Français dropdown-ico

Manuel d’utilisation Simplicity 1692570

27 pages 1.2 mb
Télécharger

Aller à la page of 27

Summary
  • Simplicity 1692570 - page 1

    How to use this file...(Operators Manuals) ————————————————————————————————————————————––– Instructions for Print Vendors (Paper Manuals) Paper Size: * 11 x 17 * Body—50 lbs brilliant white offset or equivalent. * Cover—on pre-printed two-tone “Swash ...

  • Simplicity 1692570 - page 2

    THIS PAGE INTENTIONALLY BLANK ...

  • Simplicity 1692570 - page 3

    OPERA T OR’S MANUAL R 1 2 3 4 5 Large Frame Snowthrower Models 860 Models Mfg. No. Description 1691900 860, 8HP Snowthrower 1692469 860, 8HP Snowthrower (Export) 970 Models Mfg. No. Description 1692569 970, 9HP Snowthrower 1692570 970, 9HP Snowthrower (Export) 1080 Models Mfg. No. Description 1691899 1080, 10HP Snowthrower 1691948 1080, 10HP Snow ...

  • Simplicity 1692570 - page 4

    MANUFACTURING, INC. 500 N Spring Street / PO Box 997 Port Washington, WI 53074-0997 www.simplicitymfg.com © Copyright 1998, Simplicity Manufacturing, Inc. All Rights Reserved. Printed in USA. ...

  • Simplicity 1692570 - page 5

    OPERA T OR’S MANUAL R 1 2 3 4 5 Large Frame Snowthrower Models 8/24E Models Mfg. No. Description 1692616 824E, 8HP Snowthrower 9/28 Models Mfg. No. Description 1692617 9/28, 9HP Snowthrower 1715080-05 Rev 8/1998 TP 100-2016-05-LW-B ...

  • Simplicity 1692570 - page 6

    500 N. Spring Street, P .O. Box 997 Port W ashington, WI 53074-0997 ...

  • Simplicity 1692570 - page 7

    03 1 T able Of Contents SAFETY RULES General ...................................................................2 Preparation .............................................................2 Operation ................................................................3 Maintenance & Storage ..........................................3 Safety Signs &a ...

  • Simplicity 1692570 - page 8

    03 2 W ARNING This unit is a “two-stage” snowthrower. The first stage is the auger, which feeds the snow back into the impeller housing. The second stage is the impeller, which throws the snow out the dis- charge chute. If bodily contact is made with the auger or impeller when they are rotating, severe personal injury will occur. To avoid injur ...

  • Simplicity 1692570 - page 9

    03 3 Safety Rules OPERA TION • Keep hands and feet away from rotating parts. Keep clear of discharge opening at all times. • Always clear snow up and down the face of slopes, never across the face. Use extreme caution when changing direction on slopes. Do not attempt to clear slopes over 17.7% (10 o ) . • Use extreme caution when operating on ...

  • Simplicity 1692570 - page 10

    03 Safety Signs & Decals 4 SAFETY DECALS Safety warning decals are placed at strategic locations on the snowthrower as a constant reminder to the opera- tor of the most important safety precautions. All warning, caution and instructional messages on your snowthrow- er should be carefully read and obeyed. If any of these decals are lost or damag ...

  • Simplicity 1692570 - page 11

    03 Speed Selector Traction & Free-Hand™ Control Auger Engage Control Chute Direction Control Chute Deflector Chute Deflector Knob OR Remote Deflector Control Skid Shoes Traction Lock Pins Headlight (optional) 5 Controls Figure 1. Snowthrower Controls (1080 Model Shown ) Figure 2. Engine Controls F E C G D B A Location of electric starter if e ...

  • Simplicity 1692570 - page 12

    03 6 ST ARTING CONTROLS Electric Start Units Only A. Electric Start Button - The Electric Start Button (A, Figure 3) activates an electric starter mounted to the engine, eliminating the need to pull the starter handle. The Electric Start Button operates on 120 Volts AC, which is provided by connection to the extension cord provided with units equip ...

  • Simplicity 1692570 - page 13

    03 7 GROUND SPEED CONTROLS A. Speed Selector - This lever (A, Figures 4 & 5) is used to set the ground speed of the snowthrower. The snowthrower has five forward speeds, 1–5, and two reverse speeds, 1–2. No neutral position or gate is required, since the traction drive design automati- cally provides "neutral" (no forward or rever ...

  • Simplicity 1692570 - page 14

    03 8 GENERAL OPERA TION CHECKS BEFORE EACH ST ART -UP 1. Make sure all safety guards are in place and all nuts, bolts and clips are secure. 2. Check the engine oil level. See your engine Owner’s Manual for procedure and specifications. 3. Check to make sure spark plug wire is attached and spark plug is tightened securely. If necessary, torque spa ...

  • Simplicity 1692570 - page 15

    03 Figure 7. Operator's Control Position A. Speed Selector B. Traction & Free-Hand™ Control C. Auger Engage Control D. Chute Direction Control E . Chute Deflector (not shown) F. Remote Deflector Control. A B C D F 9 Operation ST ARTING THE ENGINE 1. Turn the fuel valve (B, Figure 6) to the ON position. 2. Insert the Engine Key (F, Figure ...

  • Simplicity 1692570 - page 16

    03 10 ENGINE SPEED For overall best performance, run the snowthrower at full engine operating speed. Use the engine Throttle Lever (E, Figure 6) to set the engine speed. Slide the Throttle Lever UP to increase engine speed, and DOWN to reduce speed. GROUND SPEED SELECT OR Use the Speed Selector (A, Figure 7) to control the drive speed of the snowth ...

