-
Niles Audio BG525 - page 1
MODEL BG 52 5 B LENDING H IGH F IDELITY AND A RCHITECTURE ® INST ALLA TION & OPERA TION GUIDE MODEL BG 52 5 B A CK GROUND ® ® ...
-
Niles Audio BG525 - page 2
Congr atulations! Thank you for choosing a Blueprint Series ® In-Wall Loudspeaker from Niles. With proper installation and operation, you'll enjoy years of trouble-free use. Niles manufactures the industry's most complete line of custom installation components and accessories for audio/video systems. For a free full-line catalog write: N ...
-
Niles Audio BG525 - page 3
2 Fea tur es and Benefits Intr oduction The BG Background group of Blueprint Series ® Loudspeakers offers a product expressly designed for quality back- ground music reproduction. This speaker is perfect for hallways, laundry rooms, entryways or other areas where critical listening is unlikely and cost is a major influence in the purchase decision ...
-
Niles Audio BG525 - page 4
sandwiching the drywall between them. The speaker baffle attaches to the frame, and the grille mounts over the speaker. Three Stage Installation System for Remodels or New Construction Y ou install only the parts you need for a particular stage of construction. When the framing and wiring are finished, you install the bracket . After the drywall is ...
-
Niles Audio BG525 - page 5
Recommended A mplifier Power For satisfactory performance, we recom- mend an amplifier with a power rating of five to fifty watts for the BG-525. Curiously, most speakers are not damaged by large amplifiers but by small amplifiers. If your system is playing loudly, a small amplifier will run out of power very quick- ly. When an amplifier runs out o ...
-
Niles Audio BG525 - page 6
light switches and dimmers). V olume con- trols are connected in line with the speak- er, so you must connect the wire from the amplifier to the volume control and then from the volume control to the speaker. Speaker Wire Use 2-conductor speaker wire when con- necting BG speakers to your receiver or amplifier . For most applications, we rec- ommend ...
-
Niles Audio BG525 - page 7
6 Speak er Placement The Boundary Effect Corners can affect the bass response of the speaker powerfully! This is called the boundary effect. Y ou will emphasize par- ticular bass frequencies and cancel out other bass frequencies when you place speakers close to the wall/ceiling bound- ary or a corner wall boundary . This can make the speaker sound ...
-
Niles Audio BG525 - page 8
This huge array of speakers assures that you will feel completely surrounded by the ambient soundtrack of the movie. Film makers try to use the “surround” soundtrack to envelope you in the envi- ronment on screen. They will place back- ground music, rain sounds, traffic noise, etc. on the “surround” soundtrack. In a home with a single pair ...
-
Niles Audio BG525 - page 9
Inst allation Fundamen tals Running the Speaker Wire in New Construction If you have doubts about whether you are capable of installing a Niles Blueprint Series speaker in your walls, consult a Niles dealer or professional installer. They have special tools, techniques, and experi- ence to make the impossible possible. The installer can provide you ...
-
Niles Audio BG525 - page 10
Try to line the holes up perfectly, because it makes pulling the wire much easier. A good technique is to snap a chalk line across the face of the studs or against the bottom of the ceiling joists. Then work backward so that you can always see the holes you have already drilled. Paying careful attention to this will save you a lot of time later on! ...
-
Niles Audio BG525 - page 11
Identify where all of your electrical, phone, and TV wiring is likely to be and plan to route around it all. You can acci- dentally induce 60 Hz hum on your speakers if you run your speaker wire right beside electrical wire for more than a few feet. T ry to keep speaker wire running par- allel to power cables at least 3 feet away. T o find exactly ...
-
Niles Audio BG525 - page 12
conduit, vents or drain pipe will be visible that give useful information. Choose the route with the fewest potential obstacles. If your house is built on a slab or you are wiring between two finished floors, look for baseboards which could be removed and replaced with the wire behind them . Doorjambs can be removed and often have enough space for ...
-
Niles Audio BG525 - page 13
12 Figure 6 Installation F undamentals In traditional wood stud / drywall construc- tion you can cut the hole for the speaker and utilize the large hole to auger holes across, up or down the wall for as far as your drill bit will take you. If you have matching paint and take reasonable care in patching you can cut a hatch in the dry- wall at each s ...
