Manuel d’utilisation Windsor 10066350

24 pages 1.06 mb
Télécharger

Aller à la page of 24

Summary
  • Windsor 10066350 - page 1

    86221970 PRV NO 980282 H AUTOMATIC SCRUBBER MODELS: SCC172 QSCC172 SCH172 10066320 10066300 10066350 SCHC172 HCC172 QSCC172IA 10066330 10066270 10066310 QSCC172IS AS17 AS17B 10066080 10066210 10066220 AS17T AS17TH AS17E 10066250 10066260 10066230 AS17I QSC172 10066240 10052700 Read these instructions before using the machine IPX4 ...

  • Windsor 10066350 - page 2

    MACHINE DATA LOG/OVERVIEW 86221970 17” SCRUBBER 01/03/07 2 OVERVIEW The Automatic Scrubber is a battery powered, hard floor scrubber intended for commercial use. The appliance applies a cleaning solution o nto a hard floor, scrubs the floor with a brush or pad, and then vacuums the soiled water back into the recovery tank. YOUR DEALER Name: _____ ...

  • Windsor 10066350 - page 3

    TABLE OF CONTENTS 86221970 17” SCRUBBER 01/03/07 3 Machine Data Log/ Overview . ............................... 2 Table of Co ntents ................................................. 3 HOW TO USE THIS MANUAL How to use this Manual. ....................................... 1-1 SAFETY Important Safety Instructions ............................... 2-1 ...

  • Windsor 10066350 - page 4

    HOW TO USE THIS MANUAL 86221970 17” SCRUBBER 01/03/07 1-1 This manual contains the f ollowin g sections: - HOW TO USE THIS MANUAL - SAFETY - OPERATIONS - MAINTENANCE - PARTS LIST The HOW TO USE THIS MANUAL section will tell you how to find important information for ordering correct repair parts. Parts may be ordered from authori zed Windsor deale ...

  • Windsor 10066350 - page 5

    86221970 17” SCRUBBER 01/03/07 2-1 IMPORTANT SAFETY INSTRUCTIONS When using a battery powered appliance, basic precaution must always be followed, including the following: READ ALL INSTRUCTIONS BEFO RE USING THIS MACHINE. To reduce the risk of fire, electric sho ck, or injury : Use only indoors. Do not use outdoors or expose to rain. Use only as ...

  • Windsor 10066350 - page 6

    HAZARD INTENSITY LEVEL 86221970 17” SCRUBBER 01/03/07 2-2 The following symbols are used throughout this guide as indicated in the ir descriptions: HAZARD INTENSITY LEVEL There are three levels of hazard intensity identified by signal words - WARNING and CAUTION and FOR SAFETY. The level of hazard intensity is determined by the following definiti ...

  • Windsor 10066350 - page 7

    SAFETY LABEL LOCATION 86221970 17” SCRUBBER 01/24/07 2-3 NOTE: These drawings indicate the location of safet y labels on the machine . If at any time the labels become illegible, promptly replace them. OR FIRE. DO NOT USE OR MATERIALS CA N CAUSE EXPLOSI ON FLAMMABLE MATERI AL. PICK UP FLAMMABLE SAFETY L ABEL 8 6252540 BATTER Y CA UTION 86252520 P ...

  • Windsor 10066350 - page 8

    TECHNICAL SPECIFICATIONS 86221970 17” SCRUBBER 01/03/07 3-1 ITEM DIMENSION/CAPACITY Rated Voltage 24 VDC Rated Amperage 30 Amps Batteries 2 x 12 Volt 105-130 AH Scrub Brush Motor 0.75hp (0.56 kw) Vacuum Motor 24 VDC 2 stage by pass Mass (GVW) 319 lbs (144.7 kg) Weight empty without batteries 142 lbs (64.4 kg) Solution Control Gravity feed, fully ...

  • Windsor 10066350 - page 9

    TECHNICAL SPECIFICATIONS 86221970 17” SCRUBBER 01/03/07 3-2 ITEM MEASURE Height 35 in (0.89 m) Length 42 in (1.07 m) Width without squeege e 20 in (0.51 m) Width of squeegee 31 in (0.79 m) Width of scrub path 17 in (0.43 m) SPECIAL NOTES: The A-weighted sound pressure level em itted by the appliance was measu red t o be 74.1 dBA. This is a space- ...

  • Windsor 10066350 - page 10

    HOW THIS MACHINE WORKS 86221970 17” SCRUBBER 01/03/07 3-3 This Automatic Scrubber is a battery powered, hard floor scrubber intended for commercial use. The appliance applies a clea ning solution onto a hard floor, scrubs the floor with a bru sh, and t hen vacuums the soiled water back into the recovery tank. The machine's primary sy stems a ...

  • Windsor 10066350 - page 11

    COMPONENTS 86221970 17” SCRUBBER 01/03/07 3-4 14 13 12 11 10 9 8 7 6 5 4 3 2 1 1. Control Panel 2. Control Handle 3. Recovery Tank 4. Recovery Tank Drain Hose 5. Recovery Tank Domel 6. Scrub Brush/Pad 7. Solution Tank 8. Solution Tank Cover 9. Solution Tank Drain Hose 10. Solution Strainer 11. Solution Tank Support Lanyard 12. Squeegee 13. Vacuum ...

  • Windsor 10066350 - page 12

    CONTROLS 86221970 17” SCRUBBER 01/03/07 3-5 1. Solution Control Lev er 2. Brush Switch 3. Brush Lift Pedal 4. Vacuum Switch 5. Squeegee Lift Lever 6. Battery Charge Level Indicator 7. Hour Meter 8. Circuit Breaker 9. Brush Reverse Switch 1 2 3 4 5 6 7 8 9 ...

