Français dropdown-ico

Manuel d’utilisation Davis Heavy Duty Solar Power Kit 6612

23 pages Non applicable
Télécharger

Aller à la page of 23

Summary
  • Davis Heavy Duty Solar Power Kit 6612 - page 1

    ™ Solar P o w er Kits USER MANUAL Davis Instruments, 3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A. • 510-732-9229 • www.davisnet.com R Solar P ower Kit, #6614 & Heavy Duty Solar Po wer Kit, #6612 ™ ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 2

    1 Welcome to Solar Power Kit & Heavy Duty Solar Power Kit (6614 & 6612) The Solar Power Kit and the Heavy Duty Solar Power Kit allow you to power and shelter your Vantage Pro2 or Vantage Vue console, or your Weather Envoy or Envoy8X for remote or field installations. The kits consist of three key elements: a solar panel, a battery, and a re ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 3

    2 Contents of Package Solar Panel and W eather-Resistant Housing Charging Circuit: 10’ console or Envo y power cable (back) Battery power cable (middle) Solar power cable (front) Charging Circuit: 10’ console or Envo y power cable (back) Battery power cable (middle) Solar power cable (front) T o solar panel T o solar panel 6 volt, 1.40 amp . hr ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 4

    3 The package contains the following: • Weather-proof shelter with solar panel • Hardware kit (as shown) Tools for Setup • Phillips head screwdriver • Adjustable wrench or 7/16 '' wrench • Drill and 3/16 '' (5 mm) drill bit (if mounting on a vertical surface) ¼" Lock W ashers ¼" Hex Nuts U-Bolts Backing Pla ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 5

    4 Mounting Consoles in the Solar Power Kit (1.4 Ah battery, #6614) Note: You may mount the shelter before installing the console or Envoy. However, it may be easier to do this at a workbench rather than in the field. In the case of an Envoy, you will need a PC to set up the Envoy after you power it up. The shelter has been designed to fit Davis con ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 6

    5 3. In order for the Vantage Pro2 console to fit in the shelter, you must move the battery platform. Remove the two screws and washers holding the battery platform in place. 4. Move it to the left side (as you face the shelter). Making sure the tray is flush with the bottom, reinsert and tighten the screws. 5. Plug the console power cable back int ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 7

    6 7. On the back wall of the shelter, look for the embossed outline of a Vantage Pro2 console and the screw holes marked “VP2.” 8. Insert the two ½'' #6 screws into the marked holes. The depth of the hole has been specifically designed so that the screw will “bottom out” at the correct depth. Do not overtighten. Note: You may nee ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 8

    7 Mounting a Vantage Vue console in the Solar Power Kit 1. Remove all packaging material. 2. Unplug the power cable from the jack closest to the back on the charging circuit. Console/En voy P ower Battery power Solar power ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 9

    8 3. In order for the Vantage Vue console to fit in the shelter, you must move the battery platform. Remove the two screws and washers holding the battery platform in place. 4. Move it to the right side (as you face the shelter). Making sure the tray is flush with the bottom, reinsert and tighten the screws. 5. Plug the console power cable back int ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 10

    9 7. On the back wall of the shelter, look for the embossed outline of a Vantage Vue console and the screw holes marked “VV.” 8. Insert the two ½'' #6 screws into the marked holes. The depth of the hole has been specifically designed so that the screw will “bottom out” at the correct depth. Do not overtighten. Note: You may need ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 11

    10 Mounting a Wireless Weather Envoy in the Solar Power Kit Note: You will need your PC to setup the Envoy after you power it up. 1. Remove all packaging material. 2. Unplug the power cable from the jack closest to the back on the charging circuit. Console/Env oy P ower Battery power Solar power ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 12

    11 3. In order for the Envoy to fit in the shelter, you must move the battery platform. Remove the two screws and washers holding the battery platform in place. 4. Move it to the right side (as you face the shelter). Making sure the tray is flush with the bottom, reinsert and tighten the screws. 5. Plug the power cable back into the jack. (It fits ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 13

    12 7. On the back wall of the shelter, look for the embossed outline of an Envoy and the screw holes marked “E” 8. Insert the two ½'' #6 screws into the marked holes. The depth of the hole has been specifically designed so that the screw will “bottom out” at the correct depth. Do not overtighten. Note: You may need to adjust the ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 14

    13 Mounting an Envoy in the Heavy Duty Solar Power Kit (12 Ah battery, #6612) Inside the Heavy Duty Solar Power Kit shelter, you may install: • An Envoy8X • A cabled Weather Envoy • A wireless Weather Envoy where low light or poor conditions require extra power. Note: If using the Heavy Duty Solar Power Kit to power a cabled Vantage Pro2 cons ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 15

