-
Baumatic BT26 - page 1
...
-
Baumatic BT26 - page 2
1 User Manual for your Baumatic BT26SS Cooker Hood 60 cm Chimney Hood in Stainless Steel NOTE : This User Instruction Man ual contains imp ortant information, including safety & installation points, w hich will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available fo r future reference. ...
-
Baumatic BT26 - page 3
2 YOUR COOKER HOOD’S SPECIFICATIONS ….……………..………….3 IMPORTANT SAFETY INFO RMATION……………………………….…4-5 CARING FOR THE ENVI RONMENT…………………………………………6 USING YOUR COOKER HOOD………………………………..……………..7 SPECIAL FUNCTION S………………………? ...
-
Baumatic BT26 - page 4
3 Congratulations on purchasing a Baumatic Cooker Hood! To fully enjoy using your app liance long into the future, please firstly familiarise yours elf with its specifications, safety advice and operational in structions included in this manual. You will also need this manual to ensure that your Cooker Hood has been installed properly. DIMENSIONS W ...
-
Baumatic BT26 - page 5
4 o Any installation work must be carried out by a qualified electrician or competent person. o The hood must be installed in accordance with the installation instructions and all measurements followed. o If the cooker hood is installed for use above a gas appliance then the provision for ventilation must be in accordance with the Gas Safety Codes ...
-
Baumatic BT26 - page 6
5 o Ensure the ducting for the extractor function has the same diameter as the outlet hole all the way through. o Keep young children from using, playing with or tampering with the cooker hood. Older children and infirm persons should be supervised if they are using the cooker hood. o Your cooker hood is for domestic use only. o Please dispose of t ...
-
Baumatic BT26 - page 7
6 Note : Before discarding an old appliance, switch off and disconnect it from the power supp ly. Cut off and render any plug useless. Cut the cable off directly behind th e appliance to prevent misuse. This should be under taken by a competent person. CONFORMITY TO W.E.E.E. DIRECTIVE Environmental Note ...
-
Baumatic BT26 - page 8
7 To use your cooker hood: 1) Make sure it has been properly installed. 2) Find the CONTROL PANEL. It is located centrally at the front of the canopy. 3) The CONTROL PANEL contains keys as shown in the Figure below. These perform separate functions. You will need to understand what the keys do before you attempt to use your cooker hood. * Note: The ...
-
Baumatic BT26 - page 9
8 SPECIAL FUNCTIONS : Your Baumatic Cooker Hood also has advanced features. These are: a) Reminder to clean t he Metal Grease Filters After every 30 hours of use, your cooker hood’s microprocessor will alert you to clean the metal grease filters. It does this by showing a flashing ‘A’ on the display for 5 seconds . Please ensure that you clea ...
-
Baumatic BT26 - page 10
9 IMPORTANT! : Before cleaning, always ensure that you have switched your cooker hood OFF at the omni-polar switch, set at the wall from t he cable: Cleaning  Clean the external p arts with mild liquid deterg ents on a damp cloth.  Never use abrasive powder, corrosive solvents or brushes.  Never insert pointed objects into the motor’s prote ...
-
Baumatic BT26 - page 11
10 First remove the grille by pu lling down on it. Undo the side catches. You can now clean the anti -grease filter grilles. 9 Soak them for about one hour in hot water with a grease-loosening detergent then rinse off thoroughly with hot water. 9 Repeat the process if needed . Refit the grease grille once it has dried. To clean the grease filter gr ...
-
Baumatic BT26 - page 12
11 a) Changing the light bulb 9 Before changing the light bulb, ensure th at the appliance is not live (i.e., ensure that you have switched it off so that it’s in the ‘0’ position). 9 Remove the metal anti-grease filters (se e Figure 2 below) and find the old bulbs located in the light fixture up inside the exposed canopy. Change the h alogen ...
-
Baumatic BT26 - page 13
12 _____________________________________________ _________________________________________ Installing / Changing the Carbon Filter . Your Baumatic Cooker Hood uses CARBON FILT ERS to purify the air for the air recirculation function. You will find two filters t hat will attach to both sides of the fan motor (please see fi gures at bottom of page). ...
