-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 1
Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 Model: ST -42TVFL-IPI 1 Owner ’ s Manual Installation and Operation • Do not store or use gasoline or other flamma- ble vapors and liquids in the vicinity of this or any other appliance. • What to do if you smell gas - Do not try to light any appliance - Do not touch any electric ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 2
2 Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 ! SAFETY AND W ARNING INFORMA TION READ and UNDERST AND all instructions carefully before starting the inst allation. FAILURE TO FOLLOW these installation instructions may result in a possible fire hazard and will void the warranty . Prior to the first firing of the fireplace, READ t ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 3
3 Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 T able of Contents Safety and W arning Information .................. 2 Service Parts List ......................................... 4 Section 1: Approvals and Codes ................ 6 Appliance Certification ........................................... 6 Installation Codes .......... ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 4
4 Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 4 Log Set Assembly Service Parts Diagram Service Parts ST -42TVFL-IPI Beginning Manufacturing Date: July 2002 Ending Manufacturing Date: _______ 1 2 3 4 5 6 7 I T EM DES CRI P TI O N S ERI AL # P ART NUM BER Log Set A s s em bly (s ol d as c ompl et e l og s et only ) LOGS -M S Y 1 H ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 5
V alve Assembly Diagram/Parts List Service Parts Beginning Manufacturing Date: July 2002 Ending Manufacturing Date: ______ ST -42TVFL-IPI 5 Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 1 2 3 4 5 6 7 8 9 10 11 12 13 16 15 14 I T EM DES CRI P TI O N S ERI AL # P ART NUM BER Pilo t A s s e mb ly N G 385- 510A Y Pilo t A s s e mb ly ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 6
Approval Listings and Codes Appliance Certification The Heat & Glo fireplace models discussed in this Installers Guide have been tested to certification standards and listed by the applicable laboratories. CERTIFICA TION MODEL LABORA TO RY TYPE S T ANDARD ST -42TVFL-IPI Underwriters B- V ent ANSI Z21.50•CGA2.22 Installation Codes The fireplac ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 7
7 Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 2 Getting S t arted Introducing the Heat & Glo Gas Fireplaces Heat & Glo B-type vent gas fireplaces are designed to operate with all exhaust gases expelled to the outside of the building. The information contained in this Installers Guide , unless noted otherwise, applies to ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 8
8 Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 Figure 1. Diagram of the ST -42TVFL-IPI When planning a fireplace installation, it’s necessary to determine: • Where the unit is to be installed. • The vent system configuration to be used. • Gas supply piping. • Electrical wiring. • Framing and finishing details. • Whe ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 9
Figure 3. Fireplace Locations and Space Requirements Clearance Requirements The top, back, and sides of the fireplace are defined by stand-offs. Minimum Clearances from the Fireplace to Combustible Materials Glass Back of Metal Ends T op of Sides Floor Fireplace of Fireplace Fireplace Ceiling 36 inches 0 1/2 inch 1/2 inch 4-1/2 inches 36 inches (91 ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 10
Minimum Clearances from the B-T ype V ent Pipe to Combustible Materials is 1 inch (25 mm) all around the pipe. Step 2 Framing the Fireplace Fireplace framing can be built before or after the fireplace is set in place. Framing should be positioned to accommodate wall coverings and fireplace facing material. The diagram below shows framing reference ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 11
11 Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 Step 3 Negative Pressure Make-up Air Negative Pressure warning : When negative pressure is present, an atmospherically vented fireplace (with a draft hood) may not function properly and it may down draft. In the case of a gas appliance, spillage of the combustion gases may occur . T ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 12
Detailed inst allation instructions for Model AK-TV Outside Air kit are found in the kit. Air Damper Before lighting the burner , open the damper plate by sliding the air damper rod, located by the gas valve, towards you. Figure 5. Make-up Air DUCT COLLAR DAMP ER AS SEM BL Y Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 12 ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 13
13 Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 Step 4 Inst alling the V ent System A. V ent System Approvals These fireplaces are approved to use 6-inch (152mm) diameter B-type vent. B-type vent must be used when the vent system is within combustible construction. These models may also use single wall rigid or flexible gas vent ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 14
Figure 6. V ent System Att achment ! WARNING: THIS GAS FIREPLACE MUST NEVER BE VENTED BY CONNECTING TO A CHIMNEY FLUE SERVING A SEP ARA TE SOLID FUEL BURNING APPLIANCE. 4 FT . MINIMUM 17 FT . MAXIMUM MAXIMUM HORI ZON T AL RUN 4 FT MINIMUM 10 FT . MINIMUM Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 14 ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 15
