-
Nordmende 2401935EN0801 - page 1
O P E R AT I N G I N S T R U C T I O N S Steam Humidifier 2401935 EN 0801 Nor dmann ec onoV ap N O R D M A N N ENGINEERING ...
-
Nordmende 2401935EN0801 - page 2
2 Intr oduction You have purchased a NORDMANN steam humidifier which, provided you observe the operating instructions, will ensure fully automatic operation and reliable, low-maintenance service. Therefore, read these operating instructions carefully and pay particular attention to the safety instructions and warnings. Should you have any queries t ...
-
Nordmende 2401935EN0801 - page 3
3 General Safety Instructions The econoVap steam humidifier has been designed and constructed in accordance with the latest technology and the accepted safety regulations. The user is obliged to pay attention to these safety instructions as well as the specific regulations for installation and the safety and accident prevention regulations in the c ...
-
Nordmende 2401935EN0801 - page 4
3.1 Dimensions Dimensions of the units Positioning of the humidifier 4 210 5 6 2 354 195 4 0 0 340 6 7 2 490 335 4 9 0 3 Installation Type Dimensions Fixing holes Steam outlet Drainage 4–8 kg/h Fig. 3.1 Fig. 3.2 1 x Ø 22 1 x Ø 22 15–32 kg/h Fig. 3.3 Fig. 3.4 1 x Ø 35 1 x Ø 22 45–65 kg/h Fig. 3.3 Fig. 3.4 2 x Ø 35 1 x Ø 22 3 2 0 3 8 0 10 ...
-
Nordmende 2401935EN0801 - page 5
5 Dimensions of the steam distribution pipes 3.2 Steam Nozzle For smaller outputs of up to 4 kg/h steam, we offer a nozzle which can be either fitted in air ducts, for instance, or used for direct room humidification. The rules for vaporisation lines (lines needed to mix the steam adequately with air) must be observed here too. When the steam nozzl ...
-
Nordmende 2401935EN0801 - page 6
Dimensions of the steam blowers 4-23 kg/h Fixing holes for the Dimensions of the steam blowers 4-23 kg/h steam blowers 4-23 kg/h Dimensions of the Turbo steam blowers 32, 45 und 65 kg/h 6 A B == B A == BA D E CG F BC A D E G F H J B C A D E G F H J A B D C E FG Type A B 4 - 8 kg 1 00 130 1 5-23 kg 1 80 240 Fig. Type A B C D E F G mm mm mm mm mm mm ...
-
Nordmende 2401935EN0801 - page 7
7 3.3 Fitting the humidifier For the fitting of the humidifier use the material supplied with the unit. Observe the various minimum distances as indicated in figure 3.5. Ensure that there is sufficient room to perform servicing and maintenance work and that the unit is easily accessible. To facilitate such work, mount the unit at eye level. We reco ...
-
Nordmende 2401935EN0801 - page 8
Steam-distribution pipe fitted on suction side: Because of the under-pressure in the appliance or the duct part, condensate may be kept back in the steam-distribution pipe. If there is an outlet in the empty part of the humidifier, the condensate can be bled off in the immediate vicinity. An alternative method of bleeding off the condensate can be ...
-
Nordmende 2401935EN0801 - page 9
9 Technical specifications steam blowers: 3.6 Laying the steam hose The steam hose should be kept as short as possible. It should not be possible to block or obstruct the steam supply lines in any way. Furthermore, they must be protected from outside interference (e.g. deformities, kinking etc.). After the hose has been laid, it is advisable to re- ...
-
Nordmende 2401935EN0801 - page 10
10 4 W ater connections 3.7 Laying the condensate hose It is advisable to lay the condensate hose as near to the ver- tical as possible and to feed the condensate either directly into an open funnel or below the siphon. If the steam-distribution pipe is fitted above the humidifier, the condensate can be fed back to the unit by placing the end of th ...
-
Nordmende 2401935EN0801 - page 11
4.2 W ater intake and drainage Please observe the local regulations concerning the connection of appliances to the pressure and drainage system. The humidifier is designed to operate on ordinary tap water only. If you intend to use treated or de-mineralised water, consult your NORDMANN representative beforehand. Where the water pressure is between ...
-
Nordmende 2401935EN0801 - page 12
6.1 Start-up Prior to starting the unit up, check the correct connections of the steam pipe, water feed pipe, drainage pipes and electrical cables. Open the shut-off valve in the water feed pipe and switch the unit on with the black power switch. As soon as the demand for steam is recognised, the green LED lights up, the contactor is activated and ...
-
Nordmende 2401935EN0801 - page 13
13 6.4 System- and servicing indications LED shining “green” continuously Operation Humidification is demanded. The humidifier operates automatically. Without demand of humidity the LED remains dark. red flash in the shining “green” Niveau max. attained Occurs when the Niveau max. sensor is activated. This causes a momentary closure of the ...
-
Nordmende 2401935EN0801 - page 14
14 ! Regular servicing helps to maintain the operation of the humidifier. The following work must be carried out by qualified personnel. 7.1 Regular checks • Inspect the steam cylinder: Are there any deposits in the steam cylinder? ⇒ Remove the drainage strainer and flush the cylinder thoroughly with tap water (without chemical additives). Repl ...
-
Nordmende 2401935EN0801 - page 15
15 black red white black red white Fig. 7.1 7.4 T aking the humidifier out of operation If the humidifier is out of operation for a longer period of time ( e.g. in summer or when the air conditioning system is not operating), the steam cylinder must be emptied and the power supply disconnected. All options can be fitted either at the factory or sub ...
-
Nordmende 2401935EN0801 - page 16
9. T echnical specifications Other heating voltages on request. T ype mark: Type 434 834 1 534 2364 3264 4564 6564 Heating voltage V olt 400 V olt, 50/60 Hz Number of phases ~ 3 3 3 3 3 3 3 Heating current A 4.4 8.8 16.5 25.2 35.1 49.4 7 1.3 External fuses p. phase A 10 16 25 40 50 80 100 T ype mark: Type 422 432 822 832 1532 2362 3262 Heating volt ...
Avez-vous une question à propos de Nordmende 2401935EN0801?
Utiliser le formulaire ci-dessous
Si vous n’avez pas résolu votre problème avec Nordmende 2401935EN0801, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Nordmende 2401935EN0801 il est probable qu’il a envie de partager la façon de le résoudre.