-
Life Fitness g7 - page 1
G7 CABLE MOTION ™ GYM SYSTEM USER GUIDE W ARNING: Read and follow all directions for each step to insure proper assembly of this product. CLASS H P ART # 8352100 REV . A VERSION: LFG7-001 DA TE: 08-10-07 ...
-
Life Fitness g7 - page 2
2 T ABLE OF CONTENTS Safety S tatement . . . . . . . . . . . . . . . .2 Assembly Instructions . . . . . . . . . . . . . .7 Gym Dimensions. . . . . . . . . . . . . . . . .3 General Maintenance . . . . . . . . . . . . . .19 Components List . . . . . . . . . . . . . . . . .4 W arranty S tatement . . . . . . . . . . . . . . .20 Required Hardware . . . ...
-
Life Fitness g7 - page 3
3 GYM DIMENSIONS Weight: 720 lbs Resistance Ratio: 1:2 ...
-
Life Fitness g7 - page 4
ITEM NO. QTY . P ART NO. DESCRIPTION 1 1 8172901 LEFT TOWER 2 1 8178003 TOP BRACKET TUBE 3 1 8178002 MIDDLE BRACKET TUBE 4 1 8178004 BOTTOM BRACKET TUBE 5 1 8351601 LEFT SLIDE TUBE (WITH ROLLER CARRIAGE) ASSEMBL Y 6 1 8257401 RIGHT U BRACKET 7 1 8256901 LEFT U BRACKET 8 1 8316401 RIGHT SWIVEL PULLEY 9 1 8151301 LEFT SWIVEL PULLEY 10 1 8351701 RIGHT ...
-
Life Fitness g7 - page 5
5 HARDW ARE LISTED BELOW ITEM NO. QTY . P ART NO. DESCRIPTION 26 32 3256201 M10 X20MM SCREW 27 52 3264201 M10 W ASHER 28 20 3242201 M5 HEX SCREW 29 20 3264101 M6 W ASHER 30 4 3256208 M10 X 55MM SCREW 31 2 3256206 M10 X 45MM SCREW 32 13 3242002 M10 HEX NYLOCK NUT 33 7 325621 1 M10 X 70MM SCREW 34 2 3264601 M10 SOCKET HEAD NUT 35 2 3256207 M10 X 50MM ...
-
Life Fitness g7 - page 6
6 HARDW ARE: ...
-
Life Fitness g7 - page 7
7 NOTE: T wo person assembly is recommended. STEP 1: Make sure the LEFT TOWER (1) and the RIGHT TOWER (1 1) are positioned correctly prior to assembly . The LEFT U BRACKET (A) and RIGHT U BRACKET (B) should point towards each other as shown in the above illustration. Use four M10 x 20mm SCREWS (26) and four M10 W ASHERS (27) to connect the ...
-
Life Fitness g7 - page 8
8 STEP 2: Attach the CHIN UP BAR (12) between the LEFT TOWER (1) and RIGHT TOWER (1 1) using four M10 x 70mm SCREWS (33), eight M10 W ASHERS (27), and four M10 HEX NYLOCK NUTS (32). Finger tighten only . NOTE: Make sure the CHIN UP BAR (12) is in the correct position as shown. T ighten all FRAME and CHIN UP BAR screws and nuts securely . ...
-
Life Fitness g7 - page 9
9 STEP 3: Slide the top of the LEFT SLIDE TUBE ASSEMBL Y (5) over the UPPER BRACKET (C) on the LEFT T OWER (1). NOTE: MAKE SURE THE ENGRA VED NUMBERS ON THE LEFT SLIDE TUBE ASSEMBL Y (5) F ACE THE INSIDE OF THE GYM. NOTE THE ORIENT A TION OF THE CARRIAGE. Secure the LEFT SLIDE TUBE ASSEMBL Y (5) to the UPPER BRACKET (C) of the LEFT T OWER ( ...
-
Life Fitness g7 - page 10
10 STEP 4: Remove the protective paper from the SIDE SHROUD (23) before installation. Install one SIDE SHROUD (23) to the RIGHT TOWER (1 1) using sixteen M5 SHOULDER SCREWS (39) on the inside of the SIDE SHROUD (23) into the UPRIGHT TUBES (E) of the RIGHT TOWER (1 1). T ighten the screws securely . NOTE: YOU MUST BE ST ANDING INSIDE THE GYM ...
-
Life Fitness g7 - page 11
11 STEP 5 NOTE: INST ALL FROM THE INSIDE OF THE UNIT . Position two WEIGHT ST ACK CUSHIONS (20) and GUIDE RODS (16) at the GUIDE ROD BRACKET (G) on the RIGHT TOWER (1 1) as shown. NOTE: MAKE SURE THA T THE PLUGGED END OF THE GUIDE RODS (16) ARE F ACING UP . Slide one WEIGHT PLA TE (17) over the GUIDE RODS (16) and slowly lower the WEIGHT PL ...
