Manuale per l’uso York H3CE120

16 pagine 0.71 mb
Scarica

Vai alla pagina of 16

Summary
  • York H3CE120 - page 1

    GENERAL These condensing units are designed for outdoor installation on a roof or at ground level. Every unit is completely piped and wired at the factory and is shipped ready for immediate installa- tion. Only the liquid and suction lines to the evaporator coil, the control wiring and the main power wiring are required to com - plete the installat ...

  • York H3CE120 - page 2

    035-15407-002-B-0404 2 Unitary Products Group General ................................................................................ 1 Reference ............................................................................ 1 Inspection ............................................................................ 1 Nomenclature ..................... ...

  • York H3CE120 - page 3

    LIMIT ATIONS These units must be installed in accordance with all national and local safety codes. If no local codes apply , installation must conform with the appropriate national codes. See T able 1 for Unit Application Data. Units are designed to meet National Safety Code Standards. If components are to be added to a unit to meet local codes, th ...

  • York H3CE120 - page 4

    CLEARANCES All units require certain minimum clearances for proper opera- tion and service. Refer to Figure 4 for these clearances. WARNING: Do not permit overhanging structures or shrubs to obstruct condenser air discharge. Additional height may be required for snow clearance if winter operation is expected. POWER AND CONTROL WIRING Install electr ...

  • York H3CE120 - page 5

    035-15407-002-B-0404 Unitary Products Group 5 Model HCE V oltage Code Compressor Condenser Fan Motor Unit Ampacity (Amps) Max. Fuse Size 1 (Amps) Power Supply RLA LRA Power Supply HP Qty . FLA 090 25 208/230-3-60 25.6 190 208/230-1-60 3/4 1 3.03 35.1 60 46 460-3-60 12.8 95 460-1-60 3/4 1 1.6 17.6 30 58 575-3-60 10.2 75 575-1-60 3/4 1 1.8 14.6 20 12 ...

  • York H3CE120 - page 6

    035-15407-002-B-0404 6 Unitary Products Group FIG. 5 - UNIT DIMENSIONS AND CLEARANCES A I R O U T A I R I N 4- 5/ 8 ( 118) 2 5 - 3 / 4 ( 6 5 5 ) 1 0 - 1 / 8 ( 2 5 8 ) 2 - 1 / 2 ( 6 . 4 ) 4 - 1 / 2 ( 115) G U A G E L I N E A C C E S S 1 - 1 / 8 " ( 2 8 . 6 ) O D S U C T I O N L I N E 1 / 2 " ( 1 2 . 7 ) O D L I Q U I D L I N E C O M P R E ...

  • York H3CE120 - page 7

    REFRIGERANT PIPING GENERAL GUIDELINES Many service problems can be avoided by taking adequate precautions to provide an internally clean and dry system and by using procedures and materials that conform with estab- lished standards. Use hard drawn copper tubing where no appreciable amount of bending around pipes or other obstructions is necessary . ...

  • York H3CE120 - page 8

    035-15407-002-B-0404 8 Unitary Products Group NOTE: Add the operating charge of the condensing unit, the evaporator coil and the refrigerant lines to determine the total refrigerant charge of the system. 1 Charges are based on 40 ° F suction temperature and a 105 ° F liquid temperature. 2 T ype “L” copper tubing. Model Designation Nominal Cap ...

  • York H3CE120 - page 9

    EXTENDING THE SERVICE PORTS (Refer to Fig 7.) 1. Loosen the screws securing the service ports in shipping position. 2. Push the service ports through the corner post. 3. T ighten the screws to secure the service ports for installa - tion. INST ALLATION Since the condensing units are shipped with a holding charge of refrigerant-22, they can be check ...

  • York H3CE120 - page 10

    10. After the disc has been removed, burnish the external sur - faces and clean the internal surfaces as outlined above. The suction piping can now be brazed to the suction connection on the evaporator coil while maintaining a minimum flow of dry nitrogen. Before brazing the suction line to the condensing unit; 1. Move the dry nitrogen supply to th ...

  • York H3CE120 - page 11

    035-15407-002-B-0404 Unitary Products Group 11 FIG. 7 - EXTENDING THE SERVICE PORTS ...

  • York H3CE120 - page 12

    035-15407-002-B-0404 12 Unitary Products Group FIG. 8 - CHARGING CURVE HCE090 FIG. 9 - CHARGING CURVE HCE120 ...

  • York H3CE120 - page 13

    035-15407-002-B-0404 Unitary Products Group 13 FIG. 10 - CHARGING CURVE HCE150 ...

  • York H3CE120 - page 14

    UNIT OPERATION - 7-1/2, 10 & 12-1/2 TON When the external control calls for cooling at terminal Y1: 1. The system controller (SC) is energized. The system con - troller starts the compressors and enables the condenser fans by energizing contactor 1M (and 2M on the 12-1/2 ton, 208/230 volt models). The single condenser fan is energized with the ...

  • York H3CE120 - page 15

    If the unit continues to be shut down by one of its safety con - trols, service should be called to determine the cause of the problem. Repeatedly resetting the lockout circuit may damage the unit. The following accessories are available to provide low am - bient operation to 0 ° F. SAFETY FEATURES 1. All condenser fan motors have inherent protect ...

  • York H3CE120 - page 16

    Unitary Products Group 5005 Y ork Drive, Norman, Oklahoma 73069 Subject to change without notice. Printed in U.S.A Copyright © 2004 by Y ork International Corporation. All Rights Reserved. 035-15407-002-B-0404 Supersedes: 035-15407-002-A-0304 ...

Fabbricante York Categoria Air Conditioner

I documenti che otteniamo dal fabbricante del dispositivoYork H3CE120 possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici York
- manuali per l’uso H3CE120
- schede prodotto York
- opuscoli
- o etichette energetiche York H3CE120
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso York H3CE120.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione York H3CE120, manuali di manutenzione, brevi manuali o manuali utente York H3CE120. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto York H3CE120.

Manuali per l’uso simili

Manuale completo del dispositivo York H3CE120, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare York H3CE120 dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti York H3CE120.

Il manuale per l’uso completo York, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale York H3CE120 - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice York H3CE120, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per York H3CE120 che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo York H3CE120 - che ci dovrebbe aiutare nei primi passi durante l'uso York H3CE120
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del York H3CE120
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio York H3CE120 in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su York H3CE120?

Utilizza il modulo sottostante

Se non hai risolto il problema con York H3CE120 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con York H3CE120 è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Commenti (0)