    14 3. In order for the Envoy to fit in the shelter, you must move the battery platform. Remove the two screws and washers holding the battery platform in place. 4. Move it to the right side (as you face the shelter). Making sure the tray is flush with the bottom, reinsert and tighten the screws. ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 16

    15 5. Plug the console power cable back into the jack. (It fits only one way, with the latch in back.) 6. The battery comes shipped with the positive cable unconnected to prevent battery drain. Connect the positive (red) cable to the positive (red) terminal on the battery. 7. On the back wall of the shelter, look for the embossed outline of an Envo ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 17

    16 10. Plug the main power cable into the Envoy. 11. If you are mounting a cabled Weather Envoy, remove the rubber plug from the hole on the floor of the shelter, under the Envoy. Wrap the oval-hole split grommet around the Envoy’s ISS cable and feed the cable up through the hole, inserting grommet snuggly into the hole. Plug the ISS cable into t ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 18

    17 Using the Solar Power Kit or Heavy Duty Solar Power Kit with a Universal Shelter For some installations, you will need both a Solar Power Kit or Heavy Duty Solar Power Kit and a Universal Shelter. For example, if you wish to power to a cabled Vantage Pro2, you will need the Heavy Duty Solar Power Kit with the 12 Ah bat- tery. However, there is n ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 19

    18 Mounting the Shelter Choose a location for your shelter. It can be mounted on a pole or a flat surface such as a wall or a wooden post. It is important that the shelter be mounted so that the solar panel gets the greatest amount of sunshine: the solar panel should be facing south (in the northern hemisphere) or north (in the southern hemisphere) ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 20

    19 Mounting on a Post or Flat Surface Attach the shelter to the mounting surface in the desired location using the large screws,1/4'' flat washers, and backing plates as shown below. Use a pencil or a center-punch to mark the location of the pilot hole. 1. With a 3/16'' (5 mm) drill bit, drill two holes approximately 2'&apo ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 21

    20 Appendix A: Using the Heavy Duty Solar Power Kit with two batteries You may add even more power to your devices by mounting two batteries in your Heavy Duty Solar Power Kit, and running that power to a console installed in a Universal Shelter. Please contact Davis Technical Support for materials and instructions. ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 22

    21 Contacting Davis Technical Support For questions about installing or operating your Solar Power Kit, please contact Davis Technical Support. We’ll be glad to help. Note: Please do not return your unit for repair without prior authorization. Online www.davisnet.com See the Weather Support section for copies of user manuals, product specificatio ...

  • Davis Heavy Duty Solar Power Kit 6612 - page 23

    Solar Power Kits Product Numbers 6614 (1.4 Ah battery) and 6612 (12 Ah battery) Document Number: 07395.326 Rev. A, February 6, 2013 Vantage Pro ® , Vantage Pro2 ™ , Vantage Vue ® , Envoy 8X ™ , and Envoy ™ are trademarks of Davis Instruments Corp., Hayward, CA. © Davis Instruments Corp. 2012. All rights reserved. Information in this docume ...

Fabricant Davis Catégorie Battery charger

Les documents que nous recevons du fabricant de l'appareilDavis Heavy Duty Solar Power Kit 6612 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Davis
- manuels d’utilisations Heavy Duty Solar Power Kit 6612
- fiches produit Davis
- dépliants
- ou étiquettes-énergie Davis Heavy Duty Solar Power Kit 6612
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Davis Heavy Duty Solar Power Kit 6612.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Davis Heavy Duty Solar Power Kit 6612, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Davis Heavy Duty Solar Power Kit 6612. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Davis Heavy Duty Solar Power Kit 6612.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Davis Heavy Duty Solar Power Kit 6612, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Davis Heavy Duty Solar Power Kit 6612 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Davis Heavy Duty Solar Power Kit 6612.

Le manuel d’utilisation complet Davis, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Davis Heavy Duty Solar Power Kit 6612 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Davis Heavy Duty Solar Power Kit 6612, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lDavis Heavy Duty Solar Power Kit 6612 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Davis Heavy Duty Solar Power Kit 6612 - qui devraient nous aider dans les premières étapes lors de l'utilisation Davis Heavy Duty Solar Power Kit 6612
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Davis Heavy Duty Solar Power Kit 6612
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Davis Heavy Duty Solar Power Kit 6612 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Davis Heavy Duty Solar Power Kit 6612?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Davis Heavy Duty Solar Power Kit 6612, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Davis Heavy Duty Solar Power Kit 6612 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Captcha
Nouvelle image

Commentaires (0)