Manuale per l’uso Cobra Electronics 148.GTL.ST

15 pagine 0.4 mb
Scarica

Vai alla pagina of 15

Summary
  • Cobra Electronics 148.GTL.ST - page 1

    PRINTED IN THAILAND ©COBRA ELECTRONICS CORPORATION 1997 480-241-P-001 Cobra Electronics Corporation 6500 W . Cortland Street Chicago, IL 60707 OPERATING INSTRUCTIONS FOR Y OUR 40 CHANNEL CITIZENS BAND SSB/AM 2-W A Y MOBILE RADIO Model 148 GTL ST 148.GTL.ST.MANUAL 10/1/98 10:56 AM Page 1 ...

  • Cobra Electronics 148.GTL.ST - page 2

    40-CHANNEL, CITIZENS BAND SSB/AM 2-W A Y MOBILE RADIO Model 148 GTL ST Contents P age The CB/SoundT r acker Story .............................................................. 1 Section I: Introduction...................................................................... 2 Section II: Specifications ................................................ ...

  • Cobra Electronics 148.GTL.ST - page 3

    Section I Introduction FREQUENCY RANGE T he COBRA 148 GTL ST transcei v er represents one of the most ad v anced SSB/AM two-w a y radios ever designed for use as a Class D station in the Citizens Radio Service. This unit features ad vanced Phase Lock Loop (PLL) circuitry, which is used in the AM mode and in the upper and lower single sideband modes ...

  • Cobra Electronics 148.GTL.ST - page 4

    Section II Specifications (Cont.) 4 RECEIVER Sensitivity SSB: 0.25 µ V for 10dB (S+N)/N at greater than 1/2-watt of audio output. AM: 0.5 µ V for 10 dB (S+N)/ at greater than 1/2-watt of audio output. Selectivity AM: 6dB @ 3 KHz, 50 dB @ 9 KHz. SSB: 6 dB @ 1.1 KHz, 60 dB @ 2.3 KHz. Image Rejection More than 65 dB . IF Frequency AM: 7.8 MHz 1st IF ...

  • Cobra Electronics 148.GTL.ST - page 5

    6 Section III Installation IGNITION NOISE INTERFERENCE Use of a mobile recei v er at low signal levels is normally limited by the presence of electrical noise. T he primary source of noise in automobile installations is from the generator and ignition system in the vehicle. Under most operating conditions, w hen signal level is adequate, the backgr ...

  • Cobra Electronics 148.GTL.ST - page 6

    Section III Installation (Continued) D. T ry a different location on your car (keeping in mind the radiation pattern you wish). E. Is the antenna perfectly vertical? F . T ry a different location in your neighborhood. Stay a w ay from large metal objects when adjusting (metal telephone or light posts, fences, etc.). NOTE T he COBRA 148 GTL ST will ...

  • Cobra Electronics 148.GTL.ST - page 7

    Section IV Operation (Continued) 4. SWR CAL CONTROL (outer concentric dial) . In order for you to achiev e maximum radiated power and the longest range, it is important that your antenna be in good condition, properly adjusted and matched to your trans- ceiver . The Built-in SWR (standing w a v e ratio) meter lets you easily measure your antenna co ...

  • Cobra Electronics 148.GTL.ST - page 8

    12 Section IV Operation (Continued) B. INDICA TOR FUNCTIONS 15. S-METER. Swings proportionally to the strength of the incoming signal. 16. RF METER . Swings proportionally to the RF output power . 17. SWR METER . Sw i ng s p r o po r t io n a l ly to t he r a ti o o f s t an d i n g w a ve v o l ta ge a nd RF ou tpu t . U s ed t o p r op e r l y ad ...

  • Cobra Electronics 148.GTL.ST - page 9

    14 Section IV Operation (Continued) T hus when a voice is used in place of a whistle or tone, in the proper listening mode the voice will be recei v ed correctly whereas in the incorrect mode, the v oice will be translated backwards and cannot be made intelligible by the voice lock control. When listening to an AM transmission, a correct sideband i ...

