Manuel d’utilisation Interfire Audio A300.2

17 pages 3.67 mb
Télécharger

Aller à la page of 17

Summary
  • Interfire Audio A300.2 - page 1

    2 CHANNEL / 4 CHANNEL / 5 CHANNEL AUTOMOTIVE AMPLIFIER INSTRUCTION MANUAL A300.2 / A500.2 / A700.2 A1000.2 / A1100.2 / A2200.2 A500.4 / A700.4 / A900.4 / A800.5 ...

  • Interfire Audio A300.2 - page 2

    1 free installation. • Four Class ''AB'' High-Current Dual Discrete Drive Stages. • Class ''AB'' T echnology MOSFET PWM Power Supply . • Bridgeable & TRI-Mode Operation. • Continuously V ariable 12dB/Octave High Pass & 12dB /Octave Low Pass Crossover. • Subwoofer V ariable Crossover for Deep ...

  • Interfire Audio A300.2 - page 3

    • NEVER operate the amplifier without the proper power and ground wire, 10 gauge minimum. • NEVER operate the amplifier without proper fusing. Fuse holder must be located with in 0.5 meters from the battery . This fuse is to protect the car not the electronics. In case of a short, the fuse will blow instead of the wire burning up. Using other t ...

  • Interfire Audio A300.2 - page 4

    1. After reading precaution, decide where you are going to install the unit. Also, see Fig.1. 2. Once the location has been determined, place the amplifier into position. Using a felt tip pen or pencil mark the four holes to be drilled for mounting. NEVER use the amplifier as a template for drilling. It is very easy to damage the amplifier surface ...

  • Interfire Audio A300.2 - page 5

    It is important to have good quality power and ground connections. Remember , to complete an electrical circuit, the ground connection is just as important as the positive power connection. Before any power connections are made, disconnect the ground cable at the When the power supply lead, memory backup lead or ground lead are extended use a 5mm² ...

  • Interfire Audio A300.2 - page 6

    5 FIG.2 +12V REM GND AUTO - ANTENNA LEAD CH1 CH2 CAR STEREO HEAD UNIT LINE INPUT GAIN BASS L.P.F L.P.F H.P.F H.P.F 6V 0.2V 0dB 12dB 50Hz 250Hz FLAT 80Hz 1.2KHz CROSSOVER CH1 CH2 ...

  • Interfire Audio A300.2 - page 7

    6 CH3 CH4 CH2 CH1 +12V REM GND AUTO - ANTENNA LEAD CAR STEREO HEAD UNIT FIG.2 LINE INPUT LINE INPUT GAIN GAIN BASS BASS CROSSOVER CROSSOVER 6V 0.2V 0dB 12dB 50Hz 500Hz FLAT L.P.F H.P.F FLAT L.P.F H.P.F CH1 CH2 CH3 CH4 50Hz 500Hz 0dB 12dB 6V 0.2V CH 1/2 CH 3/4 ...

  • Interfire Audio A300.2 - page 8

    7 CH3 CH4 CH2 CH1 CH5 CH6 +12V REM GND AUTO - ANTENNA LEAD CAR STEREO HEAD UNIT FIG.2 6V 0.2V FLAT L.P.F 250Hz 50Hz 1.2kHz 80Hz 1.2kHz 80Hz 250Hz 50Hz H.P.F GAIN CH 1/2 LINE INPUT GAIN L.P.F L.P.F H.P.F H.P.F FLAT LINE INPUT CH1 CH2 CH3 CH4 CROSSOVER CROSSOVER 6V 0.2V FLAT 250Hz 50Hz 1.2kHz 80Hz 6V 0.2V CH5 CH6 CH 5 CH 3/4 ...

  • Interfire Audio A300.2 - page 9

    POWER B+ GND REM FUSE SPEAKER CH1 (+) (+) ON PROTECT BRIDGED CH2 POWER B+ GND REM FUSE SPEAKER CH1 (+) (+) ON PROTECT BRIDGED CH2 POWER B+ GND REM FUSE SPEAKER CH1 (+) (+) ON PROTECT BRIDGED CH2 This amplifier can operate in one, two or three channel mode. The minimum impedance for single channel (bridged/mono) operation is 4 or 8 ohms. Tri channel ...

