-
Planet Technology PL-201-UK/US - page 1
85M Powerline Ethernet Bridge PL-201-UK/US User Manual ...
-
Planet Technology PL-201-UK/US - page 2
Copyright Copyright (C) 2005 PLANET Technolo gy Corp. All righ ts re served. The products and programs described in this Us er’s Manual are license d products of PLANET Technology, This User’s Manual contains propriet ary information prote cted by copyright, and this User’s Manual and all accompanying h ardware, so ftware, and docume ntation ...
-
Planet Technology PL-201-UK/US - page 3
Trademarks The PLANET logo is a trademark of PLANET Te chnology. This docume ntation may refer to numerous hardware and software products by their tr ade n ames. In most, if not all cases, these designations are claime d as trademarks or registered trademarks by their respective compani es. Revision User’s Manual for PLANET 85M Powe rline Ethern ...
-
Planet Technology PL-201-UK/US - page 4
Table of Content Chapter 1 Introduction ....................................................................................... 5 Overview ......................................................................................................... 5 Feature ............................................................................................... ...
-
Planet Technology PL-201-UK/US - page 5
Chapter 1: Introduction Overview Thank you for purchasing PLANET 85M Po werline Ethernet Brid ge. With Planet powerline communication produ cts, your power outlets are no longer to be viewed only as power receptacles but also as network connection point. The PL- 201 is a Powerline to Ethernet Bridge wi th a RJ-45 Ethernet interface which directly c ...
-
Planet Technology PL-201-UK/US - page 6
Dimension UK: 69 x 90 x 60 mm US: 69 x 90 x 48 mm Weight UK: 130g US: 120g Certifications FCC, CE Operating Temp. 0~50 degree C Operating Humidity 10~90% (non-condensing) Input Voltage 100V~240V AC 50~60Hz Package Contents • PL-201 x 1 • CD ROM x 1 (user’s manual, utility) • RJ-45 Ethernet cable x 1 • Quick installation Guide x 1 System R ...
-
Planet Technology PL-201-UK/US - page 7
LED definition LED Description PWR Steady on indicate the power line device connect to the power outlet Steady on indicates the RJ-45 port has correctly connected to the network card of your PC or the Ethernet network ETH Blinking indicates the data are transferring Steady on indicates there exis ts another powerline device PL Blinking indicates th ...
-
Planet Technology PL-201-UK/US - page 8
Chapter 2: Installation Overview The installation of 85M Ether net Bridge will only take mi nutes. No need to set up long wires through out the house, just simply install the utility, and physically plug the unit into the wall outlet, then to c onnect RJ-45 to the computer. Users can select to adjust its security functions and the platform of the n ...
-
Planet Technology PL-201-UK/US - page 9
On this screen you will be asked to input the User Name and Organization. It is not crucial to the device itself, so enter it as desired. The ‘ Install this application for ’ will work under the circumstances which multiple logins are applied. For example: If the user wishes only he/she ca n use the utility with that particular account, then bu ...
-
Planet Technology PL-201-UK/US - page 10
This section allows you to change the default directory where the program is installed. If you don’t want to change it, click on Next to continue the installation. This section allows a user to go ‘ Back ’ or ‘ Install ’ the utility. In case if the user wishes to change the previous options then go ahead, click on ‘ Back ’ to change t ...
-
Planet Technology PL-201-UK/US - page 11
This screen shows the progre ss of the installation. This screen shows that the installati on was completed successfully. Click on Finish to exit the wizard. 11 ...
-
Planet Technology PL-201-UK/US - page 12
Chapter 3: Configuration Overview The PL-201 uses 56-bit DES encryption to block outside access. The key is set by using the Configuration Utility on the CD. By defaul t, the protection is enabled, however, it is recommended to change the default network password. All your powerline devices must use the same network password in order to be connecte ...
-
Planet Technology PL-201-UK/US - page 13
*Note* If you do not see ANY unit in the device status but the powerline device does exist, try to unplug a ll devices and plug them back. Meanwhile, please make sure the cable is the right type and working correctly. If all seems to be correc t, and you still receive nothing in the Device window, try rebooti ng your computer. Part 2: Diagnose a Ne ...
-
Planet Technology PL-201-UK/US - page 14
with the units that you do not view in the network screen, you don’t have to do this with all units.) If the problem persists, tr y to move the unit closer to this current unit (adjacent plugs on the same wall so cket is most preferable). If the problem still persists and that unit is still not shown on the network, then the unit might be defecti ...
-
Planet Technology PL-201-UK/US - page 15
Setting Up Security on a Network Pow erline device The Privacy Tab will allow users to use one primary computer to control the Network Passw ord of all units on the home network. You will have to go back to the Main Tab first then find the DEK (Device Encryption Key) Key located on the botto m of each device. Enter this Key into the Device Password ...
-
Planet Technology PL-201-UK/US - page 16
**Note** The DEK is unique for EACH Powerline device. To use this you will need to input the DEK for each unit. 16 ...
Avez-vous une question à propos de Planet Technology PL-201-UK/US?
Utiliser le formulaire ci-dessous
Si vous n’avez pas résolu votre problème avec Planet Technology PL-201-UK/US, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Planet Technology PL-201-UK/US il est probable qu’il a envie de partager la façon de le résoudre.