Manuale per l’uso NEC NP09CM

16 pagine Non applicabile
Scarica

Vai alla pagina of 16

Summary
  • NEC NP09CM - page 1

    Portable Projector NP09CM Ceiling Mount Unit Installation and Adjustment Manual Thank you for your purchase of the NEC portable projector ceiling mount unit. Please read this installation and adjustment manual carefully to ensure proper use. Special skills are required for the installation of the portable projector. This work should never be perfor ...

  • NEC NP09CM - page 2

    2 Heed the Follo wing • When installing the projector, be sure to do so as explained in this manual. The projector may fall and cause injury if it is installed improperly. • To prevent the projector from falling, install it in a place and fasten it in a way with sufficient strength to support the combined weight (3.6 kg) of the projector (2.1 k ...

  • NEC NP09CM - page 3

    3 CA UTION • Do not obstruct the projector's ventilation holes. Doing so will prevent the dissipation of heat and may result in fires. In particular, do not use the projector in the following ways: Do not install the projector in a wall or in a tight place where ventilation is poor, place a cover it, etc. • Do not install the projector in ...

  • NEC NP09CM - page 4

    4 Preparation Required T ools Phillips screwdriver ● ● ● ● Inclination axis screws Left-right angle adjustment screws Inclination adjustment screws Up-down angle adjustment screws List of P acka ged Parts Names of the P ar ts Installation and adjustment manual ..........1 Up-down angle adjustment screws (M5 ) ...4 Projector mounting screws ...

  • NEC NP09CM - page 5

    Preparation 5 Dimensions (Unit: mm) Fixed Ceiling Part Bolt Hole Position Dimensions Fixed Ceiling Part and Lens Center Dimensions Diagram Center line of fixed ceiling part Lens center/Center line of fixed ceiling part 138.9 42.2 180 85.5 210 271.8 90.4 120 150 10 4 - Distance to lens end Lens center Lens center NP09CM_E 08.2.15 5:37 PM ページ 5 ...

  • NEC NP09CM - page 6

    6 Zoom adjustment range 25 0123456789 1 0 1 2 ( m ) 40 60 80 100 120 150 180 200 240 300 11 Wide angle (Maximum) Telephoto (Maximum) Guide to Screen Size and Projector Mounting Position Screen Size and Projection Distance··· (NP200/NP100) Use this guide when considering the distance to the screen and the screen size. • The ceiling mount unit c ...

  • NEC NP09CM - page 7

    Guide to Screen Size and Projector Mounting Position 7 (Inches) (m) 25 0 0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 5.5 6.0m 40 60 80 100 120 150 180 200 240 270 300 Screen Size Con version T able··· (NP200/NP100) Using the Table The dimensions of a 100 inch screen size according to the table will be approximat ...

  • NEC NP09CM - page 8

    8 1 Mounting the Pr ojector Attach the Fixed Ceiling P ar t to the Ceiling First, partially tighten the four screws, then tighten the screws firmly after positioning. Use M8 bolts for the fixed ceiling part. Use of types other than M8 could cause the projector to fall. W ARNING! Fixed ceiling part 2 Attach the Pr ojector Mounting Adapter to the Pro ...

  • NEC NP09CM - page 9

    9 3 4 Mounting the Projector Suspend the Projector fr om the Fixed Ceiling P ar t Slide the slotted part of the projector mounting adapter over the pin of the fixed ceiling part and push all the way to the back. The projector is temporarily suspended in this condition and attention must be paid so that the unit does not fall since it is not fixed i ...

  • NEC NP09CM - page 10

    Mounting the Projector 10 NOTE : Mounting boards, M8-type anchor nuts, bolts, nuts and washers are commercially available. Mounting board (Strong enough to support the weight of the whole unit.) Nut and washer Beam Nut and washer Bolt (M8) Anchor nut (Purchase commercially-available M8-type anchor nuts that are strong enough to endure the weight of ...

  • NEC NP09CM - page 11

    11 1 2 3 Replacing the Lamp To replace the lamp, first switch off the power, wait for the cooling fans to stop and disconnect the power plug from the outlet. Now, wait about 60 minutes before replacing the lamp. Attempts to replace the lamp during operation or immediately after operation has stopped will cause burns because of the high temperature. ...

  • NEC NP09CM - page 12

    12 1 上下端 Upper and lower edges Adjustment of the Pr ojection Angle Before the Adjustment • Refer to the instruction manual of the projector, switch on the power and project an image. • Refer to the section "Orientation " of Setup and select the projection orientation. Select "Ceiling/Front" when projection is from the ...

  • NEC NP09CM - page 13

    13 2 3 Adjustment of the Projection Angle Adjust the Up-Down Angle Turn the projector up and down so that the left and right edges of the screen are parallel, then firmly tighten the four up-down angle adjustment screws. It is acceptable if the image extends beyond the screen. Maximum adjustment angle +/-10 ˚ Up-down angle adjustment screws (There ...

  • NEC NP09CM - page 14

    14 Adjustment of the Projection Angle Fine Adjustment After the adjustments, chec k that the par ts are fixed securel y . Loosen the same screws that were used in the distortion adjustment and finely adjust the angle so that the projected image fits the screen, then tighten all the screws (i.e., a total of 14 including the inclination axis screws). ...

  • NEC NP09CM - page 15

    MEMO NP09CM_E 08.2.15 5:37 PM ページ 15 ...

  • NEC NP09CM - page 16

    MEMO NP09CM_E 08.2.15 5:37 PM ページ 16 ...

Fabbricante NEC Categoria Projector accessory

I documenti che otteniamo dal fabbricante del dispositivoNEC NP09CM possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici NEC
- manuali per l’uso NP09CM
- schede prodotto NEC
- opuscoli
- o etichette energetiche NEC NP09CM
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso NEC NP09CM.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione NEC NP09CM, manuali di manutenzione, brevi manuali o manuali utente NEC NP09CM. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto NEC NP09CM.

Manuali per l’uso simili

Manuale completo del dispositivo NEC NP09CM, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare NEC NP09CM dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti NEC NP09CM.

Il manuale per l’uso completo NEC, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale NEC NP09CM - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice NEC NP09CM, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per NEC NP09CM che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo NEC NP09CM - che ci dovrebbe aiutare nei primi passi durante l'uso NEC NP09CM
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del NEC NP09CM
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio NEC NP09CM in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su NEC NP09CM?

Utilizza il modulo sottostante

Se non hai risolto il problema con NEC NP09CM con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con NEC NP09CM è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Commenti (0)