Italiano dropdown-ico

Manuale per l’uso Hoover S3083-030

20 pagine 1.42 mb
Scarica

Vai alla pagina of 20

Summary
  • Hoover S3083-030 - page 1

    HOOVER Model Owner’s i Celebrity II TM .S3083-030 Manual j Cleaner &L ...

  • Hoover S3083-030 - page 2

    Fill in and retain ! The vacuum cleaner you have just purchased is a combination cleaner. It has a motorized power nozzle for carpet and floor cleaning and has cleaning tools for above the floor cleaning. Your cleaner is a model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..*.......................... a ...

  • Hoover S3083-030 - page 3

    Importantsafeguards! l Read all instructions. l Warning: Electric shock could occur if used outdoors or on wet surfaces. l Close supervision is necessary when any appliance is used by or near children. Do not allow vacuum cleaner to be used as a toy or to run unattended at any time. l Keep hands, feet, loose clothing, and hair away from rotating ag ...

  • Hoover S3083-030 - page 4

    14 A I 1. FURNITURE GUARD 2. COMBINATION CARPET AND FLOOR ‘POWERMATIC’ NOZZLE Powermatic nozzle automatically adjusts to different carpet pile height. Has setting for “Carpet” and “Bare Floor”. 3. SURFACE SELECTOR INDICATOR Shows “Carpet” or “Bare Floor” setting of Surface Selector Lever. 4. SURFACE SELECTOR LEVER Push lever wit ...

  • Hoover S3083-030 - page 5

    6. WALL/FLOOR BRUSH 7. HOSE CORD CONNECTION TO CLEANER Plug hose cord into cleaner base to receptacle. 8. CASTERS Provide easier towing; pull cleaner using hose to guide the cleaner easily over carpet, throw rugs, and door sills. 9. ON-OFF SWITCH A convenient switch is located near front of cleaner. 10. CORD STORAGE HOOKS II. EXTENSION WANDS Connec ...

  • Hoover S3083-030 - page 6

    TO CONNECT AND REMOVE HOSE To connect hose, insert hose into opening of cleaner lining up the arrow on the hose with the dot on the cleaner. Turn the hose clockwise until it lines up with the bar on the cleaner and latch locks into place. When the hose is attached properly, the hose cord plug will reach to the receptacle on the cleaner. Insert the ...

  • Hoover S3083-030 - page 7

    HOW TO USE HANDLE ADJUSTMENTS The handle has two positions when used with the power nozzle: Storage and Low. Step on the Han- dle Adjustment Latch to lower the handle. Use the low position for reaching under low furniture. Raise the handle straight up for the storage position. CARPET AND RUG CLEANING When using the power nozzle for carpet and rug c ...

  • Hoover S3083-030 - page 8

    FOR HARD SURFACE FLOOR CLEANING The power nozzle can be used for cleaning hard sur- face floors such as wood, linoleum, vinyl, asphalt and rubber tile, sealed cork, concrete and terrazzo as well as carpet. You will find it particularly con- venient when cleaning rugs to adjust the power noz- zle to “Bare Floor” and continue cleaning the sur- ro ...

  • Hoover S3083-030 - page 9

    HOW TO USE THE ‘CELEBRITY II’ CLEANER WITH CLEANING TOOLS CLEANING TOOLS The cleaning tools have many uses. Select the tool best suited for the cleaning task from the descrip- tions below. Adjust the Suction Regulator to select the amount of suction appropriate to the cleaning task. FURNITURE NOZZLE For upholstered furniture, draperies, tapestr ...

  • Hoover S3083-030 - page 10

    TO CLEAN HARD TO REACH AREAS Use the curved wand with the extension wands. The tools attached to the curved wand will enable you to clean many hard to reach areas; especially crown moldings, tops of drapery rods, shelves, and picture frames, etc. TO CLEAN STAIRS Clean stairs by placing the cleaner on its side as pictured in the illustration. Clean ...

  • Hoover S3083-030 - page 11

    When To Replace Check bag from time to time. When the bag is filled with dirt, the cleaner will not operate effectively. Discard used bag. CAUTION: Very fine materials, such as face powder, cornstarch, fire- place ashes or fireplace soot, may seal the throw away bag and may cause it to burst even though it is only partially full of dirt. When the c ...