15 Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 C. Bedroom Installation in Canada This model MUST NOT be vented into a vent system installed exterior to a building. The part of the vent system above the roof line can be exterior to the building. D. V ent T ermination WARNING: MAJOR U.S. BUILDING CODES SPECIFY MINIMUM CHIMNEY AND/ ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 16
The diagram below shows how to properly position, level, and secure the fireplace. 1. Place the fireplace into position. 2. Level the fireplace from side to side and from front to back. 3. Shim the fireplace with non-combustible material, such as sheet metal, as necessary . 4. Secure the fireplace to the framing by nailing or screwing. Figure 8. Pr ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 17
17 Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 Step 7 The Gas Supply Line N O T E : Have the gas supply line installed i n accordance with local building codes b y a qualified installer approved and/or licensed as required by the locality . (In the Commonwealth of Massachusetts installation must be performed by a licensed plumbe ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 18
• At the gas line access hole, use insulation to re- pack the space around the gas pipe. • Insert insulation from the outside of the fireplace and pack the insulation tightly to totally seal between the pipe and the outer casing. The gas line should be installed by a qualified service technician. Figure 9. Gas Supply Line Step 8 Gas Pressure Re ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 19
19 Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 ! ! Step 9 Wiring the Fireplace NOTE: Electrical wiring must be installed by a licensed electrician. Caution: Disconnect remote controls if you are absent for extended time periods. This will prevent accidental fireplace operation. Appliance Requirements • This appliance DOES NOT ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 20
Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 Figure 10. Intermittent Pilot Ignition (IPI) Wiring Diagram For Intermittent Pilot Ignition (IPI) Wiring Appliance Requirements This appliance requires that 1 10-120 V AC be wired to the junction box. Maintain correct polarity when wiring the junction box. Operation using Battery Power ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 21
Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 If the box is being wired to a wall mounted sw i tch for use with a fan (See Figure 1 1): • The power supply for the appliance must be brought into a switch box. • The power can then be supplied from the switch box to the appliance using a minimum of 14-3 with ground wire. • At t ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 22
22 Heat & Glo • ST -42TVFL-IPI • 455-902 Rev . C • 12/07 ! Step 10 Finishing The following diagram shows the minimum vertical and corresponding maximum horizontal dimensions of fireplace mantels or other combustible projections above the top front edge of the fireplace. See Figures 1, 2 and 3 for other fireplace clearances. Only non- comb ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 23
S tep 1 1 Inst alling T rim, Logs, and Ember Material Figure 13. Sealant Material Hearth Extensions A hearth extension may be desirable for aesthetic reasons. However , ANSI or CAN/CGA testing standards do not require hearth extensions for gas fireplace appliances. Inst alling the T rim Combustible materials may be brought up to the specified clear ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 24
Figure 14. Placement of the Ember Material Placing the Ember Material Ember material is shipped with this gas fireplace. The bag labeled Golden Ember (GE-93) is flame colorant material. The bag labeled Glowing Ember (050-721) is standard glowing ember material. T o place the ember material: • Remove wing nuts and glass clips or tension springs ar ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 25
Step 12 Before Lighting the Fireplace Before lighting the fireplace, be sure to do the following: Remove all paperwork and documents from underneath the fireplace. Review safety warnings and cautions • Read the Safety and W arning Information sec- tion at the beginning of this Installers Guide . Double-check for gas leaks • Before lighting the ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 26
4 Maint aining and Servicing Y our Fireplace T ype of Fireplace Maintenance T ask T o Maintenance Frequency B y Be Completed Replacing Once annually , Qualified Brush away loose ember material near Old Ember during the Service the burner . Replace old ember Material annual check-up T echnician material with new dime-size and -shape pieces of Golden ...
-
Heat & Glo LifeStyle ST-42TVFL-IPI - page 27
Heat & Glo, a brand of Hearth & Home T echnologies Inc. 20802 Kensington Boulevard, Lakeville, MN 55044 www .heatnglo.com Contact Information Please contact your Heat & Glo dealer with any questions or concerns. For the location of your nearest Heat & Glo dealer , please visit www .heatnglo.com. - NOTES - ___________________________ ...
Avez-vous une question à propos de Heat & Glo LifeStyle ST-42TVFL-IPI?
Utiliser le formulaire ci-dessous
Si vous n’avez pas résolu votre problème avec Heat & Glo LifeStyle ST-42TVFL-IPI, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Heat & Glo LifeStyle ST-42TVFL-IPI il est probable qu’il a envie de partager la façon de le résoudre.