Manuel d’utilisation Electrolux 34942G

28 pages 0.25 mb
Télécharger

Aller à la page of 28

Summary
  • Electrolux 34942G - page 1

    34942G Gas hob Operating Instructions GB ...

  • Electrolux 34942G - page 2

    2 Important Safety Information Y ou MUST r ead these warnings car efully befor e installing or us ing the hob. If you need assistance, contact our Customer Care Department on 087 05 350 350 Installation  This hob must be installed by qualified personnel, according to the manufacturer’s instructions and to the relevant British Standards.  An ...

  • Electrolux 34942G - page 3

    3  When using the hob for a long period of time, the ventilation should be improved, by opening a window or increasing the extractor speed.  Do not use this hob if it is in contact with water . Do not operate the hob with wet hands.  Ensure the control knobs are in the ‘OFF’ position when not in use.  When using other electrical app ...

  • Electrolux 34942G - page 4

    4 Contents Important Safety Information .................................................................... 2 Instructions for the User .............................................................................. 6 Description of the Hob ........................................................................................... 6 Operation ..... ...

  • Electrolux 34942G - page 5

    5 This appliance is manufactured accor ding to the following EEC directives: 73/23 EEC - 90/683 EEC - 93/68 EEC - 89/336 EEC - 90/396 EEC, current edition. Guide to Use the in struction s The following symbols will be found in the text to guide you throughout the Instructions: Safety Instructions Step by step instructions for an oper ation Hints an ...

  • Electrolux 34942G - page 6

    6 1. Hob T op 2. Rapid Burner 3. Semi-rapid Burners 4 . Triple-cr own Burner 5. Auxiliary Burner 6. Control knob for back left burner (semi-rapid) 7. Control knob for back right burner (semi-r apid) 8. Control knob for front right burner (auxiliary) 9 . Control knob for central burner (triple-crown) 10 . Control knob for front right burner (r apid) ...

  • Electrolux 34942G - page 7

    7 Operation Burner minimum m aximum diameter diameter Triple-crown (ultra-rapid) 160 mm 260 mm Lar ge (r apid ) 160 mm 240 mm Medium (semi-rapid) 120 mm 220 mm Small (auxiliary) 80 mm 160 mm As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering. If you use a saucepan which is smaller than the recom ...

  • Electrolux 34942G - page 8

    8 Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply . The hob is best cleaned whilst it is still warm, as spillage can be removed mor e easily than if it is left to cool. The Hob To p Regularly wipe over the hob top using a soft cloth well wrung out in warm water to which a little washing ...

  • Electrolux 34942G - page 9

    9 Something Not Working? If the hob is not working correctly , please carry out the following checks before contacting your local Service Force Centre. SYMPT OM  There is no spark when lighting the gas  The gas ring burns unevenly SOLUTION  Check that the unit is plugged in and the electrical supply is switched on  Check that the RCCB h ...

  • Electrolux 34942G - page 10

    10 Service and Spar e Part s When you contact the Service Centre, they will need the following information: 1. Y our name, address and post code. 2. Y our telephone number 3. Clear and concise details of the fault 4 . The model and the serial number (see rating label on the back of this instruction booklet) 5. Date of purchase If you requir e spare ...

  • Electrolux 34942G - page 11

    11 Guarantee Conditions Standar d guarantee conditions We, AEG-Electrolux, undertake that if within 12 months of the date of the purchase this AEG- Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workman- ship or materials, we will, at our discretion repair or r eplace the same FREE OF CHARGE for labour , ...

  • Electrolux 34942G - page 12

    12 OVERALL DIMENSIONS Width: 860 mm Depth: 500 mm Height: 8 8 m m Weight: 1 6 K g CUT OUT DIMENSIONS Width: 830 mm Depth: 470 mm Thickness: 3 0 m m SUPPLY CONNECTIONS Gas: RC 1/2 inch (1/2 inch male) Rear right hand corner Electric: 2 30 V 50 Hz , 220 V 60 Hz s upply , 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fus ...

  • Electrolux 34942G - page 13

    13 Burner Dia. Tap By-pass 1/100 mm Auxiliary 28 Semi-rapid 32 Rapid 40 Triple-Crown 5 6 Aeration adjustment none BURNER RAPID S E M I-RAPID AUXILIARY T R IP L E (large) ( m edium) ( small) CROWN POSITION MA X MI N MA X M IN M AX MI N MA X MI N NOMINAL THERMAL POWER (kW) 3 . 0 0 . 6 5 2 . 0 0 . 4 5 1 . 0 0 . 3 3 4 . 0 1 . 2 NOMINAL FLOW RATE (m 3 / ...

  • Electrolux 34942G - page 14

    14 Important safety r equir ements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition). Detailed recommendations are contained in the following British Standards Codes Of Practice: B .S. 6 172/ B.S. 5440, P ar . 2 and B.S. 6891 Current Edi ...