  • Hoover S3083-030 - page 12

    HOW TO CLEAN SECONDARY FILTER DISCONNECT CLEANER FROM ELECTRICAL OUTLET BEFORE REMOVING FILTER The secondary filter is a foam disc located on top of the motor and protects the motor from dirt par- ticles. When the filter becomes dirty, either clean or replace it. To remove, pull filter from top of motor. Clean by rinsing it in water. When dry, slid ...

  • Hoover S3083-030 - page 13

    To provide space for grasping the agitator, remove end of hose from holder, Fig. 3. Then grip agitator and pull out. Fig. 4. Remove old belt. Place one end of the new belt around agitator pulley with smooth side of belt against the pulley. Fig. 5. 5 Line up metal projection on end of agitator (opposite the belt) with groove on inside wall of nozzle ...

  • Hoover S3083-030 - page 14

    Place a screwdriver under the belt as illus- trated. Fig. 8. 8 Bracing the end of the screwdriver against the end of the motor shaft, slide belt over end of shaft. Fig. 9. Remove screwdriver. Check to be sure belt is not twisted. 9 Rotate the agitator by hand to properly align the belt on the motor shaft. Agitator should rotate freely. Fig. 10. IO ...

  • Hoover S3083-030 - page 15

    NOZZLE HOSE The Nozzle Hose carries the dirt from the nozzle to the extension wand and to the throw away bag. If the hose becomes obstructed, cleaning effectiveness will sharply decrease. Remove bottom plate as de- scribed in preceding section, and slide end of hose out of the holder. Clear hose and reinsert into holder. Replace bottom plate as des ...

  • Hoover S3083-030 - page 16

    LOCATOR Remove brushes by pulling them from agitator with pliers. Slide new brushes into the channels - small ends first - pushing them in as far as possible. (Fig. 4). Replace end plate and shaft, lining up locator on end section with slot in agitator. Replace other end section and end plate and tighten. (Fig. 5). 5 END SECTION WAS BEARIN Should y ...

  • Hoover S3083-030 - page 17

    HOW TO REPLACE THE BOTTOM PLATE BRUSH Disconnect cleaner from electrical outlet and disconnect Powermatic nozzle from extension wand. 1 Put the Surface Selector Lever in the “Carpet” Position. This will allow for easier removal of the brush. Turn Power- matic nozzle over. Remove bottom plate by unscrewing the 2 Phillips head screws at the back ...

  • Hoover S3083-030 - page 18

    USER CHECK LIST This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem develops, it usually can be remedied quite easily when the cause is identified. Accordingly, this check list is provided for your convenience. PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION A. CLEANER 1. Not ...

  • Hoover S3083-030 - page 19

    LUBRICATION The motor is equipped with one ball bearing and one roller bearing. These bearings contain sufficient lubrication for the life of the motor. The addition of lubricant could cause damage. Therefore, do not add lubricant to either motor bearing. The agitator is equipped with two ball bearings that should be lubricated periodically. This s ...

  • Hoover S3083-030 - page 20

    VCMA VACUUM CLEANER MANUFACTURERS ASSOCIATION (HOOVER - AN ASSOCIATION MEMBER) Service To The Consumer Since 19 13 This information has been compiled by the Vacuum Cleaner Manufacturers Associ- ation from Governmental and Private Sources concerned with product safety. These basic guidelines are for your protection and convenience. TO AVOID ELECTRIC ...

Fabbricante Hoover Categoria Vacuum Cleaner

I documenti che otteniamo dal fabbricante del dispositivoHoover S3083-030 possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Hoover
- manuali per l’uso S3083-030
- schede prodotto Hoover
- opuscoli
- o etichette energetiche Hoover S3083-030
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Hoover S3083-030.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Hoover S3083-030, manuali di manutenzione, brevi manuali o manuali utente Hoover S3083-030. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Hoover S3083-030.

Manuali per l’uso simili

Manuale completo del dispositivo Hoover S3083-030, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Hoover S3083-030 dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Hoover S3083-030.

Il manuale per l’uso completo Hoover, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Hoover S3083-030 - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Hoover S3083-030, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Hoover S3083-030 che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Hoover S3083-030 - che ci dovrebbe aiutare nei primi passi durante l'uso Hoover S3083-030
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Hoover S3083-030
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Hoover S3083-030 in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Hoover S3083-030?

Utilizza il modulo sottostante

Se non hai risolto il problema con Hoover S3083-030 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Hoover S3083-030 è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Captcha
Nuova immagine

Commenti (0)