-
Nilfisk-ALTO S12 - page 1
Form No. 70250A 7/01 Clarke Technology Printed in th e U.S.A. READ THIS BOOK This book has important information for the use and safe operation of this machine. Failure to read this book prior to operating or attempting any service or maintenance procedure to your ALTO machine could result in injury to you or to other personnel; damage to the machi ...
-
Nilfisk-ALTO S12 - page 2
Page -2- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual T able of Contents Operator Safety Instructions ................................................................................... 3 Grounding Instructions ............................................................................................ 5 Consignes de sécurité ...
-
Nilfisk-ALTO S12 - page 3
Page -3- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual OPERA TOR SAFETY INSTRUCTIONS WARNING AVERTISSEMENT ADVERTENCIA For the safe operation of this machine, read and understand all dangers, warnings and cautions. Look for these symbols: DANGER : If you do not follow the instructions in a DANGER , severe bodily injury or death c ...
-
Nilfisk-ALTO S12 - page 4
Page -4- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual SA VE THESE INSTRUCTIONS W ARNING: T o reduce the risk of fire, electric shock, or injury: 16. Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt. 17. Do not use to pick up flammable or combustible liq ...
-
Nilfisk-ALTO S12 - page 5
Page -5- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual GROUNDING INSTRUCTIONS Preparation: The following are instructions for connection to the power supply and the electrical ground. This machine must be connected to the electrical ground to protect the operator from electrical shock. The machine has an approved power cord with ...
-
Nilfisk-ALTO S12 - page 6
Page -6- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual CONSIGNES DE SÉCURITÈ DE L'UTILISA TEUR A VERTISSEMENT Pour utiliser cet appareil en toute sécurité, il faut lire et coprendre tous les consignes de danger, d'avertissement et d'attention. Soyez attentif aux symboles que voici. DANGER : Ne pas respecter les ...
-
Nilfisk-ALTO S12 - page 7
Page -7- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual 16 . Ne remassez pas de objets qui brûient ou fument comme les cigarettes, les allumettes ou les cendres chaudes. 17. Les poulies de la courroie peuvent devenir chaudes pendant l'utilisation normale. Pour prévenir des brûlures, évitez de toucher la poulie lors de l&a ...
-
Nilfisk-ALTO S12 - page 8
Page -8- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual INSTRUCTIONS VISANT LA MISE A LA TERRE PREP ARA TION: Consignes pour brancher l'appareil a la source d'energie et pour la mise à la terre. Cet appareil doit être mise à la terre afin d'eviter le risque de choc électrique. Cet appareil est pourvu d'un c ...
-
Nilfisk-ALTO S12 - page 9
Page -9- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual HOW TO PREP ARE THE MACHINE FOR OPERA TION Assemble the Handle Attach upper (A) and lower (B) handle to handle socket (C) by aligning holes and securing with 2 part screws (D). See figure 1. Inst all the Bag Assembly Position the bag coupling into the left bag support (A) and ...
-
Nilfisk-ALTO S12 - page 10
Page -10- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual MAINTENANCE This section describes the procedures that must be done by the operator . W ARNING: T o prevent injury , always turn off the switch and remove the electrical plug from the electrical outlet before changing the brush, belt, or filter bag and before leaving the mac ...
-
Nilfisk-ALTO S12 - page 11
Page -11- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual MAINTENANCE (CONT .) 9. Place the rubber end cap covers over both end caps (flat side against end cap). Align holes and secure. Then, slant the brush roll forward so the end caps are in line with the slots in the cleaner base. Push the brush roll into the base until seated. ...
-
Nilfisk-ALTO S12 - page 12
Page -12- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual Steel Core Brush W ARNING: T urn off the switch and disconnect unit from electrical supply before replacing brush strips. 1. New brush strips inserts are supplied in set s. T o replace, first disconnect the machine from the electrical outlet. 2. Remove the brush roll, see th ...
-
Nilfisk-ALTO S12 - page 13
Page -13- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual Symphony Upright Vacuum Wiring Diagram 11/00 CLARKE TECHNOLOGY TROUBLE SHOOTING GUIDE PROBLEM POSSIBLE CAUSE SOLUTION Motor does not run. 1) Not firmly plugged in. 1) Check attachment plug. 2) Bad On-Off switch. 2) Replace switch. 3) Line open. 3) Replace cord. 4) Motor open ...
-
Nilfisk-ALTO S12 - page 14
Page -14- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual CLARKE TECHNOLOGY Symphony Upright Vacuum Collector Cup Assembly Drawing 7/01 108 ...
-
Nilfisk-ALTO S12 - page 15
Page -15- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual Ref. Part No. Description Qt y 2 80065A Screw (M4 *10) 1 26 56489A Screw (M4 *15) 2 3 3 1 E-clip (E6) 5 35 56485A Screw (M4 * 8) 3 70 30138A Handle Grip 1 71 51240A Handle Assembly, Upper 1 72 30143A Bag Hook 1 73 30144A B a g R e t a i n e r 1 74 30142A Cord Retainer, Upper ...
-
Nilfisk-ALTO S12 - page 16
Page -16- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual Symphony Upright Vacuum Base Assembly Drawing 1/01 CLARKE TECHNOLOGY ...
-
Nilfisk-ALTO S12 - page 17
Page -17- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual Ref. Part No. Description Qty. 1 51229A Hood and Graphics 1 2 80065A Screw (M4 *10) 2 3 51949A Cable Clip 1 4 80066A Screw (M4* 18.5) 6 5 Washer (4.2 *12*1) 4 6 51348A Motor Assembly 1 7 51230A Motor Exhaust (LH) 1 8 30161A Exhaust Foam 2 9 40178A Power Switch 1 10 51245A Sw ...
-
Nilfisk-ALTO S12 - page 18
Page -18- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual CLARKE TECHNOLOGY Symphony Upright Vacuum Handle and Filter Bag Assembly Drawing 7/01 ...
-
Nilfisk-ALTO S12 - page 19
Page -19- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual Ref. Part No. Description Qt y. 26 56489A Screw (M4*15) 2 3 3 1 E-Clip (E6) 5 35 56485A Screw (M4*8) 3 70 30138A Handle Grip 1 71 51240A Handle Assembly - Upper Chrome 1 72 30143A Bag Hook 1 73 30144A B a g R e t ainer 1 74 30142A Cord Retainer- Upper 1 7 5 Screw (M4*25) 3 7 ...
-
Nilfisk-ALTO S12 - page 20
Page -20- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual NOTES ...
-
Nilfisk-ALTO S12 - page 21
Page -21- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual AL T O ® PRODUCT SUPPORT BRANCHES PRODUCTION F ACILITIES AL TO Danmark A/S , Aalborg Blytaekkervej 2 DK-9000 Aalborg +45 72 18 21 00 AL T O Danmar k A/S, Hadsund Industrikvar teret DK-9560 Hadsund +45 72 18 21 00 SALES SUBSIDIARIES AL TO Canada Ltd., Re xdale Ontario 24 Con ...
-
Nilfisk-ALTO S12 - page 22
Page -22- CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual CLARKE TECHNOLOGY U.S. W ARRANTY This Clarke Industrial/Commercial Product is warranted to be free from defects in materials and work- manship under normal use and service for a period of one year from the date of purchase, when operated and maintained in accordance with Cla ...
Hai una domanda su Nilfisk-ALTO S12?
Utilizza il modulo sottostante
Se non hai risolto il problema con Nilfisk-ALTO S12 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Nilfisk-ALTO S12 è probabile che voglia condividere il modo di risolverlo.