-
Onkyo ED-205 - page 1
A V Surr ound Pr ocessor ED-205 AV SURROUND PROCESSOR STANDBY/ON STANDBY EFFECT MODE MASTER VOLUME MULTI CH INPUT LINE VIDEO-1/2 ED-205 POWER OFF ON Instruction Manual Thank you for purchasing the ONKYO AV Surround Processor. Please read this manual thoroughly before making connections and turning on the power. Following the instructions in this ma ...
-
Onkyo ED-205 - page 2
2 1. Read Instructions – All the safety and operating instructions should be read before the appliance is operated. 2. Retain Instructions – The safety and operating instructions should be retained for future reference. 3. Heed Warnings – All warnings on the appliance and in the operating instructions should be adhered to. 4. Follow Instructi ...
-
Onkyo ED-205 - page 3
3 1. Warranty Claim You can find the serial number on the rear panel of this unit. In case of warranty claim, please report this number. 2. Recording Copyright Recording of copyrighted material for other than personal use is illegal without permission of the copyright holder. 3. AC Fuse The fuse is located inside the chassis and is not user-service ...
-
Onkyo ED-205 - page 4
4 Supplied accessories Check that the following accessories are supplied with your ED-205. Features ■ Compact, high-quality component design ■ Dolby * Pro Logic decoder with 3 surround modes (Hall, Live, and Arena) and Stereo mode ■ Superb expandability with 5.1-channel input ■ Flexible connectivity with Separate Collection Series component ...
-
Onkyo ED-205 - page 5
5 Bef ore operating this unit Installing the remote controller batteries 1 Remove the battery compartment cover by pressing the tab and lifting up the cover. 2 Insert two AA (R6- or UM-3)-size batteries into the battery compartment. Carefully follow the polarity diagram (positive (+) and negative (-) symbols) inside the battery compartment. 3 After ...
-
Onkyo ED-205 - page 6
6 6 IN VIDEO-1 MONITOR OUT OUT IN VIDEO-2 IN VIDEO-1 IN OUT PROCESSOR FRONT SURROUND OUT IN VIDEO-2 SUB- WOOFER R L SURROUND CENTER REMOTE CONTROL SUB WOOFER PRE OUT CENTER R L S VIDEO VIDEO SPEAKERS MULTI CHANNEL INPUT OUT IN VIDEO-2 IN VIDEO-1 MONITOR OUT CAUTION: SPEAKER IMPEDANCE 6 OHMS MIN. /SPEAKER 1 Connecting the amplifier Connect the ampli ...
-
Onkyo ED-205 - page 7
7 7 Connecting equipment with 5.1-channel audio output (such as a DVD player) Connect the equipment's 5.1-channel output jacks to the ED-205's MULTI CHANNEL INPUT jacks. The equipment's 2-channel audio output jacks should be connected to the amplifier such as A-905 's LINE-1 jacks. The equipment's Video output jack should b ...
-
Onkyo ED-205 - page 8
8 8 15mm Connecting the speaker cables 1 Peel the insulation off the ends of the speaker cable 15 mm. Do not cut core wires. 2 Twist the core wires. 3 Press the lever below the speaker terminal to open the connection hole. 4 Insert the core wires into connection hole. 5 Return the lever to the original position.Make sure that the core wires are bar ...
-
Onkyo ED-205 - page 9
9 9 Speaker placement and connection 1 Connecting the Center speaker 2 Connecting the Surround speakers 3 Connecting the Subwoofer Connect your subwoofer to the ED-205's SUBWOOFER PRE OUT jack via an audio connection cable. • From the SUBWOOFER PRE OUT jack, a monaural signal that is a mixture of the Left and Right channel signals is output. ...
-
Onkyo ED-205 - page 10
10 10 AV SURROUND PROCESSOR STANDBY/ON STANDBY EFFECT MODE MASTER VOLUME MULTI CH INPUT LINE VIDEO-1/2 ED-205 POWER OFF ON AV SURROUND PROCESSOR STANDBY/ON STANDBY EFFECT MODE MASTER VOLUME MULTI CH INPUT POWER LINE VIDEO-1/2 ED-205 OFF ON If your system is totally configured with ONKYO separate collection series components, you can use the system ...
