-
Emerson HD8100R - page 1
PE R S O N A L C D , CD - R / R W P L A YE R w i t h 6 0 SE C O N D AN T I - S H O C K a n d W I R E D R E M O T E C O N T R O L , S T E R E O H E AD P H O N E S H D 8100 R O W N E R ’ S M A N U A L V i s i t ou r w eb s i t e a t w ww . e m e r s on r ad i o . c o m HD8100R_031604.p65 16/3/2004, 14:18 20 ...
-
Emerson HD8100R - page 2
1 T h a n k y o u . ........ F o r pu r c ha s i ng t h i s E m e r s on P e r s o na l CD P l a y e r . T he C D p l a y e r ha s a 2 0 t r a ck p r og r a mm ab l e m e m o r y s o y ou c a n li s t en t o t he s o ng s on y ou r f a v o r i t e CD ' s i n a n y o r de r y ou c h oo s e . O r y o u c a n u s e t he R a ndo m p l a y ba ck f ...
-
Emerson HD8100R - page 3
2 W A RN I N G: T O P R EVE N T F I R E O R S H O C K H A Z A R D , D O N O T E XP O SE T H I S UN I T T O R A I N O R M O I S T UR E . T h i s de v i c e c o m p li e s w i t h pa r t 15 o f t he F CC r u l e s . O pe r a t i on i s s ub j e c t t o t he c ond i t i on t ha t t h i s de v i c e doe s no t c au s e ha r m f u l i n t e r f e r en c ...
-
Emerson HD8100R - page 4
3 P R E P AR A T I O N F O R U S E REMOVE THE TRANSIT CARD This personal CD player is shipped with a dummy CD ‘ transit card ‘ inside the CD compartment. The purpose of this card is to prevent the laser from moving during shipment of the product. This card must be removed before using the CD playe r. Slide the OPEN switch to the right to unlock ...
-
Emerson HD8100R - page 5
4 INS TA LLING THE B ATTERIES Note : The battery compartment is located inside the CD compartment. 1.) Slide the OPEN switch to the right to open the CD door. If you have not already done so, remove the dummy CD ‘ transit card ’ and discard it. 2.) Press the battery door locking tab in the direction of the ‘ Arrow ’ to open the battery door ...
-
Emerson HD8100R - page 6
5 CONNECTING THE OPTION AL AC ADAPTER (NOT INCLUDED) 1.) Connect the small female plug of the optional AC adapter to the “ DC IN 4.5 V ” jack on the right side of the CD player. 2.) Connect the adapter housing to your 120V 60Hz AC outlet. Notes: • Never connect or disconnect the adapter from the AC outlet while your hands are wet. • The hou ...
-
Emerson HD8100R - page 7
6 CONNECTING THE STEREO HEADPHONES AND REMOTE CONTROL • Connect the plug of the supplied stereo headphones directly to the green-colored PHONES jack on the left side of the cabinet. • Or you may connect the headphones to the supplied Remote Control, then to the PHONES jack. Note: The control buttons PL A Y/ PA USE , STOP , SKIP FWD and SKIP REV ...
-
Emerson HD8100R - page 8
7 1 . ) O PE N S w i t c h – S li de t o t he r i gh t t o un l o ck a nd open t he CD doo r . . 2 . ) V O L U M E C on t r o l – R a i s e s o r l o w e r s t he v o l u m e . 3 . ) P H O N ES J a ck – C onne c t s t e r eo headphone s , i n c l uded , t o t h i s j a ck . 4 . ) H O L D S w i t c h ( B o tt o m C ab i ne t ) . 5 . ) P R OG ( ...
-
Emerson HD8100R - page 9
8 1 . ) T r a ck N u m be r Di s p l a y . 2 . ) P R OG ( P r og r a m) I n d i c a t o r – A ppea r s w hen p r og r a mm i ng t r a cks o r p l a y i ng p r og r a mm ed t r a cks . 3 . ) S HU FF ( S hu ff l e ) I nd i c a t o r – A ppea r s w hen R a ndo m p l a y ba ck m ode i s s e l e c t ed . 4 . ) I N T R O I nd i c a t o r – A ppe a ...