  • Interfire Audio A300.2 - page 10

    CH2 POWER B+ GND REM FUSE SPEAKER (+) (+) (+) (+) CH4 CH3 ON PROTECT CH1 BRIDGED BRIDGED 2 S PEAKER BRIDGED 2 S PEAKER + 1 SUBWOOFER 4 S PEAKER STEREO 6 S PEAKER HEX MODE 9 2-4 Ohms 4 CH 5 CH 4-8 Ohms 6 CH 4-8 Ohms FIG.3 CH2 POWER B+ GND REM FUSE SPEAKER (+) (+) (+) (+) CH4 CH3 ON PROTECT CH1 BRIDGED BRIDGED 3 CH SUB WOOFER 4-8 Ohms 2 CH 1CH 2-4 Oh ...

  • Interfire Audio A300.2 - page 11

    4-8 Ohms 1 CH 2 CH BRIDGED BRIDGED POWER B+ GND REM FUSE SPEAKER (+) CH4 (+) CH5 (+) CH3 ON PROTECT (+) CH1 (+) CH2 BRIDGED BRIDGED POWER B+ GND REM FUSE SPEAKER (+) CH4 (+) CH5 (+) CH3 ON PROTECT (+) CH1 (+) CH2 BRIDGED BRIDGED POWER B+ GND REM FUSE SPEAKER (+) CH4 (+) CH5 (+) CH3 ON PROTECT (+) CH1 (+) CH2 2-8 Ohms 3 C H 3 S PEAKER BRIDGED 10 5 S ...

  • Interfire Audio A300.2 - page 12

    11 1.Set to the "H.P .F" position when the amplifier is used to drive a tweeter/midrange system. The frequencies below the crossover point will be attenuated at 12dB/octave. Permits adjustment of the crossover frequency ,by rotating the knob to select any frequency 2.Set to the "L.P .F" position when the amplifier is used to dri ...

  • Interfire Audio A300.2 - page 13

    12 ...

  • Interfire Audio A300.2 - page 14

    13 ...

  • Interfire Audio A300.2 - page 15

    14 This section provides you with a catalog of amplifier symptoms and their probable causes and solutions. Before you consult this listing, make sure the vehicle's electrical system is working properly by verifying that other electrical items (e. g. headlights, windows, etc.) Still function correctly . No Audio Low or N.C Remote Tu rn-on conne ...

  • Interfire Audio A300.2 - page 16

    AMPLIFIER 4 OHMS @ 0.05% THD 4 OHMS Bridged 0.5% THD LOW P ASS FILTE R HIGH PA SS FILT ER MAXIMUM OUTPUT POWER FUSE RAT ING FREQUENCY RESPONSE (-1dB) SIGNAL TO NOISE RAT IO (`A' WTD) INPUT SENSITIVITY INPUT IMPEDANCE OPERATIO N VOLTA GE (NEGAT IVE GROUND) SPEAKER IMPEDANCE @ STEREO DRIVEN DIMENSIONS (W mm x H mm x D mm ) A300.2 75W x 2 150W x ...

  • Interfire Audio A300.2 - page 17

    AMPLIFIER 4 OHMS @ 0.05% THD 4 OHMS Bridged 0.5% THD LOW P ASS FILTE R HIGH PA SS FILT ER MAXIMUM OUTPUT POWER FUSE RAT ING FREQUENCY RESPONSE (-1dB) SIGNAL TO NOISE RAT IO (`A' WTD) INPUT SENSITIVITY INPUT IMPEDANCE OPERATIO N VOLTA GE (NEGATIV E GROUND) SPEAKER IMPEDANCE @ STEREO DRIVEN DIMENSIONS (W mm x H mm x D mm ) 250x59x280 250x59x320 ...

Fabricant Interfire Audio Catégorie Stereo Amplifier

Les documents que nous recevons du fabricant de l'appareilInterfire Audio A300.2 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Interfire Audio
- manuels d’utilisations A300.2
- fiches produit Interfire Audio
- dépliants
- ou étiquettes-énergie Interfire Audio A300.2
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Interfire Audio A300.2.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Interfire Audio A300.2, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Interfire Audio A300.2. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Interfire Audio A300.2.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Interfire Audio A300.2, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Interfire Audio A300.2 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Interfire Audio A300.2.

Le manuel d’utilisation complet Interfire Audio, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Interfire Audio A300.2 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Interfire Audio A300.2, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lInterfire Audio A300.2 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Interfire Audio A300.2 - qui devraient nous aider dans les premières étapes lors de l'utilisation Interfire Audio A300.2
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Interfire Audio A300.2
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Interfire Audio A300.2 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Interfire Audio A300.2?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Interfire Audio A300.2, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Interfire Audio A300.2 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)