  • Simplicity 1692570 - page 17

    03 11 Operation FREE-WHEELING AND TRACTION DRIVE LOCK For easy turning when pushing the snowthrower, you can disengage the traction drive at one or both wheels by using the Traction Lock Pins (See Figures 11 & 12.) 1. Turn the unit off, remove the Engine Key, and discon- nect the spark plug wire. 2. To DISENGAGE the traction drive lock, insert ...

  • Simplicity 1692570 - page 18

    03 12 Regular Maintenance NORMAL CARE Check auger gear case lubrication.* Lubricate snowthrower . Check tire pressure. Change engine oil.** ✛ Clean or replace spark plug. ✛ Check drive linkage/belt tension Page 12 Page 13 Page 22 - - Page 16-19 25 Hours 10 Hours Monthly 50 Hours ✛ Y early 4-6 Hours Simplicity Winter Weight Worm Gear Oil 10W O ...

  • Simplicity 1692570 - page 19

    Figure 14. Lubricate Points Where Free-Hand TM Control Linkage Pivots - (Model 1080 Shown) Do not lubricate Remote Deflector Control 04 LUBRICATION NOTES: 1.Grease locations indicated by grease gun symbol: Use grease fittings when present. Disassemble parts to apply grease to moving parts when grease fittings are not installed. 2.Oil locations indi ...

  • Simplicity 1692570 - page 20

    03 14 Service W ARNING Before performing any adjustment or service to snowthrower, stop the engine and wait for moving parts to stop. Remove the key. To prevent accidental starting, disconnect the spark plug wire and fasten away from the plug. PROBLEM POSSIBLE CAUSE REMEDY Engine fails to start. 1. Key is OFF. 2. Failure to Prime cold Engine 3. Fue ...

  • Simplicity 1692570 - page 21

    03 15 Service PROBLEM POSSIBLE CAUSE REMEDY Auger rotates, but snow is not thrown far enough 1. Chute Deflector too low. 2. Engine speed too slow. 3. Ground speed too fast. 4. Snowthrower discharge chute clogged. 5. Auger belt loose or worn. 1. Adjust deflector as necessary. 2. Set speed to full throttle. 3. Use slower Speed Selector setting. 4. ST ...

  • Simplicity 1692570 - page 22

    Figure 21. Belt Cover Belt Cover Screws 03 16 Figure 19. Speed Selector and Auger Drive Linkages A. Turnbuckle E. Lower Rod B. Spring Hook F. Nuts C. Lever G. Nuts D. Carriage Bolts SPEED SELECT OR ADJUSTMENT 1. Loosen the two nuts (F, figure 19). 2. Place the shift lever in 5th gear. The lower speed selector rod (E, Figure 19) will properly locate ...

  • Simplicity 1692570 - page 23

    Figure 24. Belt Pattern (as viewed from front of snowthrower) A. Engine Pulley C. Idler Pulley B. Drive Belt D. Driven Pulley Belt Stops Belt Stops (Auger Pulley Only) 03 Maintenance & 17 Service b. Remove the belt from the engine pulley. Slip the belt from under the brake pad. c. Remove six capscrews from bottom cover to snowthrower frame. Loo ...

  • Simplicity 1692570 - page 24

    03 18 Service Figure 26. Shear Pins Figure 25. Roller Chain Master Link Keeper link (Must install towards wheel side with open end trailing.) Master link Direction of travel ROLLER CHAIN REPLACEMENT 1. Remove gas from fuel tank and run engine until it stops running from lack of fuel. 2. Disconnect spark plug wire and fasten it away from the spark p ...

  • Simplicity 1692570 - page 25

    DISCHARGE CONTROL ADJUSTMENT If the discharge chute is difficult to operate, first lubricate the pinion gear (A, Figure 27) and ring gear (F, Figure 27). If it is still difficult to operate, adjust as follows: 1. Loosen the nut (G, Figure 27) which holds the pinion gear bracket in the slotted hole. 2. If the pinion gear is too tight against the rin ...

  • Simplicity 1692570 - page 26

    03 20 ENGINE Make ................................................................Tecumseh Cylinders ........................................................................1 Cycles .............................................................................4 Crankshaft .......................................................Horizontal 8 HP - Model ...

  • Simplicity 1692570 - page 27

    03 21 Replacement Parts & Accessories USE ONL Y GENUINE SIMPLICITY REPLACEMENT P ARTS A vailable through your local authorized SIMPLICITY dealer . Note: Information listed above is correct at time of printing, and are subject to changes in availability and specifications without notice. Part numbers may be superceded by other part numbers. COMM ...

Fabricant Simplicity Catégorie Snow Blower

Les documents que nous recevons du fabricant de l'appareilSimplicity 1692570 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Simplicity
- manuels d’utilisations 1692570
- fiches produit Simplicity
- dépliants
- ou étiquettes-énergie Simplicity 1692570
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Simplicity 1692570.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Simplicity 1692570, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Simplicity 1692570. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Simplicity 1692570.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Simplicity 1692570, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Simplicity 1692570 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Simplicity 1692570.

Le manuel d’utilisation complet Simplicity, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Simplicity 1692570 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Simplicity 1692570, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lSimplicity 1692570 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Simplicity 1692570 - qui devraient nous aider dans les premières étapes lors de l'utilisation Simplicity 1692570
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Simplicity 1692570
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Simplicity 1692570 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Simplicity 1692570?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Simplicity 1692570, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Simplicity 1692570 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Captcha
Nouvelle image

Commentaires (0)