Manuel d’utilisation Brinkmann SL-7

12 pages Non applicable
Télécharger

Aller à la page of 12

Summary
  • Brinkmann SL-7 - page 1

    MODEL SL-7 OWNER’S MANUAL ASSEMBL Y AND OPERA TING INSTRUCTIONS INSTR_821-7000-0_SL7.qxd 5/17/06 4:29 PM Page 1 ...

  • Brinkmann SL-7 - page 2

    HOW YOUR HOME SECURITY MOTION ACTIV A TED LIGHTING SYSTEM WORKS The Home Security Motion Activated Lighting System is designed to turn on automatically at night when a person enters the detection zone. The light will stay on as long as the motion detector senses motion in the zone. The light will turn off in approximately 90 seconds after the perso ...

  • Brinkmann SL-7 - page 3

    P ARTS LIST : Home Security Main Housing Main Housing Mounting Screws (2) Solar Panel Module with Cord Solar Panel Module Mounting Screws (3) SL-7 Owner’ s Manual 2 ASSEMBL Y INSTRUCTIONS Inspect contents of the box to ensure all parts are included and undamaged. A Phillips screwdriver will be required. 1 2 3 4 5 Step 1 Select a location and atta ...

  • Brinkmann SL-7 - page 4

    3 Step 3 Slide the two slots in the back of main housing onto the screws. Step 4 Select a location within 15 feet from the main housing to mount the solar panel module. The solar panel module must be mounted where it will receive FULL, DIRECT SUNLIGHT for several hours each day . Step 5 Firmly plug the solar panel module cord into the main housing. ...

  • Brinkmann SL-7 - page 5

    4 Step 8 Point the two floodlights in the desired direction. Y ou may want to adjust the floodlights after letting the unit operate for a few nights. Step 9 Position the detector head in the direction you want to cover . Never aim the motion detector head directly at the sun or above a 90° angle (horizontal level). Do not rotate the head more than ...

  • Brinkmann SL-7 - page 6

    5 Step 1 After installing your light, leave the switch in the “OFF” position and charge in FULL, DIRECT SUNLIGHT for THREE FULL SUNNY DAYS. Step 2 After allowing the battery to fully charge, the motion detector can be adjusted and tested. Point the motion detector head down 15° from horizontal level. Step 3 Move the slide switch to “TEST” ...

  • Brinkmann SL-7 - page 7

    6 T erminal Wire Connector Changing Batteries 1. Unscrew the four screws in front housing and separate it from rear housing. 2. Carefully peel the tape off the battery , leaving wires attached to tape. 3. Remove the battery from rear housing, being careful not to pull on wires. 4. Disconnect wires from battery terminals and remove battery . 5. Conn ...

  • Brinkmann SL-7 - page 8

    7 1. Clean snow and debris off the solar panel so the batter y can recharge. 2. Check and replace batter y periodically throughout the year , especially after winter months. Wintertime Tips Solar security lights can be left outside year round, even in cold weather . However , if you wish to store your light indoors for more than two or three days, ...

  • Brinkmann SL-7 - page 9

    8 Note: After installing the main housing and solar panel module, leave the switch in the “OFF” position and charge in FULL, DIRECT SUNLIGHT for THREE FULL DA YS. Then remove the switch label and slide the switch to the “AUTO” position. The light will turn on automatically at night when it detects motion. T roubleshooting & Important In ...

  • Brinkmann SL-7 - page 10

    cut along dotted line TEMPLA TE Screw Hole Screw Hole 9 INSTR_821-7000-0_SL7.qxd 5/17/06 4:29 PM Page 10 ...

  • Brinkmann SL-7 - page 11

    10 HOME SECURITY ACCESSORIES For Visa/MasterCard orders, please call 800-468-5252, Monday through Friday , 8:30 AM - 5:00 PM Central Standard Time. 100-0057-0 Replacement Bulb 070-6001-0 SL-7 Replacement Battery 112-0010-0 15 ft. Extension Cord INSTR_821-7000-0_SL7.qxd 5/17/06 4:29 PM Page 11 ...

  • Brinkmann SL-7 - page 12

    For one year from date of purchase, The Brinkmann Corporation warrants the Home Security Motion Activated Lighting System against defects due to workmanship or materials to the original purchaser . The Brinkmann Corporation’ s obligations under this warranty are limited to the following guidelines: • This warranty does not extend to the bulb or ...

Fabricant Brinkmann Catégorie Motion detector

Les documents que nous recevons du fabricant de l'appareilBrinkmann SL-7 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Brinkmann
- manuels d’utilisations SL-7
- fiches produit Brinkmann
- dépliants
- ou étiquettes-énergie Brinkmann SL-7
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Brinkmann SL-7.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Brinkmann SL-7, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Brinkmann SL-7. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Brinkmann SL-7.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Brinkmann SL-7, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Brinkmann SL-7 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Brinkmann SL-7.

Le manuel d’utilisation complet Brinkmann, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Brinkmann SL-7 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Brinkmann SL-7, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lBrinkmann SL-7 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Brinkmann SL-7 - qui devraient nous aider dans les premières étapes lors de l'utilisation Brinkmann SL-7
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Brinkmann SL-7
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Brinkmann SL-7 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Brinkmann SL-7?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Brinkmann SL-7, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Brinkmann SL-7 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)