-
Life Fitness g7 - page 12
12 STEP 6: Uncoil cables to remove all twists. Remove the UPPER PULLEYS (H) on the RIGHT TOWER (1 1) and LEFT TOWER (1) by removing the M10 x 50mm SCREW (I), PULLEY RET AINER (J), M10 SOCKET HEAD NUT (K), and P ARTIAL PULLEY COVERS (L). Set the UPPER PULLEYS (H) and hardware aside. Remove the LOWER PULLEYS (M) on the RIGHT TOWER (1 1) a ...
-
Life Fitness g7 - page 13
13 STEP 7: Insert the threaded end of the CABLE (21) where UPPER PULLEY (H) was located. Lower the CABLE (21) down the long vertical tube that is in front of the gym until it can be retrieved near where the LOWER PULLEY (M) was located. Carefully pull enough cable out to reach the ROLLER CARRIAGE (Q). REINST ALL the LOWER PULLEY using t ...
-
Life Fitness g7 - page 14
14 STEP 8: Dissemble one QUICK CONNECT by removing the two M5 HEX SCREWS (T) from the QUICK CONNECT COU- PLER (U). Carefuly remove the QUICK CONNECT SPRING (V), the QUICK CONNECT SLEEVE (W) and the QUICK CONNECT HOUSING (X). Slide the QUICK CONNECT HOUSING (X), QUICK CONNECT SPRING (V), and QUICK CONNECT SLEEVE (W) onto the cable as shown. ...
-
Life Fitness g7 - page 15
15 STEP 9: Make adjustments to the HEAD PLA TE PULLEY (19) and the threaded cable end to adjust cable length and to ensure the cable is taut. If the threaded cable end is completely threaded into the ROLLER CARRIAGE (Q) and there is still some slack in the CABLE (21), remove the pulley from the HEAD PLA TE PULLEY (19). Thread the HEAD PLA T ...
-
Life Fitness g7 - page 16
16 STEP 10: Install the FOOT EXTENSIONS (22) to the BOTTOM BRACKET TUBES (4) using four M10 x 20mm SCREWS (26) and four M10 W ASHERS (27) on each side. ...
-
Life Fitness g7 - page 17
17 STEP 1 1: Attach the six KIOSK BRACKETS (24) to the RIGHT TOWER (1 1) and LEFT TOWER (1) using two M5 HEX SCREWS (28) and two M6 W ASHERS (29) each. T ighten the screws securely . Fasten the KIOSK (25) to the KIOSK BRACKETS (24) using twelve M10 x 20mm SCREWS (40) and twelve 10.5 W ASHERS (41). NOTE: SUPPORT THE KIOSK (25) UNTIL THE SCRE ...
-
Life Fitness g7 - page 18
18 STEP 12: Adjust the rollers if the ROLLER CARRIAGE (Q) rolls up and down the tube with difficulty , or if it seems to sloppy . Unscrew the cable end from the roller carriage housing. Remove the SCREWS (Y) that hold the two PLASTIC COVERS (Z) together . There are two ROLLER ADJUSTMENT SCREWS (AA), each with a spring, on the back s ...
-
Life Fitness g7 - page 19
19 MAINTENANCE Please note: * W e recommend cleaning your product (pads and frame) on a regular basis, using warm soapy water . T ouch-up paint can be purchased from your Life Fitness cus- tomer service representative at (800) 351-3737. * Inspect equipment daily . T ighten all loose connections are replace worn part s immediately . Failure to do so ...
-
Life Fitness g7 - page 20
20 LIMITED W ARRANTY Life Fitness® G7 Cable Motion™ Gym System Life Fitness extends the following LIMITED W ARRANTY to the original owner (proof of purchase required, keep your receipt with this manual) of the Life Fitness product. The W arranty terms apply to IN HOME and LIGHT INSTITUTIONAL USE ONL Y . 1. LIMITED W ARRANTY ON FRAME AND WELDS. I ...
-
Life Fitness g7 - page 21
LIFE FITNESS 5100 NOR TH RIVER ROAD. SCHILLER P ARK, IL 60176 U.S.A. T el: 1.847.288.3300 Fax: 1.800.216.8893 1.800.351.3737 (T oll-free within the U.S. and Canada) www .lifefitness.com INTERNA TIONAL OFFICES LFG7-001 Rev A 08/07 Life Fitness Atlantic BV Atlantic Headquarters Bijdorpplein 25-31 2992 LB Barendrecht The Netherlands Phone: (180) 646 6 ...
Hai una domanda su Life Fitness g7?
Utilizza il modulo sottostante
Se non hai risolto il problema con Life Fitness g7 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Life Fitness g7 è probabile che voglia condividere il modo di risolverlo.