  • Cobra Electronics 148.GTL.ST - page 10

    16 3 4 2 1 Section IV Operation (Continued) Fig. 2. Microphone Cable Preparation T o wire the microphone cable to the plug provided, proceed as follows. Fig. 3 . Microphone plug wiring. 1. Remove the retaining screw. 2. Unscrew the housing from the pin receptacle bod y . 3. Loosen the two cable clamp retainer screws. 4. F eed the microphone cable t ...

  • Cobra Electronics 148.GTL.ST - page 11

    18 Section V Maintenance and Adjustment T he COBRA 148 GTL ST transcei v er is specifically designed for the environment encountered in mobile installations. T he use of all solid state circuitry and its light weight result in high reliability. Should a failure occur, however, replace parts only with identical parts. Do not substitute. Refer to the ...

  • Cobra Electronics 148.GTL.ST - page 12

    Activ ating/Testing SoundT r acker ACTIV A TING SOUNDTRACKER 1. Press the SoundTracker button on the right side of front panel. TESTING SOUNDTRACKER 1. Select any unused channel on your CB . 2. Open the squelch fully by turning the knob counter-clockwise until it stops. 3. T urn the volume up louder than your nor- mal listening level. 4. Switch the ...

  • Cobra Electronics 148.GTL.ST - page 13

    22 Section VI Appendix (Continued) A FEW RULES THAT SHOULD BE OBEYED 1. Y ou are not allowed to carry on a con v ersation with another station for more than fiv e minutes at a time without taking a one-minute break, to gi v e others a chance to use the channel. 2. Y ou are not allowed to blast others off the air by o ver-powering them with illegall ...

  • Cobra Electronics 148.GTL.ST - page 14

    If Y ou T hink Y ou Need Service If Y ou T hink Y ou Need Service, Call 773-889-3087 Y ou m a y be aske d to send you r uni t to the Cobr a f actor y . It will b e neces sar y to fur nis h th e follo wi ng, in or der to ha ve the pr oduc t ser vic ed and r e t u r n e d . 1 . Fo r W a r r anty R epair , include s ome form of pr o o f - o f - p u r ...

  • Cobra Electronics 148.GTL.ST - page 15

    Description Part No. Cost Ea. X Qty. = Amount Replacement microphone with 4-pin connector for 148 GTL ST CA-73 $19.95 MOBILE POWER MICROPHONE Amplified Power Microphone with 4-pin connector for 148 GTL ST CA-75 $19.95 NOISE CANCEL MICROPHONE for 148 GTL ST CA-77 $39.95 ECHO POWER MICROPHONE or 148 GTL ST CA-79 $69.95 High Performance, Magnetic Moun ...

Fabbricante Cobra Electronics Categoria Two-Way Radio

I documenti che otteniamo dal fabbricante del dispositivoCobra Electronics 148.GTL.ST possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Cobra Electronics
- manuali per l’uso 148.GTL.ST
- schede prodotto Cobra Electronics
- opuscoli
- o etichette energetiche Cobra Electronics 148.GTL.ST
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Cobra Electronics 148.GTL.ST.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Cobra Electronics 148.GTL.ST, manuali di manutenzione, brevi manuali o manuali utente Cobra Electronics 148.GTL.ST. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Cobra Electronics 148.GTL.ST.

Manuale completo del dispositivo Cobra Electronics 148.GTL.ST, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Cobra Electronics 148.GTL.ST dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Cobra Electronics 148.GTL.ST.

Il manuale per l’uso completo Cobra Electronics, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Cobra Electronics 148.GTL.ST - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Cobra Electronics 148.GTL.ST, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Cobra Electronics 148.GTL.ST che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Cobra Electronics 148.GTL.ST - che ci dovrebbe aiutare nei primi passi durante l'uso Cobra Electronics 148.GTL.ST
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Cobra Electronics 148.GTL.ST
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Cobra Electronics 148.GTL.ST in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Cobra Electronics 148.GTL.ST?

Utilizza il modulo sottostante

Se non hai risolto il problema con Cobra Electronics 148.GTL.ST con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Cobra Electronics 148.GTL.ST è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Commenti (0)