-
Niles Audio BG525 - page 14
Installation of Br ackets, F r ames and Grilles in Ne w Construction Stage One: Before Drywall is Hung Insulating the Wall Cavity. If feasible, fill the wall cavity with insula- tion at this point . Attach the wings to the bracket by snap- ping them into the sides of the bracket. The wings can be shortened by breaking them along the scored lines if ...
-
Niles Audio BG525 - page 15
ed of aluminum with a perfectly even powder coat overall. This powder coat is an ideal primer. Remove the grilles before painting. If you are using spray paint, use two thin coats without any primer . If you are using a compressor and a spray gun, use the finest, most diffuse setting. Practice first on some paper if you have no experience painting ...
-
Niles Audio BG525 - page 16
Inst allation of Br acket s, Fr ames and Grilles in Existing W alls IMPORTANT: Before you cut into any wall, review the sections on running wire and speaker placement. 1 . Drill a 1 /8” pilot hole just barely through the wallboard or drywall (1/2” to 5/8” deep in most homes) about an inch below the center of your proposed speak- er location ( ...
-
Niles Audio BG525 - page 17
the drywall section can be replaced clean- ly if there is an unseen obstruction behind the wall. BE VERY CAREFUL NOT TO SAW THROUGH EXISTING WIRES, PIPES, OR STRUCTURE. IF YOU FEEL ANY EXTRA RESISTANCE AS YOU ARE CUT- TING, STOP . 4. If you are cutting into lath and plaster walls, use masking tape to outline your penciled marks, drill the four corn ...
-
Niles Audio BG525 - page 18
Installing the Speaker If the grille is already installed, remove it by using a bent paper clip or the tip of a corkscrew and pulling it away from the frame (See Figure 13) . 1 . Separate the speaker wire so that at least two inches of each conductor are free. 2. Strip one half inch of insulation from the end of each conductor of the speaker wire. ...
-
Niles Audio BG525 - page 19
Oper ation Listening at Higher Volumes It requires more power to achieve a rea- sonable volume of sound in a large room than it does in a small room. It is possi- ble (even if you are not a teenager) to turn the volume so high that the amplifi- er runs out of power . This creates “clip- ping” distortion. Clipping distortion makes treble sound v ...
-
Niles Audio BG525 - page 20
19 L imit ed W arr anty Niles Audio Corporation ("NILES") warrants its loudspeaker products to the original purchaser to be free of manufacturing defects in material and workmanship for a period of five years from date of purchase. This Warranty is subject to the following additional conditions and limitations. The Warranty is void and in ...
-
Niles Audio BG525 - page 21
CUT ALONG DOTTED LINE Model Purchased __________________ ____________ _____ ________________ _______ _______ ___________________ Serial Number _____________ ____________________ _________________________ _______ ___________________ Date Purchased (month/day/year) _______ _____________________ _____ _____________ ______ ________ ______ Dealer Name a ...
-
Niles Audio BG525 - page 22
CUT ALONG DOTTED LINE AND RETURN TO: Niles Audio Corporation. Warranty Registration Dept. P.O. Box 160818 Miami, Florida 33 1 16- 0818 PLEASE FILL OUT THE W ARRANTY REGISTRA TION CARD ON THE REVERSE SIDE, DET ACH, AND MAIL T O: Niles Audio Corporation W arranty Registration Dept. P .O. Box 1 608 1 8 Miami, Florida 33 1 1 6-08 1 8 ® ...
-
Niles Audio BG525 - page 23
www.nilesaudio.com Niles Audio Corporation 1 233 1 S. W . 1 30 Street Miami, Florida 33 1 86 T el: (305) 238-43 73 Fax: (305) 238-0 1 85 Printed in Taiwan © 1 999 Niles Audio Corporation. Because Niles strives to continuously improve its products, Niles reserves the right to change product specifications without notice. Niles, the Niles logo, Blen ...
Avez-vous une question à propos de Niles Audio BG525?
Utiliser le formulaire ci-dessous
Si vous n’avez pas résolu votre problème avec Niles Audio BG525, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Niles Audio BG525 il est probable qu’il a envie de partager la façon de le résoudre.