-
American Audio Professional Power Amplifier - page 1
User Instructions AMERICAN AUDIO ® 4295 Charter Street Los Angeles Ca. 90058 Revised 02/02 Pr ofessional Power Ampli ers ? ...
-
American Audio Professional Power Amplifier - page 2
This symbol is intended to alert the user to the presence of non insulated "danger ous voltage" within the product's enclosur e that may be of suf cient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user of the presence of important operating and maintenance (servicing) instructi ...
-
American Audio Professional Power Amplifier - page 3
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER. THERE ARE NO USER SERVICEABLE P ARTS INSIDE. REFER ALL SERVICE TO YOUR AUTHORIZED AMERICAN AUDIO ® DEALER. CAUTION Do not open - risk of electric shock FOR OPTIMUM PERFORMANCE AND RELIABILITY DO NOT PRESENT THE AMPLIFIER WITH A SPEAKER LOAD OF LESS THAN 2 OHMS OR ANY COMBINA T ...
-
American Audio Professional Power Amplifier - page 4
Important Pr ecautions • T o reduce the risk of electrical shock or r e, do not expose this unit rain or moisture • Do not spill water or other liquids into or on to your unit • Do not attempt to operate this unit if the power cord has been frayed or broken • Do not attempt to remove or br eak of f the ground pr ong from the electrical ...
-
American Audio Professional Power Amplifier - page 5
FRONT P ANEL 1. Power Switch - This switch controls the units main power . 2. Channel 1 Limiter Switch (V2000 & V3000 Only) - This is used to activate the channels built-in limiter . The limiter reduces the average output level when the signal begins to distort, this process is designed to reduce distortion and pr otect the speakers. See limite ...
-
American Audio Professional Power Amplifier - page 6
V1000 plus V1000 plus V1000 REAR P ANEL 1. Channel 2 Input - Connect the input source for channel two to either the balance XLR or the balanced/unbalanced 1/4” input jacks. The 1/4” TRS plug is configured as follows; Tip is positive, Ring is negative and Sleeve is ground. The XLR jack is configur ed as follows; Pin three positive, pin two negat ...
-
American Audio Professional Power Amplifier - page 7
V2000 plus V2000 plus V2000 REAR P ANEL 1. Cooling Fan - Dual speed cooling fans. These fans are used to cool the inter nal parts of the amplifier . Never block the fan grills in any way or mount in an en- close rack, doing so may cause the amplifier to overheat and fail. 2. Channel 2 Input - Conne ct the inpu t sour ce for channel two to either th ...
-
American Audio Professional Power Amplifier - page 8
V3000 plus V3000 plus V3000 REAR P ANEL 1. Cooling Fan - Dual speed cooling fans. This fans are used to cool the internal parts of the amplifier when in use. Never block the fan grills in any way or mount in an enclose rack, doing so may cause the amplifier to overheat and fail. 2. Channel 2 Subwoofer Mode On/Off Switch - This switch activates the ...
-
American Audio Professional Power Amplifier - page 9
Unbalanced TS 1/4” Unbalanced TS 1/4” Plug Plug Hot (+) Ne gati ve (-) Balanced TRS 1/4 Balanced TRS 1/4 ” Plug Ground/Shield Hot (+) Ne gati ve (-) 2 Hot (+ data) 3 Ne gati v e (- data) 1 Ground/Return/ 0v) 1 2 3 Male XLR Pin Con gu Male XLR Pin Con gu Male XLR Pin Con ration: US ITT Standar d OUTPUTS: Binding Post/Banana Plug - Con ...
-
American Audio Professional Power Amplifier - page 10
Bar e Wire Connections: When connecting your speakers to the amplifier using bar e wire; Unscrew the red and black caps on the binding post, be sure not to completely remove or unscrew the red and black caps. Strip back the wire insulation 1/2” (13mm). Insert the bare wir e into the hole that was reveled by unscr ewing the binding post cap. After ...
-
American Audio Professional Power Amplifier - page 11
TYPICAL MONO BRIDGE SET -UP SPEAKERS 8 OHM MINIMUM T ypical Stereo Output Connections T ypical Stereo Output Connections Diagram 14 Diagram 13 SPEAKERS 4 OHM MINIMUM SPEAKERS 4 OHM MINIMUM 1000 W A 1000 W A 1000 W TTS A TTS A BRIDGE MONO 120V~60Hz 6 A M P CAUTION 4 OHM S M IN IMU M IMP EDA NC E P RE CH ANN EL 4 OHM S M IN IMU M IMP EDA NC E P RE CH ...
-
American Audio Professional Power Amplifier - page 12
1 2 3 4 T ypical Ster eo Set-Up T ypical Mixer V3000 plus V3000 plus V3000 series (Rear View) T ypical Speaker Connect to Vplus series Channel One Output T ypical Speaker Connect to Vplus series Channel T wo Output Output Diagram 15 American Audio ® - www .americandj.com - V plus - www .americandj.com - V plus - www .americandj.com - V Series Ampl ...
-
American Audio Professional Power Amplifier - page 13
OPERATING MODES: Stereo Operation - Page 10/Figure 9 details an example of a typical stereo set-up. Connect your inputs into channels one and two of the amplifier. Connect your speakers to the outputs on the rear of the amplifier. Be sure that your front gain controls are turned down to their lowest level (full counter-clockwise). Turn your amp on. ...
-
American Audio Professional Power Amplifier - page 14
goes into pr otect mode, the other side will continue to operate normally . During short circuit pr otection, the "Clip" LED and “Pr otect" LED will light simultaneously indicating amplifier fault. All channel output during the “Short Circuit Pr otection" will be interrupted (i.e. no sound output). Short Circuit Pr otection ...
-
American Audio Professional Power Amplifier - page 15
Output Power: 2 ohms, 1 khz 1% THD 2 ohms, 1 khz 1% THD 2 ohms, 1 khz 1% 4 ohms, 1khz, 1% 4 ohms, 1khz, 1% 4 ohms, 1khz, 1% THD 8 ohms, 1khz 1% THD 8 ohms, 1khz 1% THD 8 ohms, 1khz 1% (Bridge Mode, mono) 4 ohms, 1khz, 1% THD 4 ohms, 1khz, 1% THD 4 ohms, 1khz, 1% 8 ohms, 1khz, 1% THD 8 ohms, 1khz, 1% THD 8 ohms, 1khz, 1% Dimensions & W Dimension ...
-
American Audio Professional Power Amplifier - page 16
©American Audio® American Audio® is part American DJ® Group of Companies American DJ® W orld Headquarters: 4295 Charter Street Los Angeles, CA 90058 USA T el: 323-582-2650 / Fax: 323-582-2610 web: www .americandj.com / e-mail: info@americandj.com ...
Hai una domanda su American Audio Professional Power Amplifier?
Utilizza il modulo sottostante
Se non hai risolto il problema con American Audio Professional Power Amplifier con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con American Audio Professional Power Amplifier è probabile che voglia condividere il modo di risolverlo.