  • Electrolux 34942G - page 15

    15 CLEARANCES REQUIRED WHEN FITTING THE GAS HOB WITHOUT A COOKER HOOD ABOVE CLEARANCES REQUIRED WHEN FITTING THE GAS HOB WITH A COOKER HOOD ABOVE Installation IMPORTANT This hob must be installed by qualified personnel to the relevant British Standar ds. Any gas installation must be carried out by a CORGI register e d installer . The manufacturer w ...

  • Electrolux 34942G - page 16

    16 A) End of shaft with nut B) Washer C) Elbow FO 0814 FO 0264 On the end of the shaft, which includes the G 1/2" threaded elbow , adjustment is fixed so that the washer is fitted between the components as shown in the diagram. Scr ew the parts together without using excessive force. It is important to install the elbow corr ectly , with the s ...

  • Electrolux 34942G - page 17

    17 Cut Out Size The dimensions of the cut-out are given in the diagram. Building In Building over a cupboar d or drawer If the hob is to be installed above a cupboard or dr awer it will be necessary to fit a heat resistant boar d below the base of the hob on the underside of the work surface. It is also recommended to carry out the electrical conne ...

  • Electrolux 34942G - page 18

    18 ON/OFF SWITCH FLEX OUTLET ON/OFF SWITCH FLEX OUTLET FO 0763 FO 0764 12 Building over a kitchen unit with door Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in diagram 3. The panel fitted under t ...

  • Electrolux 34942G - page 19

    19 Building in Fitting the hob to the worktop Before fitting the hob into the cut out, a sealing gasket supplied with the hob must be fitted to the edge of the cut out. It is essential that no gaps are left in this seal in or der to prevent spillage near the hob seeping into the cabinet below . 1) Place the sealing gasket all around the edge of the ...

  • Electrolux 34942G - page 20

    20 Electrical connection s Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. THIS HOB MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. This hob is designed to be connected to a 23 0 V ...

  • Electrolux 34942G - page 21

    21 P ermanent Connection In the case of a permanent connection, it is necessary that you install a double pole switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the requir ed load in compliance with the curr ent electric regulations. The switch must not brea ...

  • Electrolux 34942G - page 22

    22 Fault Finding Preliminary Electrical Sy stems Check START Isolate appliance and carry out: A: Earth Continuity check. Has inlet fuse blown? Carry out: C: Polarity check. Electricity supply should now be satisfactory. Carry out: D: Resistance to Earth check. Inlet wiring faulty. Rectify any fault. Isolate appliance and carry out: B: Insulation ch ...

  • Electrolux 34942G - page 23

    23 A. EARTH CONTINUITY CHECK Appliance must be electrically disconnected - meter set on ý (Ohms) x 1 scale and adjust zero if necessary . — Test leads from any appliance earth point to earth pin on plug. Resistance should be less than 0.1 ý (Ohm), check all earth wires for continuity and all contacts are clean and tight. B. INSULA TION CHECK Ap ...

  • Electrolux 34942G - page 24

    24 Check gas supply at burner Ignition System / Gas Ignition YES Check plug top fuse and replace if necessary Check polarity and earth continuity of supply point Check earth continuity of appliance Ignitor does not spark Check fitting of burners Check position of the electrode Check by pass simmer adjusted Light burner manually Check continuity fro ...

  • Electrolux 34942G - page 25

    25 Commis sioning When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedur e below . 1) T urn the gas tap to the MAX position and ignite. 2) Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. If the flame is unstable or is extingui ...

  • Electrolux 34942G - page 26

    26 Conver sion fr om Natur al Gas to LPG It is important to note that this model is designed for use with natural gas but can be converted for use with butane or propane gas providing the correct injectors are fitted and the gas rate is adjusted to suit. Method 1 ) Ensure that the gas taps are in the 'OFF' position 2 ) Isolate the hob fro ...

  • Electrolux 34942G - page 27

    27 ...

  • Electrolux 34942G - page 28

    35690-3001 03 /05 Grafiche MDM - Forlì From the Electrolux Group. The world’s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 m illion Electrolux G r oup products (such as refrigerators, cookers, washing machines, vacuum cleaners, chain saws and lawn mo ...

Fabricant Electrolux Catégorie Gas Grill

Les documents que nous recevons du fabricant de l'appareilElectrolux 34942G peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Electrolux
- manuels d’utilisations 34942G
- fiches produit Electrolux
- dépliants
- ou étiquettes-énergie Electrolux 34942G
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Electrolux 34942G.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Electrolux 34942G, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Electrolux 34942G. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Electrolux 34942G.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Electrolux 34942G, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Electrolux 34942G par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Electrolux 34942G.

Le manuel d’utilisation complet Electrolux, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Electrolux 34942G - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Electrolux 34942G, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lElectrolux 34942G qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Electrolux 34942G - qui devraient nous aider dans les premières étapes lors de l'utilisation Electrolux 34942G
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Electrolux 34942G
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Electrolux 34942G dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Electrolux 34942G?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Electrolux 34942G, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Electrolux 34942G il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)