-
Baumatic BT26 - page 14
13 Before installation and usage, read all t he instructions and ma ke sure that the voltage (V) and th e frequency (Hz) indicated on th e identification p late (found inside your Cooker Hood) and all the dat a inside the ap pliance are exactly the same as the voltage and frequency in your home. NOTE: The manufacturer declines all responsibilit y i ...
-
Baumatic BT26 - page 15
14 : The cooker hood must not be fitted above stoves with a radiant top plate. : We recommend that at least two people install this hood. NOTE: Your Baumatic Cooker Hood shou ld only be fitted on a wall. Do NOT position it any less tha n 700 mm (70 cm) above the hob. 1) Remove the metal anti-grease filters (See figure at right). 2) Position the hoo ...
-
Baumatic BT26 - page 16
15 ------------------ ---------------------------------------- ---------------- 3) Using a drill bit with a 6 mm diameter, make holes in the wall where you have marked these positions (see below). ---------------------------------------------------------------------------- ---------------------------------------------------------------------------- ...
-
Baumatic BT26 - page 17
16 ------------------------------ -------------------------------------------- ----------------- ------------------------------ -------------------------------------------- ----------------- 6) (EXTRACTION F UNCTION ONLY) Conne ct the coupling to the top of the cooker hood (see below). Then connect the discharge pipe to the coupling as shown below. ...
-
Baumatic BT26 - page 18
17 FITTING THE PIPE – Once your Cooker Hood has been installed, you can now fit the pipe. 1) Take the two casing s ‘A’ and ‘B’: 2) Rest the bottom of the casing ‘A’ on the top of the hood, taking care to position the tabs of the casing correctly on the back of the hood as shown as p art ‘X’ in Figure 4 at right. 3) Fix casing ‘A ...
-
Baumatic BT26 - page 19
18 6) Take the fixing bracket ‘G’ (Fig . 4 – prev ious page), centre it with respect to the mark you pr eviously made, keeping it in contact with the ceiling, and then ma rk the a nchoring hol es (‘H’). 7) Using a drill bit with a 6mm di ameter, make two holes on the fixing marks you previously mad e (see below). 8) Insert the expansion f ...
-
Baumatic BT26 - page 20
19 EXTRACTION OPERATION – Installation Instructions  Ensure that you have fitted the union (‘N’) to the upper part of the hood using the packaged t wo screws supplied inside the packing (Fig. 1 – on r ight). Using a 125 mm diameter pipe, connect the union (N) on the upper part of the hood (see Fig. 1) to the discharg e outlet for cooking ...
-
Baumatic BT26 - page 21
20 * Note on what to do if your Cooker Hood is the version that comes with a BRACKET. Please note that your cooker hood may include a lower bracket. If this is the case, you will need to have it installed as such. This will mean a slight change in how the cooker hood is to be installed from the process shown on page 14. In Fig. 6, below, you will s ...
-
Baumatic BT26 - page 22
21 If something has gone wrong with your Cooker Hood, checking against this chart might keep you from having to call for service. Symptom Solution The cooker hood will not start! • Check that the hood is connected to the electricity supply. • Check that the fan speed control is set properly. The cooker hood is not working effectively! • The f ...
-
Baumatic BT26 - page 23
22 BAUMATIC LTD. - CONDITIONS OF GUARANTEE. Dear Customer, The conditions of guarantee which apply to your Baumatic a ppliance are as follo ws: This product is guaranteed for 12 months from the date of original purchase. Baumatic Ltd will repair any defect that arises due to faulty materi als or workmanship free of charge during this period. In add ...
-
Baumatic BT26 - page 24
23 Baumatic Ltd Make-up for your kit chen Headquarters Baumatic Ltd. Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX, United Kingdom Sales Telephon e +44 118 933 6900 Sales Fax +44 118 931 0035 Service Telep hone +44 118 933 6911 Service Fax +44 118 986 9124 Spares Telephone +44 118 933 6922 Technical / Ad vice Telephone +44 118 933 6 ...
-
Baumatic BT26 - page 25
24 ...
-
Baumatic BT26 - page 26
25 ...
-
Baumatic BT26 - page 27
26 ...
-
Baumatic BT26 - page 28
27 ...
Hai una domanda su Baumatic BT26?
Utilizza il modulo sottostante
Se non hai risolto il problema con Baumatic BT26 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Baumatic BT26 è probabile che voglia condividere il modo di risolverlo.