-
Emerson HD8100R - page 10
9 O P E R A T I N G I N S T RUC T I O N S SPECIAL FUNCTIONS HOLD Switch The HOLD switch on the bottom of the cabinet must be in the ‘ Off ’ (left) position to start the CD player. If you plan to carry the CD player in a handbag, briefcase, school bag, back pack, etc, slide the HOLD switch to the ‘ On ’ (right) position. While the HOLD switc ...
-
Emerson HD8100R - page 11
10 Electronic Skip Protection (ESP) This CD player includes an Electronic Skip Protection circuit that continuously stores 60 seconds of CD music in an electronic memory. If the player is bumped or shaken you will not hear any skipping because the player is reading from the memory, not directly from the disc. Of course if the shaking continues for ...
-
Emerson HD8100R - page 12
11 NORMAL CD PL AYBACK • Make sure you have installed the batteries. • Make sure the HOLD switch is set to the ‘ Off ’ (left) position. • Make sure to set the VOLUME control to a low setting before you put on the headphones. IMPOR TANT: This CD player can play normal CDs plus CD Recordable (CD-R) and CD Rewriteable (CD-RW) discs. However ...
-
Emerson HD8100R - page 13
12 6.) Playback will continue until the end of the disc, then the player will stop automatically and the display will again show the total tracks and playing time on the disc. After approximately 30 seconds the power switches ‘ Off’ automatically to conserve the batteries and the display goes blank. To stop playback before the disc ends press t ...
-
Emerson HD8100R - page 14
13 PL AY MODE BUTTON Pressing the MODE button during playback cycles the player through the following four special playback modes: (Repeat 1 Track) ALL (Repeat All Tracks) INTRO SHUFF (Shuffle) Playback. REPE AT PLAYBACK The player can be programmed to continuously repeat a single track or the entire disc automatically. One Track Repeat During play ...
-
Emerson HD8100R - page 15
14 INTRO (Intro Scan) PL AYBACK The Intro Scan feature plays only the first 10 seconds of each track on the disc. This feature is useful when you are trying to find a particular song but you cannot remember the title. 1.) Load your disc in the player as usual and press the PL A Y/ PA USE button to begin playback. 2.) When playback begins press the ...
-
Emerson HD8100R - page 16
15 PROGRAMMED PL AYBACK You can program up to 20 tracks on a disc to play in any desired orde r. NOTE: You can program a disc either during playback or in Stop mode. 1.) Press the PROG button once. The PROG indicator and the Program Number ‘ 01 ’ appear, and the track number ‘ 00 ’ flashes. 2.) Press the SKIP FWD or SKIP REV button to selec ...
-
Emerson HD8100R - page 17
16 5.) Press the PL A Y/ PAUSE button to begin programmed playback. The PROG indicator remains in the display and the track display stops flashing. • Playback begins with the first track you programmed and continues until all programmed tracks have been played, and then the player stops. The programmed sequence will remain in the memory until the ...
-
Emerson HD8100R - page 18
17 C L E AN I N G T H E CAB I N E T W i pe w i t h a s o f t c l o t h . If t he c ab i ne t i s v e r y d i r t y , da m pen t he c l o t h w i t h a w ea k s o l u t i on o f neu t r a l de t e r gen t a nd w a t e r , and t hen w i pe c l e an . C L E AN I N G T H E L E N S A d i r t y l en s w ill c au s e s ound sk i pp i ng a nd , i f t he l ...
-
Emerson HD8100R - page 19
18 L I M I T E D W AR RAN T Y E m e r s on R a d i o C o r p . w a rr a n t s m a nu f a c t u r i ng d e f e c t s i n o r i g i n a l m a t e r i a l , i n c l ud i ng o r i g i n a l p a r t s a nd w o r k m a n s h i p, und e r no r m a l u s e a nd c o nd iti on s , f o r a p e r i od o f n i n e t y ( 90 ) d a y s fr o m t h e d a t e o f o r ...
-
Emerson HD8100R - page 20
E M E R S O N P AR T N O . 16 - 2951 403 - 0 1 P R I N T E D I N CH I NA HD8100R_031604.p65 16/3/2004, 14:18 19 ...
Hai una domanda su Emerson HD8100R?
Utilizza il modulo sottostante
Se non hai risolto il problema con Emerson HD8100R con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Emerson HD8100R è probabile che voglia condividere il modo di risolverlo.