-
Onkyo ED-205 - page 11
11 11 1 Amplifier operation buttons Point the remote controller toward the amplifier’s remote control sensor. POWER : Turns the power on or off. SLEEP : Sets the time (in units of10 minutes) until the power is automatically shut off. Setting range: 90 to 10 minutes LINE-1 : Selects the component connected to the amplifier's LINE-1 jack. LINE ...
-
Onkyo ED-205 - page 12
12 Using the Surround Modes This unit provides a variety of surround effects, enabling you to enjoy the feeling of a movie theater, concert hall, or studio in your room. To get optimized surround sounds, your speaker system plays an important role. For how to connect and setup speakers, see pages 8 and 9. • DOLBY PRO LOGIC Surround Use this mode ...
-
Onkyo ED-205 - page 13
13 L1 - L2 Recommended delay time Below 1 m 15 ms 1 to 2.5 m 20 ms 2.5 to 4 m 25 ms Over 4 m 30 ms Note: 1 ms = 1/1000 second (one millisecond) 5. Press the CENTER MODE button on the remote controller to select “NORMAL” or “PHANTOM”. NORMAL: Select this mode if your system includes the Center speaker. PHANTOM: Select this mode if your syste ...
-
Onkyo ED-205 - page 14
14 Pla ying a sour ce If you wish to adjust the sound volume of the Right or Left front speaker, always use the ED-205's MASTER VOLUME knob with the amplifier's volume control at the Surround setting position as explained on pages 12 and 13. The output levels of the Center an d Surround speakers must be readjusted every time you alter the ...
-
Onkyo ED-205 - page 15
15 Playing in the Stereo mode 1. Same as step 1. of “Playing a Dolby Pro Logic surround source”. 2. Same as step 2. of “Playing a Dolby Pro Logic surround source”. 3. Press the EFFECT button to select “STEREO”. 4. Play a source. 5. Adjust the sound volume. The sound volume for all speakers simultaneously changes. Adjust the sound volume ...
-
Onkyo ED-205 - page 16
16 Playing a multi-channel input source The following describes how to play a multi-channel input source. A multi channel input source refers to equipment with 5.1-channel output jacks (such as a DVD player). When connected to the ED-205, the equipment outputs separate signals to the 5 speaker channels (Left/Right front, Center, and Left/ Right Sur ...
-
Onkyo ED-205 - page 17
17 Power Speaker Others Remote controller Symptom The unit does not turn on. No image or sound. No sound from front speakers. No sound or quiet sound from Center speaker. No sound or quiet sound from Surround speakers. No image on the TV connected to the S VIDEO MONITOR OUT jack. No test tone sound. No image in Multi-channel input mode. Buttons on ...
-
Onkyo ED-205 - page 18
18 Display 1 INPUT SELECTOR indicator 2 SURROUND MODE indicator 3 CENTER MODE indicator 4 MUTING indicator 5 Speaker output level indicator 6 Multi-function display Contr ol positions and names In this section, the name of each switch or button that appears in the description of this manual is indicated. The function or description of the switch or ...
-
Onkyo ED-205 - page 19
19 Remote controller When the unit is connected to Onkyo separate collection series components (amplifier, tuner, DVD player, MD recorder, cassette deck, and CD player), you can use the supplied remote controller to operate each component (see page 11). The buttons shown in shaded areas are those for operating components other than the ED-205. 1 PO ...
-
Onkyo ED-205 - page 20
Amplifier (Audio) section Power output Center : 22 W at 6 Ω 1kHz (DIN) Surround : 22+22 W at 6 Ω 1kHz (DIN) Center : 29 W at 6 Ω 1kHz (EIAJ) Surround : 29+29 W at 6 Ω 1kHz (EIAJ) Damping factor : 40 at 8 Ω Input sensitivity /Impedance VIDEO-1/2, PROCESSOR IN : 300 mV, 50 k Ω MULTI CHANNEL INPUT : 300 mV, 50 k Ω Output level /Impedance ...
Hai una domanda su Onkyo ED-205?
Utilizza il modulo sottostante
Se non hai risolto il problema con Onkyo ED-205 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Onkyo ED-205 è probabile che voglia condividere il modo di risolverlo.