Manuale per l’uso Azden 211R

15 pagine 1.56 mb
Scarica

Vai alla pagina of 15

Summary
  • Azden 211R - page 1

    VHF PERFORMANCE SERIES WIRELESS MICROPHONE SYSTEMS AZDEN CORPORA TION P .O. Box 10 - 147 New Hyde Park Road Franklin Square, NY 1 1010 516.328.7500 vox • 516.328.7506 fax AzdenUS@azdencorp.com • www .azdencorp.com O WNER’S MANU AL 31 1DRH • 31 1DR • 221R • 21 1R • 200R 31L T • 31IT • 32BT • 32IT • 31HT • 31XT ...

  • Azden 211R - page 2

    Thank you for purchasing AZDEN’S “PERFORMANCE SERIES” wireless system. This manual covers the 31 1DRH, 31 1DR, 221R, 211R and 200R receivers and the 32BT (Lavaliere), 31XT (Plug-in XLR), 31HT (Handheld), 31L T (Lavaliere) and 31IT (Instrument) transmitters. Receiver Descriptions The 31 1DRH T rue Diversity VHF Half-Rack Receiver: The 31 1DRH ...

  • Azden 211R - page 3

    (4) Antenna connections. On the 31 1DRH the antennas are connector mounted (BNC) so that the supplied antennas can be disconnected and/or remoted using coax cable if needed. (5) 12-V olt Input. Plug the supplied AC adaptor into the 12-volt input on the receiver and then into a 1 10-120 V AC electrical outlet. Use only the adaptor supplied (BC-26U) ...

  • Azden 211R - page 4

    The 31 1DR T rue Diversity VHF Receiver: The 31 1DR contains two separate receivers, each operating on the same frequency . The incoming signal is constantly monitored by a diversity circuit, which switches automatically to the receiver with the stronger RF signal. This allows wireless performance that is virtually drop-out free, even under the mos ...

  • Azden 211R - page 5

    (7) Frequency label Indicates what frequency (in MHz) the receiver operates on. The AZDEN transmitter in use must also be on the same frequency . (8) Output (balanced) Using a suitable audio cable (not supplied) connect the XLR connector to the audio output on the receiver , and connect the other end of the cable to the suitable mic/line input of a ...

  • Azden 211R - page 6

    (5) Output (unbalanced) Using a suitable audio cable (not supplied), connect the 1/4-inch phone jack end of the audio output on the receiver , and connect the other end of the cable to the mic/line input of an audio mixer or amplifier . Please note that the 221R has two outputs, one for Ch.A and one for Ch.B. (6) Frequency label Indicates what freq ...

  • Azden 211R - page 7

    (6) Frequency label Indicates what frequency (in MHz) the receiver operates on. The AZDEN transmitter in use must also be on the same frequency . 200R Single channel VHF r eceiver: The 200R features a 1/4-inch output jack and volume adjustment. (1) Power/Receiving LED When the receiver is plugged in, and the Power button is press IN, the Receiving ...

  • Azden 211R - page 8

    TRANSMITTER DESCRIPTIONS Model 32BT : Lavalier microphone with body-pack transmitter . Ideal for speaking applications such as Lecturers, Actors, Actresses, etc. Model 31XT : Plug-in XLR transmitter turns any dynamic metal-bodied microphone with XLR output into a wireless microphone. Model 31HT : Handheld microphone with a built-in transmitter . Fo ...

  • Azden 211R - page 9

    (4) Audio Input Level Control T urn clockwise to increase, or counter-clockwise to decrease the input level. A small screwdriver is supplied to make adjustments. The level control is factory-preset in the center position. (5) 3 Position Switch The left position: OFF The middle position: ST ANDBY The right position: ON In the “ST ANDBY” position ...

  • Azden 211R - page 10

    Removing the 31XT : Push down on the release button and pull out. (1) T urn the bottom half of the case counter -clockwise until it is completely off. (2) Insert one fresh alkaline “AA” battery into the compartment. Make sure battery polarity is correct. Replace the bottom half of the case and turn clockwise until snug. DO NOT OVER TIGHTEN. (3) ...

  • Azden 211R - page 11

    (3) The frequency label indicates what frequency (in MHz) the transmitter broadcasts on. The AZDEN receiver in use must also be on the same frequency . (4) 3 Position Switch The bottom position: OFF The middle position: ST ANDBY The top position: ON In the “ST ANDBY” position, the audio is muted. (5) LED indicator T urns RED when the switch is ...

  • Azden 211R - page 12

    (2) Insert one fresh Alkaline 9-volt battery into the compartment. Make sure the battery polarity is correct. (3) Frequency Label The Frequency label indicates what frequency (in MHz) the transmitter broadcasts on. The AZDEN receiver in use must also be on the same frequency . (4) 31IT 1/4-inch plug Plugs into output on electric guitars and keyboar ...

  • Azden 211R - page 13

    the receiver to a mic/line input on your audio mixer or amplifier . Plug the receiver’ s AC adaptor into the 12V input jack on the receiver , and then plug it into the 110-120 V AC electrical outlet. W ith the volume of your mixer or amplifier set to minimum level, turn your system’ s power on. Turn on the transmitter(s). Make sure all LEDs on ...

  • Azden 211R - page 14

    SPECIFICA TIONS OVERALL Frequency Range: VHF 169 -216MHz W orking Range: Up to 300 feet Distortion: Less than 1% (15kHz deviation) Frequency Response: 40Hz to 15kHz, 3dB Dynamic Range: Better than 100dB S/N Ratio: Better than 95dB Operating T emperature: 0 ° – 45 ° C (32 ° – 1 13 ° F) Noise Reduction: 2:1 logarithmic compressor/expander Osc ...

  • Azden 211R - page 15

    (14) ...

Fabbricante Azden Categoria Headphones

I documenti che otteniamo dal fabbricante del dispositivoAzden 211R possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Azden
- manuali per l’uso 211R
- schede prodotto Azden
- opuscoli
- o etichette energetiche Azden 211R
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Azden 211R.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Azden 211R, manuali di manutenzione, brevi manuali o manuali utente Azden 211R. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Azden 211R.

Manuali per l’uso simili

Manuale completo del dispositivo Azden 211R, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Azden 211R dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Azden 211R.

Il manuale per l’uso completo Azden, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Azden 211R - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Azden 211R, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Azden 211R che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Azden 211R - che ci dovrebbe aiutare nei primi passi durante l'uso Azden 211R
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Azden 211R
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Azden 211R in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Azden 211R?

Utilizza il modulo sottostante

Se non hai risolto il problema con Azden 211R con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Azden 211R è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Commenti (0)