-
Electrolux DI 8821 - page 1
DI 8820 - DI 8821 HI 8820 Dunstabzugshaube Afzuigkap Hotte Cooker Hood Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Notice dutilisation et dinstallation Operating and Installation Instructions ...
-
Electrolux DI 8821 - page 2
61 Content s Safety warnings .............................................................................. 6 2 For the User ...................................................................................... 6 2 For the Inst aller ................................................................................. 6 3 Description of the Appliance ...
-
Electrolux DI 8821 - page 3
62 Safety warnings For the user The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. Also, when frying, keep the deep fry ...
-
Electrolux DI 8821 - page 4
63 For the installer When used as an extractor unit, the hood must be fitted with a 150mm diameter hose. Should there already be a pipe of diameter 125 or 120 mm that ducts to the outside through the walls, it is possible to use the 150/125- 120 mm reduction flange provided. In this case the hood will be slightly noisier . When installi ...
-
Electrolux DI 8821 - page 5
64 When the hood is used in its extraction mode, the following rules must be followed to obtain optimal operation: - short and straight outlet hose - keep bends in outlet hose to a minimum - never install the hoses with an acute angle, they must always follow a gentle curve. - keep the hose as large as possible (preferably the same diameter as ...
-
Electrolux DI 8821 - page 6
65 Description of the Appliance The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. The hood is supplied as an extractor unit and can also be used with a recirculation mode by fitting a charcoal filter . Y ou will need an original charcoal filter for this function (Available from your lo ...
-
Electrolux DI 8821 - page 7
66 Control Panel Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the hood ...
-
Electrolux DI 8821 - page 8
67 Grease and charcoal filter maintenance indicator This hood is fitted with a device that indicates when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter). On delivery , the hood is not supplied with a charcoal filter , so the saturation indicator will be dis ...
-
Electrolux DI 8821 - page 9
68 Maintenance and Care The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood Clean the outside of the hood using a damp cloth and a solution of water and mild washing up liquid. Never use corrosive, abrasive or flammable cleaning products or products containing bleach. ...
-
Electrolux DI 8821 - page 10
69 g g h d i h g g Charcoal filter The charcoal filter should only be used if you want to use the hood in recirculation mode. T o do this you will need an original charcoal filter (available from your local Service Force Centre). Cleaning/replacing the charcoal filter Unlike other charcoal filters, the LONGLIFE charcoal filter can be cl ...
-
Electrolux DI 8821 - page 11
70 W arning Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. Y ou are therefore strongly recommended to follow these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe th ...
-
Electrolux DI 8821 - page 12
71 What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply . Check that a fan speed has been selected The cooker hood is not working Check that: The fan speed is set high enough for the task. The greas ...
-
Electrolux DI 8821 - page 13
72 T echnical assist ance service (not for UK) Y ou are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fault. For service in Australia call 1300 650 020. When calling, please be ready to specify: 1. The model code number 2. The serial numbe ...
-
Electrolux DI 8821 - page 14
73 T echnical Det ails Models DI 8820 DI 8821 HI 8820 Dimensions (in cm): Heig ht 81,5-110 9 6 - 1 4 0 Width 120 1 20 Depth 7 0 70 Maximum absorbed power: 255 W 255 W Motor absorption: 175 W 175 W Lighting: 4 x 20 W 4 x 20 W Length of the cable: 150 cm 150 cm Electrical connection: 220-240 V 230 V If you require Customer Service in the Republic of ...
-
Electrolux DI 8821 - page 15
74 Mounting accessories included 1 Reduction flange Ø 150-125 1 Deflector 6 Wood-screws 6 x 70 mm 6 Wall plugs Ø 10 mm 14 Nuts 4 Metal-screw 3 x 9 mm (2 upper chimney fixing + 2 for chimney brackets) 14 Metal-screw 4 x 8 mm (4 for additional structure fixing + 10 to fix hood to structure) 14 Metal-screw 4 x 7 mm (to fix chimeny sections) 2 Chimne ...
-
Electrolux DI 8821 - page 16
75 Inst allation - Fig. 7-8-9-10 Assembling the deflector (3 parts only for filter version): The three parts should be fixed with 2 screws, the deflector extension is adjustable and should correspond to the width of the chimney flue support, to which it is then fixed. Fig. 7 . Expansion plugs are provided to secure the hood to most types of cei ...
-
Electrolux DI 8821 - page 17
76 Fig. 8 2a 3 4 4 4 4 4 4 6 6 7 7 7 7 8 8 2a 5 7 9 10 10 10 10 11 11 14,5 273 273 244 214 190 6 12 2b 2b ...
-
Electrolux DI 8821 - page 18
77 For extractor versions (13A), connect the other end of the exhaust pipe to the flue. For filter versions (13F), fit deflector F to the support and secure it to the bracket supplied using 4 screws, then connect the exhaust pipe to the connection ring located on the deflector . Fit the nuts with fixing hooks (14) supplied inside the top an ...
-
Electrolux DI 8821 - page 19
78 Fig. 9 15b 15b 15b 15b 15b 16 16 15b 15b 13F F 13A 15b 14 15a 15b ...
-
Electrolux DI 8821 - page 20
79 Fig. 10 18 18 18 18 18 18 18 18 18 18 M 19 19 X X 20 20 17 ...
-
Electrolux DI 8821 - page 21
LI2JVD Ed. 07/05 From the Electrolux Group. The world´s No.1 choice. The Electrolux Group is the world´s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, washing machines,vacuum cleaners, chain saws and lawn mowers) are sold each year to a ...
Hai una domanda su Electrolux DI 8821?
Utilizza il modulo sottostante
Se non hai risolto il problema con Electrolux DI 8821 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Electrolux DI 8821 è probabile che voglia condividere il modo di risolverlo.