Français dropdown-ico

Manuel d’utilisation Hubbell Electric Heater Company A

27 pages 4.22 mb
Télécharger

Aller à la page of 27

Summary
  • Hubbell Electric Heater Company A - page 1

    OPERATING AND MAINTENANCE MANUAL FOR ELECTRIC BOOSTER HEATER ELECTRIC HEATER COMPANY BASE MODEL “ A ” ...

  • Hubbell Electric Heater Company A - page 2

    2 HUBBELL ELECTRIC HEATER COMPANY P.O. BOX 288 STRATFORD, CT 06615 PHONE: (203) 378-2659 FAX: (203) 378-3593 INTERNET: http://www.hubbellheaters.com/ -- IMPORTANT -- Always reference the f ull model num ber and serial number when calling the factory. WARNING / CAUTION 1. Tank is to be complete ly fille d with water and a ll air is to be vente d bef ...

  • Hubbell Electric Heater Company A - page 3

    3 TABLE OF CONTENTS SECTION TITLE PAG E # I GENERAL DESCRI P TI ON AND CONSTRUCTION 5 II INSTAL LATI ON 9 III S C H E D U LE D M A IN TE NANC E AND OPERATION 16 I V TROUBL ES HOOTI NG 18 V S E R V I C I N G & R E P L A C E M E N T O F P A R T S 2 0 VI MI SCELL ANEOUS C HARTS AND FORMULAS 25 ...

  • Hubbell Electric Heater Company A - page 4

    4 ...

  • Hubbell Electric Heater Company A - page 5

    5 SECTION I - GENERAL DESCRIPTION AND CONST RUCTION GENERAL DESCRIPTION This book describes a packaged electric booster heater that is ty pically used to provide 180 ° F sanitizing rinse water. The complete assembly consists of the storage tank, immersion electric heating element(s), thermostat, safety relief valve, safety high temperature cut out ...

  • Hubbell Electric Heater Company A - page 6

    6 CONTROL THERMOS TAT The water heater is supplied with an immer sion thermostatic switch that is i nstalled and wired at t he factory. The thermostat can be adjusted through a range of 100° - 195° F and is adjustable with a flat tip screwdriver. TEMPERATURE HIGH LIMIT SWIT CH A surface mounted high temperature cut-off switch with manual reset, f ...

  • Hubbell Electric Heater Company A - page 7

    7 FUSED LOW VOLTAGE TRANS FORMER A fused low voltag e transformer is supplied with all models rated for 480-volts. This component is used to step down the 480-volt power supply to 240-volts for safety when working with control circ uits. ON/OFF SWITCH An illuminated on/off switch is pr ovided for positive verification hea t er status. OPTIONS The f ...

  • Hubbell Electric Heater Company A - page 8

    8 Pressure Reducing Valv e An optional pressure reducing valve with built-in by pass may be supplied. This valve is shipped separately for in-line installation. Stainless Ste el Outer Jacket An optional stainl ess steel outer jacket m ay replace t he standard galvaneel jacket. Stainless Ste el Legs As an option, 6-inch adjustable stainless steel le ...

  • Hubbell Electric Heater Company A - page 9

    9 SECTION II – INSTALLATION WARNING / CAUTION DO NOT TURN ON THE ELECTRI C POWER SUPPL Y to this equipment until heate r is completely filled with water and all air has been re leased. If the heater is NOT fille d with water when the power is turned on, the heating elements will burn out. For protection against excessive pressures and temperature ...

  • Hubbell Electric Heater Company A - page 10

    10 of water. To over come this condition, it is recommended that a 3/8” by -pass arrangement with a horizontal check valve be installed around the pressure regulator. This will prevent annoy ance caused by the relief valve dripping or blowing off. 3. I nstall in-line pressure and temperature gaug e, if supplied. 4. I nstall the combination temper ...

  • Hubbell Electric Heater Company A - page 11

    11 FINAL CHECKS 1. Check all connections for tightness. 2. Ensure that all the above steps are completed 3. After the wa ter is heated f or the first time, monitor the water te mperature as described in S e ct i o n III, Q u a rt e r l y In s p e c t i on. Outgoing Water (180°F ) ! ! ! ! Important ! ! ! ! Do not install any valves other than those ...

  • Hubbell Electric Heater Company A - page 12

    12 ...

  • Hubbell Electric Heater Company A - page 13

    13 ...

  • Hubbell Electric Heater Company A - page 14

    14 1 – Terminal Block 2 – Magnetic Contactor 3 – Heating Element 4 – Low Water Cut-Off, if supplied 5 – Transformer, 480-Volt/240-Volt, installed on 480-Volt models only . 6 – High-Te mperature L imit Switch 7 – Control Thermostat 8 – I lluminated On/Off Switch ...

  • Hubbell Electric Heater Company A - page 15

    15 ...

  • Hubbell Electric Heater Company A - page 16

    16 SECTION III - SCHEDULED MAINTE NANCE AND OPERATION WARNING / CAUTION Before performing any maintenance procedure, make certain power supply is OFF and cannot accidentally be turned on. MAINTENANCE AND OPERATION The water heater is automatic in its operation. I t will maintain a full tank of water at the temperature setting of the thermostat. The ...

  • Hubbell Electric Heater Company A - page 17

    17 ANNUAL INSPECTION 1. Flush tank as follows a. Shut off power supply . b. Close valve on hot water outlet piping. c. Open valve on drain piping. d. Cold water inlet line pressure will be strong enough to flush sediment from the bottom of the tank out through the drain. L et water run for 3-4 minutes. e. Close drain valve. f. Open hot water valve. ...

