-
Auto Page RF-302 - page 1
RF - 302 OPERATION INSTRUCTIONS ...
-
Auto Page RF-302 - page 2
Congratulations on your purchase of the RF - 302 vehicle security system. AutoPage, Inc. is one of the companies with the longest history and experience in vehicle security in the United States and a wh olly owned subsidiary of Iwata Electric Co., of Tokyo, Japan. Iwata has been an industry leader for 40 years, establishing a reputation for ingenui ...
-
Auto Page RF-302 - page 3
RF - 302 1 RF - 302 OPERATION I NSTRUCTIONS A. REMOTE CONTROL TRANSMITTER OPERATION 1. ARM/DISARM TO ARM THE RF - 302 Press the ON/OFF button once to arm. The siren will chirp one (1) time, the lights will flash, and all doors will lock. (*) TO DISARM THE RF - 302 Press the ON/OFF button once to disarm. The siren will chirp two (2) times, the light ...
-
Auto Page RF-302 - page 4
RF - 302 2 3. PANIC FUNCTION The RF - 302 remote control may be used as a remote panic switch to trigger the siren in cases of emergency. To activate the PANIC FUNCTION press and hold the ON/OFF button on the remote transmitter for a minimum of 3 seconds. The siren will sound. To stop the PANIC FUNCTION press the ON/OFF button on the transmitter. 4 ...
-
Auto Page RF-302 - page 5
RF - 302 3 To replace the battery, carefully remove the case screw located at the end of the remote where the key ring attaches to the case. Use a small blade Phillips screwdriver. Before removing the battery note the direction of its terminals. Install the new battery exactly the same, using caution so as not to bend, or otherwise damage the batte ...
-
Auto Page RF-302 - page 6
RF - 302 4 NOTE : Both VALET and OVERRIDE functions are performed from the same switch. 1. OVERRIDE FUNCTION The OVERRIDE FUNCTION may be used if the RF - 302 remote is lost or inoperative. To operate the OVERRIDE FUNCTION, enter the vehicle (siren will sound); switch the vehicle ignition to ON. Move the VALET/OVERRIDE switch to ON; then OFF; the s ...
-
Auto Page RF-302 - page 7
RF - 302 5 1. PASSIVE ARMING If you choose the PASSIVE (automatic) mode, the system must be operated as below. 1. Switch OFF vehicle ignition, exit vehicle, and be sure all protected openings are closed. 2. The LED STATUS INDICATOR will begin fast flashing and the passive arming timer will begin counting down. 3. If you re - open the exit the LED w ...
-
Auto Page RF-302 - page 8
RF - 302 6 Approach the vehicle and press the ON/OFF remote transmitter button. The siren will chirp 2 times and the lights will flash to indicate the RF - 302 is disarmed. G. AUTOMATIC RE - ARMING The RF - 302 is equipped with an automatic re - arming circuit that will return the alarm to a fully armed state if a door is not opened within 60 secon ...
-
Auto Page RF-302 - page 9
RF - 302 7 1. Open any door or other protected opening. The siren will sound instantly, and the lights will flash. 2. If optional sensors have been installed, arm the RF - 302 and test according to the directions of the particular sensor installed. If triggered in the armed condition, the RF - 302 will sound its siren and flash the lights for 60 se ...
-
Auto Page RF-302 - page 10
RF - 302 8 4. Turn the ignition switch "ON/OFF", "ON/OFF". The siren w ill chirp one (1) time. You are now in the programming mode. 5. Press the ON/OFF button on one of the remote transmitters until the alarm siren responds with a confirming chirp. The first transmitter is now programmed. 6. Within five (5) seconds , press the O ...
-
Auto Page RF-302 - page 11
RF - 302 9 Enter the programming mode on vehicle #1 and push the ON/OFF button on the transmitter for Ve hicle #1. The alarm siren will respond with a confirming chirp. Within five (5) seconds , push the AUX. button on the transmitter for Vehicle #2. The alarm siren will respond with a confirming chirp. Both transmitters are now programmed to Vehic ...
-
Auto Page RF-302 - page 12
RF - 302 10 AUX. BUTTON ON/OFF BUTTON BOTH BUTTONS TRANSMITTER #3 AUX. BUTTON BOTH BUTTONS ON/OFF BUTTON BOTH BUTTONS AUX. BUTTON ON/OFF BUTTON ...
-
Auto Page RF-302 - page 13
RF - 302 11 AUTOPAGE ALARM ACCESSORIES AP - 4000DX Paging System Vehicle s ecurity paging was originated by AutoPage over 18 years ago. The AP4000DX is our latest version providing a full four watts of output power to signal a handsome belt - clip paging receiver indicating your RF - 302 has been triggered, even if you cannot hear the siren. RS - 3 ...
-
Auto Page RF-302 - page 14
RF - 302 12 sensors, the SIS - 10 has a LED and potentiometer for easy sensitivity adjustment. MSEN - KIT The MSEN - KIT includes two pre - wired Micro Resonance Sensors and a special triggering amplifier. These special sensors are designed to be mounted within the vehicle door or on the door post near the latching mechanism that keeps the door clo ...
-
Auto Page RF-302 - page 15
12 LIMITED LIFETIME WARRANTY PROVISIONS (U.S. and Continental U.S. Only) 1. AutoPage, Inc. WARRANTS that this new unit has been thoroughly inspected and tested at the factory prior to delivery. Your AutoPage equipment is guaranteed for "life" to the origin al purchaser/user of the equipment under the following conditions: If the product p ...
-
Auto Page RF-302 - page 16
RF - 302 13 LIMITED TO ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. 7 AutoPage shall not be liable, under the foregoing WARRANTIES or otherwise, for: Any p ersonal injury of any kind to the purchaser, its employees or agents or anyone else whomsoever resulting directly or indirectly from the use or presence of the equipment ...
-
Auto Page RF-302 - page 17
...
-
Auto Page RF-302 - page 18
This WARRANTY CARD is for your record. However, AutoPage reserves the right to request you to submit this WARRANTY CARD which must have complete information to receive warranty service. Please keep this card in a secured place. AUTOPAGE WAR RANTY SERVICE CARD Model RF - 302 Serial#______________________________ CUSTOMER TO COMPLETE DEALER TO COMPLE ...
-
Auto Page RF-302 - page 19
13 DATE SERVICE COMPLETED ...
-
Auto Page RF-302 - page 20
1815 W. 205th St. #101 Torrance, CA 90501 310 - 618 - 2002 ...
Avez-vous une question à propos de Auto Page RF-302?
Utiliser le formulaire ci-dessous
Si vous n’avez pas résolu votre problème avec Auto Page RF-302, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Auto Page RF-302 il est probable qu’il a envie de partager la façon de le résoudre.