Français dropdown-ico

Manuel d’utilisation Wayne-Dalton 7100 Series

22 pages 7.86 mb
Télécharger

Aller à la page of 22

Summary
  • Wayne-Dalton 7100 Series - page 1

    GARAGE DOORS & OPENERS Part No. IMPORT ANT NO TICES! Wayne-Dalton highly recommends that you read and fully under - stand the Installation Instructions and Owner’ s Manual before you attempt this installation. T o avoid possible injur y , read the enclosed instructions carefully before installing and operating the garage door . Pay close atte ...

  • Wayne-Dalton 7100 Series - page 2

    2 Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com A. TRACK ROLLERS (AS REQUIRED): A1. Short Stem T rack Rollers A2. Long Stem T rack Rollers A3. Sh ...

  • Wayne-Dalton 7100 Series - page 3

    I m p o r t a n t S a f e t y I n s t r u c t i o n s DEFINITION OF KEY WORDS USED IN THIS MANUAL: W ARNING W ARNING INDICA TES A POTENTIALL Y HAZARDOUS SITUA TION WHICH; IF NOT AVOIDED , COULD RESUL T IN SEVERE OR FA T AL INJURY . CAUTION: PROPER TY DAMAGE OR INJURY CAN RESUL T FROM FAILURE TO FOLLOW INSTRUCTIONS. IMPORT ANT : REQUIRED STEP FOR SA ...

  • Wayne-Dalton 7100 Series - page 4

    Cable drums RH/LH Torsion springs RH/LH Center bracket (as required) Center bracket bushing (as required) (2) End bearing brackets (as required) Track roller carriers (as required) End bearing brackets RH/LH (as required) Keys (as required) Hinges (as required) Bottom weather seal / 3/4” nails (as required) Cotter pin (as required) 5/16” x 1-1/ ...

  • Wayne-Dalton 7100 Series - page 5

    4 Section High Strutting Schedule Intermediate II N/A T op Of Section N/A Bottom Of section Intermediate I (1) Long T op Of Section N/A Bottom Of section Bottom (1) Long T op Of Section (1) Short Bottom Of section 1 1 2 Short strut Long strut Hinges are stamped for identification Center hinge(s) Upper hinge leaf Lower hinge leaf 2” Strut 3” St ...

  • Wayne-Dalton 7100 Series - page 6

    INST ALLA TION Before installing your door , be certain that you have read and followed all of the instruc- tions covered in the pre-installation section of this manual. Failure to do so may result in an improperly installed door . IMPORT ANT : WOOD DOORS MUST BE COMPLETEL Y FINISHED (3 TOT AL COATS, INCLUDING PRIMER COA T) PRIOR TO INST ALLA TION, ...

  • Wayne-Dalton 7100 Series - page 7

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com (B) Locate the left hand bottom corner bracket. Align the bottom corner bracket horizontally with t ...

  • Wayne-Dalton 7100 Series - page 8

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com 2” Long strut T ypical section shown. (4) 1/4” - 14 x 1” Lag screws (2) 1/4” - 20 x 2 1/4? ...

  • Wayne-Dalton 7100 Series - page 9

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com (3) 1/4” - 14 x 1” Lag screws T op fixture slide(s) Long stem track roller (B) Left hand top ? ...

  • Wayne-Dalton 7100 Series - page 10

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com DEEP . IMPORT ANT : PUSH & HOLD THE HINGE LEAFS SECUREL Y AGAINST THE SECTIONS WHILE SECURING W ...

  • Wayne-Dalton 7100 Series - page 11

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com 3/8”-16 Hex nut Horizontal track angle 3/8”-16 x 3/4” T russ head bolt Horizontal track Flag ...

  • Wayne-Dalton 7100 Series - page 12

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Center bearing bracket Vertical line Mounting surface Horizontal line Center of end bearing bracket ...

  • Wayne-Dalton 7100 Series - page 13

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com T orsion keyed shaft Center bearing Red cable drum (left hand side) Black cable drum (right hand si ...

  • Wayne-Dalton 7100 Series - page 14

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Left cable drum Counterbalance lift cable Locking pliers Set screws Jamb Left end bearing bracket T ...

  • Wayne-Dalton 7100 Series - page 15

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com tension until door rests on the floor . If the door is hard to raise or drifts down on its own, ad ...

  • Wayne-Dalton 7100 Series - page 16

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com WARNING WARNING Lift handles/gripping points are required on this door, located as spelled out in t ...

  • Wayne-Dalton 7100 Series - page 17

    Door Arm Hookup T ools: Needle nose pliers At the center of the top section, measure horizontally from the top of center hinge to the bottom of strut. Using that dimension, measure and cut (2) pieces of perforated angles. Assemble the (2) pieces together using (2) 3/8” bolts and nuts (supplied by others). Now, secure to the top section using carr ...

  • Wayne-Dalton 7100 Series - page 18

    Cleaning Y our Garage Door IMPORT ANT : DO NOT USE A PRESSURE W ASHER ON YOUR GARAGE DOOR! An annual inspection of all the surfaces of your garage door(s) will reveal the extent of weather - ing and the possible need for refinishing. When the finish becomes eroded or thin, clean and prime any areas showing deterioration. Then completely refinish ...

  • Wayne-Dalton 7100 Series - page 19

    3. Lubrication: The door should open and close smoothly. Ensure the door track rollers are rotating freely when opening and closing the door . If track rollers do not rotate freely, clean the door tracks, removing dirt and any foreign substances. Clean and lubricate (use a non-silicon based lubricant) graduated end hinges, steel track rollers, spri ...

  • Wayne-Dalton 7100 Series - page 20

    Limited warranty Model 7100 Series Subject to the terms and conditions contained in this Limited Warranty , Wayne-Dalton (“Manufacturer”) warrants the sections of the door , against defects in material and workmanship, for a period of ONE (1) YEAR from the time of delivery provided: i) (i) The interior and exterior surfaces, as well as all edge ...

  • Wayne-Dalton 7100 Series - page 21

    ...

  • Wayne-Dalton 7100 Series - page 22

    AFTER INST ALLA TION IS COMPLETE, F ASTEN THIS MANUAL NEAR THE GARAGE DOOR. Please Do Not Return This Product T o The Store Thank you for your pur chase. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pa ges business listings or go to the Find a Dealer section online at www .Wayne-Dalt ...

Fabricant Wayne-Dalton Catégorie Garage Door Opener

Les documents que nous recevons du fabricant de l'appareilWayne-Dalton 7100 Series peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Wayne-Dalton
- manuels d’utilisations 7100 Series
- fiches produit Wayne-Dalton
- dépliants
- ou étiquettes-énergie Wayne-Dalton 7100 Series
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Wayne-Dalton 7100 Series.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Wayne-Dalton 7100 Series, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Wayne-Dalton 7100 Series. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Wayne-Dalton 7100 Series.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Wayne-Dalton 7100 Series, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Wayne-Dalton 7100 Series par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Wayne-Dalton 7100 Series.

Le manuel d’utilisation complet Wayne-Dalton, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Wayne-Dalton 7100 Series - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Wayne-Dalton 7100 Series, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lWayne-Dalton 7100 Series qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Wayne-Dalton 7100 Series - qui devraient nous aider dans les premières étapes lors de l'utilisation Wayne-Dalton 7100 Series
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Wayne-Dalton 7100 Series
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Wayne-Dalton 7100 Series dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Wayne-Dalton 7100 Series?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Wayne-Dalton 7100 Series, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Wayne-Dalton 7100 Series il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Captcha
Nouvelle image

Commentaires (0)