shovel and poker from the evacuation pipe of the furnace. A 7” diameter chimney listed for use with wood burning hea ting appliances is highly recommended for the Hotblast 1950. In this case, a reduce r from 7” to 6” is required. If draft ex ...

  • United States Stove HOTBLAST 1950 - page 8

    DAMPER The barometric control must be adjusted so that t he maximum draft measured at the furnace outlet is limited to - 0.06 in. w.c. Please note t hat a draft higher than -0.06 in. w.c. could result in an uncontrolla ble fire. On the other hand, the minimum draft to be respected is -0.0 4 in. w.c. in the evacuation pipe on the solid fuel side. 3. ...

  • United States Stove HOTBLAST 1950 - page 9

    3.5 ELECTRICAL CONNECTION The following instructions do not supersede the local cod e. HOTBLAST 1950 On the Hotblast 1950 the combined limit control is installed with the support provided on the left side of the appliance (two holes are predrilled o n the edge of the furnace), and conne cted to the electrical box along with the transformer. Install ...

  • United States Stove HOTBLAST 1950 - page 10

    4. OPERATING INSTRUCTIONS Control system On the wood only furnaces , the thermostat controls the air inlet damper. When the thermostat calls for heat, the damper opens and th e fire burns up. When the furnace ge ts hot enough, the combined limit control activates the blower motor at the speed selected for woo d heating. The chain that links the air ...

  • United States Stove HOTBLAST 1950 - page 11

    4.3 HEATING 1. When loading the furnace , spread the coal and em bers evenly in the center of the combu stion chamber before adding new logs. 2. Do not overload. Air must circulate freely in the upper part of the combustio n chamber in order to obtain an efficient operation of the appliance. Pl ease note that a small hot fire will pr oduce much le ...

  • United States Stove HOTBLAST 1950 - page 12

    Whenever a high amount of smoke is noticed in the room, you mu st: 1. Open doors and windows. 2. Make sure the furna ce door is closed a s well as the dam per (if necessary, lower the thermo stat starting point or undo the chain of the damper and clo se t he barometric draft control manually). 3. When the furnace has cooled down, inspect the chimne ...

  • United States Stove HOTBLAST 1950 - page 13

    5. MAINTENANCE 5.1 MAINTENANCE OF THE EXCHANGERS The evacuation pipe and the exchangers should be insp ected regularly durin g the bur ning season. Easy access is provided (without the use of tools): unscrew the wing nut on the exchangers access door. See pictures b elow. W in g nut Insulation pad Exchan g ers cover Before cleaning the three exchan ...

  • United States Stove HOTBLAST 1950 - page 14

    5.2 CHIMNEY MAINTENANCE One of the most efficient methods is t o sweep the ch imney is using a hard brush. Brush the chimney downward so soot and creosote residues will com e off the inside su rface and fall at the bottom of the chi mney where it can be removed easily. The chimney must be checked regularly and if creosote h as accumulated, it must ...

  • United States Stove HOTBLAST 1950 - page 15

    Door adjustment procedure: 1. Unscrew com plete ly the locking pin (see picture below). Lockin g p in 2. To increase t he pressure of the door on the gasket, turn the handle counter clo ckwise; to decrease the pressure on the door on the gasket, turn the handle clo ckwise. 3. Finally, screw back the locking pin about 1/4” deep, make sure you lock ...

  • United States Stove HOTBLAST 1950 - page 16

    7. WIRING DIAGRAM HOTBLAST 1950 WOOD DIRECT DRIVE RED ON 150°F LIMIT 250°F OFF 110°F LIMIT LOAD FAN LINE HONEYWE LL L6064 HIGH LINE LOW L2 120 V.A.C. L1 BLACK TRANSFO JUNCTION BOX 24 V.A.C. 24 V.A.C. THERMOSTAT SERVO-MOTOR RED BLACK WHITE BLACK BLACK 24 V.A.C. 120 V.A.C. TRANSFORMER SWITCH MOVE THIS WIRE TO CHANGE MOTOR SPEED REVISION JUNE 17TH ...

  • United States Stove HOTBLAST 1950 - page 17

    8. HOTBLAST 1950 TECHNICAL DATA HOTBLAST 1950 A 47” B 25 ½” C 47 ¼” D 15 ⅞ ” E 28” F 24 ½” G 44” FLUE * 7” WEIGHT 560 * Reducer requi red 8.1 GENERAL TECHNICAL DATA MODEL DIRECT DRIVE OUTPUT TEMP VAR. BTU/ HR STATIC PRESSURE FILTER FAN MOTOR SPEED (CFM) ( O F) (WOOD) MIN. MAX. (2) H 2 O HOTBLAST 1950 DD-10 1/3 3 or 4 1300 78 14 ...

  • United States Stove HOTBLAST 1950 - page 18

    9. DUCTS AND DAMPERS DIMENSIONS (EXAMPLES OF CALCULATION) SIMPLIFIED METHOD DISTRIBUTION SYSTEM Ducts size (heat) 4 inch outlet reduce by 1” 5 inch outlet reduce by 2” Always by 8” thick 6 inch outlet reduce by 3” N.B.: The main duct must be reduced every 2 outlets. Ducts specifications (heat) Dimensions Length Elbow Average equivalence 4? ...

  • United States Stove HOTBLAST 1950 - page 19

    10. HOTBLAST 1950 BRICKS LAYOUT WARNING: INSTALL THE CERA MIC BLANKET PANEL BEFORE PUTTING BRICKS UP IN THE COMBUSTION CHAMBER 9" 4 1/2 " 3 1/ 2" 5 1/2" 9 4" 1 5/8 " 9" 6" 3" 8 9" 4 1/ 4" 7 1/2 " 1 1/2 " 1 1/ 4" 3" 1 8 6 3 1 5 9 7 9 9 9 8 6 7 7 7 7 7 7 7 7 7 6 6 6 6 2 2 7 7 ...

  • United States Stove HOTBLAST 1950 - page 20

    19 11. TROUBLE SHOOTING PROBLEM CAUSES SOLUTIONS Heating inefficient during the first combustions. Lack of draft. Improper adjustment of the barometric damper (ope ned too wide). Chimney flue restriction (too long., or too many 90 o elbows) Adjust the damper, minimize the chimney length and use 45 o elbows. Furnace heats well, warm air plen um is v ...

Fabricant United States Stove Catégorie Furnace

Les documents que nous recevons du fabricant de l'appareilUnited States Stove HOTBLAST 1950 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques United States Stove
- manuels d’utilisations HOTBLAST 1950
- fiches produit United States Stove
- dépliants
- ou étiquettes-énergie United States Stove HOTBLAST 1950
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation United States Stove HOTBLAST 1950.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation United States Stove HOTBLAST 1950, manuels d’entretien, brefs manuels ou manuels de l’utilisateur United States Stove HOTBLAST 1950. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit United States Stove HOTBLAST 1950.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil United States Stove HOTBLAST 1950, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser United States Stove HOTBLAST 1950 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs United States Stove HOTBLAST 1950.

Le manuel d’utilisation complet United States Stove, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel United States Stove HOTBLAST 1950 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières United States Stove HOTBLAST 1950, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lUnited States Stove HOTBLAST 1950 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil United States Stove HOTBLAST 1950 - qui devraient nous aider dans les premières étapes lors de l'utilisation United States Stove HOTBLAST 1950
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de United States Stove HOTBLAST 1950
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service United States Stove HOTBLAST 1950 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de United States Stove HOTBLAST 1950?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec United States Stove HOTBLAST 1950, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec United States Stove HOTBLAST 1950 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Captcha
Nouvelle image

Commentaires (0)