Manuel d’utilisation Sherwood SRB3108

12 pages 0.77 mb
Télécharger

Aller à la page of 12

Summary
  • Sherwood SRB3108 - page 1

    As sembly & Maintenanc e Guide ® REGUL A T ORS (SRB3209) ™ MINIMUS (SRB3108) ® SHADOW ...

  • Sherwood SRB3108 - page 2

    T ABLE OF CONTENTS Page T opic Number Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 T ools Required for Servicing . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Sherwood SRB3108 - page 3

    1 INTRODUCTION This manual is a guide for the annual servicing and maintenance of the Sherwood SR3108 Minimus and SR3209 Shadow+ regulators. It gives breakdowns of regulator parts, equipment specifications, servicing instructions, troubleshooting recommendations, and guidelines for proper care of these regulators. This manual is intended for use on ...

  • Sherwood SRB3108 - page 4

    TOOLS REQUIRED FOR MINIMUS & SHADOW+ SER VICING — # 10 T orx Screwdriver (Sherwood T ool TL1 17) — Phillips screwdriver — 3/4" wrench — 5/8" wrench — 9/16" wrench — Side cutting pliers — Sherwood In-line Adjusting T ool ( p/n TL102) — Sherwood Plastic Probe (p/n TL1 1 1) to push out orifice — Sherwood Lever Heig ...

  • Sherwood SRB3108 - page 5

    3 (9) Before removing the exhaust valve (Item 12) from the case, bend it over as far as it will go from the top, bottom, left and right sides. If it fails to snap back quickly , and does not lie perfectly flat against the case, the valve should be replaced. If it does snap back satisfactorily , remove it and inspect the sealing edges. If they appea ...

  • Sherwood SRB3108 - page 6

    (3) Snap the exhaust grid (Item 10) back into its slots. Make sure it is properly seated. (4) Install the lever assembly into the case. (5) Screw the orifice housing (Item 16) onto the threads of the lever assembly . Hold the case (Item 13) in one hand. Use a 3/4" wrench on the orifice housing. T ighten the orifice housing and the lever assemb ...

  • Sherwood SRB3108 - page 7

    5 (6) After setting the adjusting orifice, check the relationship between the diaphragm wear plate and the tip of the lever assembly . If you are reusing the same major parts of the regulator , this measurement will most likely be correct, and no adjustment will be needed. T o check this relationship, temporarily install the diaphragm (Item 2). Wit ...

  • Sherwood SRB3108 - page 8

    (3) Immerse the regulator until the water is 1/4" to 1/8" from the lip of the mouthpiece. (4) Hold the regulator in this position for one minute and then slowly raise it out of the water . (5) T ip the regulator mouthpiece downward and watch the inside of the mouthpiece tube. If any water escapes from the mouthpiece tube, check for source ...

  • Sherwood SRB3108 - page 9

    WET BREA THING: 1. Improper clearing, or diver diving . . . . . . . . . . . . . .Instruct the diver on proper clearing head-technique. in total down position. 2. Diaphragm improperly installed . . . . . . . . . . . . . . .Check position of diaphragm visually . 3. Hole in the mouthpiece at tie area . . . . . . . . . . . . .Replace the mouthpiece. 4. ...

  • Sherwood SRB3108 - page 10

    CUSTOMER MAINTENANCE & HANDLING TIPS How your customers treat their regulators will directly influence the unit's function and durability . Here are a few tips that you can pass on to your customers to help ensure the durability of their new Sherwood octopus: PRE-DIVE CHECKS: (1) Check the hoses and hose connections for cuts, abrasions or ...

  • Sherwood SRB3108 - page 11

    MINIMUS (SR3108) AND SHADOW+ (SR3209) ITEM# CA T ALOG# DESCRIPTION 1 . . . . .3108R-6 . . . . . . . .Cover (right hand version) 1 . . . . .3108L-6 . . . . . . . .Cover (left hand & Shadow+ version) 2 . . . . .3108-13 . . . . . . . .Diaphragm (blue Tufel ® ) 3 . . . . .J12CO4045B . . . .Screw (combination Phillips/ square drive) 4 . . . . .19-4 ...

  • Sherwood SRB3108 - page 12

    Printed in the U.S.A on recycled paper Part Number S-MAN2007 Sherwood Scuba, the SS symbol, Oasis, Blizzard, Magnum, Brut and Wisdom are trademarks of Sherwood, Harsco Corporation Gas and Fluid Control Gr oup. All other names are trademarks of their respective owners. ALL PRODUCTS SUBJECT TO CHANGE WITHOUT NOTICE. 6204 Goodrich Road Clarenc e Ctr, ...

Fabricant Sherwood Catégorie Scuba Diving Equipment

Les documents que nous recevons du fabricant de l'appareilSherwood SRB3108 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Sherwood
- manuels d’utilisations SRB3108
- fiches produit Sherwood
- dépliants
- ou étiquettes-énergie Sherwood SRB3108
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Sherwood SRB3108.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Sherwood SRB3108, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Sherwood SRB3108. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Sherwood SRB3108.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Sherwood SRB3108, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Sherwood SRB3108 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Sherwood SRB3108.

Le manuel d’utilisation complet Sherwood, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Sherwood SRB3108 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Sherwood SRB3108, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lSherwood SRB3108 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Sherwood SRB3108 - qui devraient nous aider dans les premières étapes lors de l'utilisation Sherwood SRB3108
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Sherwood SRB3108
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Sherwood SRB3108 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Sherwood SRB3108?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Sherwood SRB3108, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Sherwood SRB3108 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)