  • Hubbell Electric Heater Company A - page 18

    18 SECTION IV – TROUBLESHOOTING Symptom Probable Cause Corrective Action / Remedy Circuit breaker tripped at source. Reset circuit breaker. On/Off switch in ‘OFF’ position Turn switch to ‘ON’ position Blown fuse in transformer, if installed. Replace fuse. High limit switch tr ipped. Reset hig h limit switch. Loose wires. Tighten wires. To ...

  • Hubbell Electric Heater Company A - page 19

    19 Faulty thermostat. Che ck thermostat a djustment. Monitor thermostat as described i n S e c t i o n III, Q u a rt er l y I nspection. Replace if necessary . Heating e lement not working on all phases Check to see that heating element is working on all phases, by checking the resistance (ohms) value for each element and c omparing with the chart ...

  • Hubbell Electric Heater Company A - page 20

    20 SECTION V - SERVICING & REPLACEMENT OF PARTS WARNING / CAUTION Before servicing or replacing any part make sure to turn the power supply switch to the OF F position. SURFACE TEMPERATURE HIGH LIMIT CUT -OFF 1. Disconnect power from unit. 2. Remove access cover. 3. Disconnect the four (4) 14 gauge wires. 4. Remove the two (2) mounting screws. ...

  • Hubbell Electric Heater Company A - page 21

    21 HEATING ELEM ENT 1. Disconnect power from unit. 2. Shut off incoming water supply . 3. Attach hose to drain connection. 4. Lift manual release lever on relief valve to let air into sy stem or break union on outgoing water line. 5. Drain water from tank. 6. Disconnect the wires from the heating element terminals. Not e that picture shown i s a th ...

  • Hubbell Electric Heater Company A - page 22

    22 IMMERSION THE RMOSTAT 1. Disconnect power from unit. 2. Remove access cover and locate t hermostat. 3. Remove high limit c over screw and cover. Cover Cover Screw 4. Disconnect the two (2) 14 gauge wires. Wires Capillary Tube 5. Remove capilla ry tube a nd bulb from thermowell. 6. Remove two (2) mounting screws. Mounting Screws 7. Replace thermo ...

  • Hubbell Electric Heater Company A - page 23

    23 MAGNETIC CONTACTOR 1. Disconnect power from unit. 2. Disconnect line and load wires to contactor. 3. Disconnect two (2) 14 gaug e control circuit wires. Control Wires Line Wires Load Wires 4. Loosen two (2) holding screws and remove contactor. Mounting Screws (Bottom screw not shown) 5. Replace with new cont actor using reverse procedure. ...

  • Hubbell Electric Heater Company A - page 24

    24 RELIEF VALVE 1. Disconnect power from unit. 2. Shut off incoming water supply . 3. Lift test lever on relief valve to relieve pressure in tank. 4. Disconnect overflow piping. 5. Unscrew relief valve, remove assemb ly and repl ace with new one. 6. Connect overflow piping. 7. Turn on incoming water supply and check for leaks. 8. Turn safety switch ...

  • Hubbell Electric Heater Company A - page 25

    25 SECTION VI – MISCELL ANEOUS CHARTS AND FORMULAS ELEMENT CHA RT Power (Wat ts) Element Part # 120V 208V 240V 480V I mmersion L ength Element Resistance (Ohms) CH-FO-358 ---- 3500 ---- ---- 11 3/8" 12.36 CH-FO-408 ---- 4000 ---- ---- 11 3/8" 10.82 CH-FO-508 ---- 5000 ---- ---- 13 1/4" 8.65 CH-FO-608 2000 6000 ---- ---- 13 3/8" ...

  • Hubbell Electric Heater Company A - page 26

    26 FORMULAS ...

  • Hubbell Electric Heater Company A - page 27

    27 TORQUE VALUE S BOLT SIZE 18-8 S/S IN. - LB S . BRASS IN. - LB S . SI LI CON BRONZE IN. - LB S . ALUMI NUM 2024-T4 IN. - LB S . 316 S/S IN. - LB S . MONEL IN. - LB S . 4-40 5.2 4.3 4.8 2.9 5.5 5.3 4-48 6.6 5.4 6.1 3.6 6.9 6.7 5-40 7.7 6.3 7.1 4.2 8.1 7.8 5-44 9.4 7.7 8.7 5.1 9.8 9.6 6-32 9.6 7.9 8.9 5.3 10.1 9.8 6-40 12.1 9.9 11.2 6.6 12.7 12.3 8 ...

Fabricant Hubbell Electric Heater Company Catégorie Electric Heater

Les documents que nous recevons du fabricant de l'appareilHubbell Electric Heater Company A peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Hubbell Electric Heater Company
- manuels d’utilisations A
- fiches produit Hubbell Electric Heater Company
- dépliants
- ou étiquettes-énergie Hubbell Electric Heater Company A
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Hubbell Electric Heater Company A.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Hubbell Electric Heater Company A, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Hubbell Electric Heater Company A. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Hubbell Electric Heater Company A.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Hubbell Electric Heater Company A, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Hubbell Electric Heater Company A par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Hubbell Electric Heater Company A.

Le manuel d’utilisation complet Hubbell Electric Heater Company, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Hubbell Electric Heater Company A - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Hubbell Electric Heater Company A, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lHubbell Electric Heater Company A qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Hubbell Electric Heater Company A - qui devraient nous aider dans les premières étapes lors de l'utilisation Hubbell Electric Heater Company A
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Hubbell Electric Heater Company A
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Hubbell Electric Heater Company A dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Hubbell Electric Heater Company A?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Hubbell Electric Heater Company A, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Hubbell Electric Heater Company A il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Captcha
Nouvelle image

Commentaires (0)