Manuel d’utilisation Sears 200.71450

16 pages 0.32 mb
Télécharger

Aller à la page of 16

Summary
  • Sears 200.71450 - page 1

    OWNER’S MANUAL Model No. 200.71450 Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. 50/15/2 AMP MANU AL BA TTER Y CHARGER 225/125 AMP ENGINE ST ARTER with BA TTERY TESTER CAUTION: Read and Follow All Safety Rules and Operating Instructions Before Every Use of this Product. ...

  • Sears 200.71450 - page 2

    1 Sch 517 T able Of Contents Warranty .................................................................... 1 Important Safety Instructions .................................. 2 Parts .......................................................................... 3 Before Using Your Battery Charger ........................ 4 Assembling your charger ...... ...

  • Sears 200.71450 - page 3

    2 Sch 517 – SAVE THESE INSTRUCTIONS – w •Read all instructions and cautions printed on the battery charger, battery, and vehicle or equipment using battery. •Use charger only on lead-acid type rechargeable batteries, such as those used in cars, trucks, trac- tors, airplanes, vans, RV’s, trolling motors, etc. This charger is not intended t ...

  • Sears 200.71450 - page 4

    3 Sch 517 Pa r t s This section shows an illustration of your battery charger. Use it to become familiar with where all the parts are located, and what they look like. Wiring diagram Item 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 Part Number 3599000286 3899000391 3899000408 90026001 399900065 2299000614 93026429 0099000063 0099000080 52 ...

  • Sears 200.71450 - page 5

    4 Sch 517 B e fo r e Using Y our B a t ter y C h ar g e r It is important to prepare your charger for use. This section will tell you how to assemble the charger, ground and connect the power cord, and prepare to charge a battery. Assembling your charger It is important to fully assemble your charger before use. Follow these instructions for easy a ...

  • Sears 200.71450 - page 6

    5 Sch 517 3. Tap the other axle cap onto the opposite end of the axle and place the axle assembly onto the bottom of the charger. Place one end of the bracket into slot, then place the axle assembly under each bracket. Fasten the other side of the brackets using the two 10-32 screws provided. To attach the handle: Turn the charger right side up ont ...

  • Sears 200.71450 - page 7

    6 Sch 517 A TEMPORARY adapter may be used to connect the charger to a two-pole outlet if a properly grounded outlet is not available. Use the adapter ONLY until a properly grounded outlet can be installed by a qualified electrician. DANGER: Before using an adapter as illustrated, be certain that the center screw of the outlet plate is grounded. The ...

  • Sears 200.71450 - page 8

    7 Sch 517 Preparing your battery to be charged It is important that you read and follow these guidelines while you are preparing to charge your battery. • Make sure that you have a 12 volt or 6 volt lead-acid battery. Set the volt/amp selector switch to match the voltage rating of the battery to be charged. • Clean the battery terminals. Be car ...

  • Sears 200.71450 - page 9

    8 Sch 517 Using Y our Bat ter y Charger To obtain the best results from your battery charger, you must know how to use it properly. This section will tell you how to set the controls, and how you can charge a battery while it is still in the vehicle, or you can remove it and then charge it. Follow the instructions below depending on how you choose ...

  • Sears 200.71450 - page 10

    9 Sch 517 The “START” area of the ammeter indicates a high rate of current being drawn by the battery. For example, when cranking an engine, the needle will be at the far right side of the “START” area since the starter will be drawing up to 225 amps from the charger. VOLTMETER: To obtain an accurate reading of your battery’s voltage befo ...

  • Sears 200.71450 - page 11

    10 Sch 517 Charging your battery Charging your battery in the vehicle: 1. Arrange the power cord and charging cords care- fully in order to avoid damage that could be caused by the hood, door, or moving engine parts. 2. Keep clear of the fan blades, belts, pulleys, and other parts that can cause injury. 3. Check the polarity of the battery posts us ...

  • Sears 200.71450 - page 12

    11 Sch 517 Charging your battery outside the vehicle: 1. Remove battery from vehicle, making sure to dis- connect grounded terminal first with all power turned off to the vehicle. REMEMBER: A marine battery should be removed and charged on shore unless special equipment designed for marine use is available. Hydrogen gas emissions can create an expl ...

  • Sears 200.71450 - page 13

    12 Sch 517 15 AMP NR NR 1½ - 2 2 - 2½ 2½ - 4½ 2½ 3½ 4 4½ 2 AMP 2 - 4 4 - 10 11 - 14 14 - 18 18 - 35 18 27 30 33 Calculating charge time The Chart Method Use the following table to more accurately determine the time it will take to bring a battery to full charge. First, identify where your battery fits into the chart. • Small batteries — ...

  • Sears 200.71450 - page 14

    13 Sch 517 Using the engine start feature Your battery charger can be used to jump start your car if the battery is low. Follow these instructions on how to use the engine start feature. 1. Set the timer knob to the OFF position. Then follow the instructions for how to connect the charger to the battery in the section “Charging your battery while ...

  • Sears 200.71450 - page 15

    14 Sch 517 If the above solutions do not eliminate the problem... call toll-free from anywhere in the U.S.A. 1-800-SEARS-64 (1-800-732-7764) 7 am to 4:30 pm CST Monday through Friday POSSIBLE CAUSE Clamps are not making a good connection. 2 amp charge rate is being used. AC cord and/or extension cord is loose. Poor electrical connection. Battery se ...

  • Sears 200.71450 - page 16

    When requesting service or ordering parts, always provide the following information: • Product T ype • Model Number • Part Number • Part Description OWNER’S MANUAL Model No. 200.71450 For the repair or replacement par ts you need Call 7 am - 7 pm, 7 days a week 1-800-366-P ART (1-800-366-7278) For the location of a Sears Repair Ser vice C ...

Fabricant Sears Catégorie Battery Charger

Les documents que nous recevons du fabricant de l'appareilSears 200.71450 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Sears
- manuels d’utilisations 200.71450
- fiches produit Sears
- dépliants
- ou étiquettes-énergie Sears 200.71450
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Sears 200.71450.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Sears 200.71450, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Sears 200.71450. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Sears 200.71450.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Sears 200.71450, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Sears 200.71450 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Sears 200.71450.

Le manuel d’utilisation complet Sears, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Sears 200.71450 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Sears 200.71450, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lSears 200.71450 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Sears 200.71450 - qui devraient nous aider dans les premières étapes lors de l'utilisation Sears 200.71450
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Sears 200.71450
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Sears 200.71450 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Sears 200.71450?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Sears 200.71450, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Sears 200.71450 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)