  • Windsor 10066350 - page 13

    CONTROLS 86221970 17” SCRUBBER 01/03/07 3-6 1. SOLUTION CONTROL LEVER Controls solution flow to scrub deck. To increase flow push the kno b forward to the desired flow. To decrease flow pull the knob back. 2. BRUSH SWITCH Controls the scrub brush motor. To turn scrub brush on, press the top of the switch. To turn scrub brush off, press the bottom ...

  • Windsor 10066350 - page 14

    MACHINE OPERATIONS 86221970 17” SCRUBBER 01/03/07 3-7 PRE-RUN MACH IN E INSPECTION Do a pre-run inspection to find possi ble problems that could cause poor perf ormance or lost time from breakdown. Follow the same pro cedure each time to avoid missing steps. NOTE: See maintenance section for pre-run machine inspection che cklist items. FILLING SO ...

  • Windsor 10066350 - page 15

    MACHINE OPERATION 86221970 17” SCRUBBER 01/03/07 3-8 TO BEGIN SCRUBBING When operating the machine around people, pay close attention for unexpecte d movement. Use extra caution around children. Flammable liquids and/or reactive metals can cause explosions or fire! Do not pick up. 1. Lower the squeegee. 2. Turn the vacuum on. 3. Lower the scrub b ...

  • Windsor 10066350 - page 16

    MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-1 BATTERIES (WET CELL BATTERIES ONLY) The batteries provide the power to ope rate the machine. The batteries require regul ar maintenance to keep them operating at peak efficiency. The machine batteries will hold their charge for long periods of time, but they can only be charged a certain number of ti ...

  • Windsor 10066350 - page 17

    MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-2 CHECKING BAT TERY SPECIFIC GRAVITY Use a hydrometer to chec k the battery specific gravity. CHECKING GRAVITY A. Hydrometer B. Battery NOTE: Do not take readings immediately after adding distilled water, if the water and acid are not thoroughly mixed, the readi ng m ay not be accurate. Check the hydro ...

  • Windsor 10066350 - page 18

    MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-3 MACHINES WITHOUT ON BOARD CHARGER Use a 24 volt, 12 amp maximum output, DC charger which will automatically shut off when the batteries are fully charged to charge the two battery pack. 1. Stop the machine in a clean, well ventilated area next to the charger. 2. Turn the machine off. FOR SAFETY: Befo ...

  • Windsor 10066350 - page 19

    MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-4 SCRUB BRUSHES NOTE: All original equipment brushes a re equi pped with “Perform Alert © ”. This feature will tell the operator when it is time to replace the scrub brush. “Perform Alert © ” brush es have pre-trimm ed bright yellow tufts to indicate the length of a worn out brush. When the t ...

  • Windsor 10066350 - page 20

    MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-5 REPLACING OR REMOVING SCRUB BRUSHES 1. Turn the machine off. FOR SAFETY: Before leavi ng or serv icing the machine; stop on level surfac e, turn OFF machine. 2. Raise the scrub deck up by pushin g down on the pedal. 3. Locate the brush reverse switch on the rear of the panel. Press to activate the mo ...

  • Windsor 10066350 - page 21

    MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-6 SERVICE SCHEDULE MAINTENANCE DAILY WEEKLY MONTHLY ANNUALLY Check battery acid level * Check vac hose connections * Clean the squeegee blades * Inspect brush or pad for debris: wire string, wear * Inspect float ball screen * Drain & rinse tanks * Raise squeegee assembly * Raise scrub deck assembly ...

  • Windsor 10066350 - page 22

    TROUBLESHOOTING 86221970 17” SCRUBBER 01/03/07 4-7 PROBLEM CAUSE SOLUTION Poor or no water pick-up Debris caught on sque egee Remove debris Worn squeegee blades Repl ace squeegee blade s Vacuum hose clogged Clear obstruction from hose Vacuum hose disconnecte d from squeegee or recove ry tank Reconnec t vacuum hose Vacuum hose damaged Replace vacu ...

  • Windsor 10066350 - page 23

    TROUBLESHOOTING 86221970 17” SCRUBBE R 01/03/07 4-8 PROBLEM CAUSE SOLUTION Little or no solution flow to the floor Solution tank empty Fill solution tank Solution flow turned off or set too low Turn on or increase flow setting Solution strainer plugged Clean solution strainer Solution hoses obstructed Clear obstruction from hose Solution solenoid ...

  • Windsor 10066350 - page 24

    NOTES: 86221970 17” SCRUBBER 01/03/07 4-9 ...

Fabricant Windsor Catégorie Vacuum Cleaner

Les documents que nous recevons du fabricant de l'appareilWindsor 10066350 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Windsor
- manuels d’utilisations 10066350
- fiches produit Windsor
- dépliants
- ou étiquettes-énergie Windsor 10066350
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Windsor 10066350.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Windsor 10066350, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Windsor 10066350. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Windsor 10066350.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Windsor 10066350, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Windsor 10066350 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Windsor 10066350.

Le manuel d’utilisation complet Windsor, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Windsor 10066350 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Windsor 10066350, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lWindsor 10066350 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Windsor 10066350 - qui devraient nous aider dans les premières étapes lors de l'utilisation Windsor 10066350
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Windsor 10066350
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Windsor 10066350 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Windsor 10066350?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Windsor 10066350, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Windsor 10066350 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)