-
Smeg JGB92XD1W - page 1
Contents 25 INSTRUCTIONS FOR THE INSTA LLER: these are for the qualified technician who must carry out a suitable check of the gas system, install the appliance, set it functioning and carry out an inspection test. INSTRUCTIONS FOR THE USER: these contain user a dvice, description of the commands and th e correct procedures for cleaning and mainten ...
-
Smeg JGB92XD1W - page 2
Introduction 26 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND TH EREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PL ACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE READING THIS MANUAL AND ALL TH E INSTRUCTIONS THEREIN BEFORE USING THE COOKER. ALSO KEEP THE SERIES OF NOZZLES SUPPLIED. I ...
-
Smeg JGB92XD1W - page 3
Introduction 27 LOWER THE GLASS COVER SLOWL Y AND BY HAND. WARNING: THE GLASS COVER MAY SHATTER IF IT OVE RHEATS. SWITCH OFF ALL RINGS AND WAIT FOR THEM TO COOL DO WN BEFORE CLOSING THE COVER. DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO TOUCH THE HEATING ELEMENTS INSIDE THE OVEN. THE APPLIANCE IS DESI GNED FOR USE BY ADULTS . DO NOT ...
-
Smeg JGB92XD1W - page 4
Instruction for the installer 28 2 INSTALLATION OF THE APPLIANCE It is the law that all gas applia nces are installed by competent persons . Corgi gas i nstallers ar e approved to work to safe and satisfactory standards . All gas installation, servicing and repair wor k must be in accordance with the gas safety regul ation s 1984 (instal lation and ...
-
Smeg JGB92XD1W - page 5
Instruction for the installer 29 2.1 Electrical connection Make sure that the power line voltage matche s the specifications indicated on the ratin g plate located inside the storage compartment. This rating plate must never be remo ved. If the appliance is hooked-up to the sup ply by means of a fixed connection, in stall a multipolar cut-out devic ...
-
Smeg JGB92XD1W - page 6
Instruction for the installer 30 2.3 Connecting to natural and LPG gas (Please see connection diagram) Make the connection to the appliance usin g flexible bayonet style hose in accordance to B.S. 669. T he hose connecti on at the rear of the applian ce has a ½” BSP internal thread. Please use seal C between the flexible con nection L and the ap ...
-
Smeg JGB92XD1W - page 7
Instruction for the installer 31 3 ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work , detach the appliance from the electrical socket. The cooker hob is set for natur al gas G20 (2H) at a pressure of 20 mbar for cooke rs with maxi oven, and for LPG G30/G31 (3 +) at a pressure of 28/37 mbar for cookers with gas ...
-
Smeg JGB92XD1W - page 8
Instruction for the installer 32 3.2 Burner and nozzle characteristics table (60 cm. models) Burner Rated heating capacity (kW) LPG – G30/G31 28/37 mbar Nozzle diameter 1/100 mm By-pass mm 1/100 Reduced flowrate (W) Flowrate g/h G30 Flowrate g/h G31 Auxiliary 1.0 50 30 350 73 71 Semi-rapid 1.75 65 33 450 127 125 Rapid (3) 3.0 85 45 800 218 214 Ra ...
-
Smeg JGB92XD1W - page 9
Instruction for the installer 33 3.3 Burner and nozzle characteristics table (90 cm. models) Burner Rated heating capacity (kW) LPG – G30/G31 28/37 mbar Nozzle diameter 1/100 mm By-pass mm 1/100 Reduced flowrate (W) Flowrate g/h G30 Flowrate g/h G31 Auxiliary 1 50 30 350 73 71 Semi-rapid 1.75 65 33 450 127 125 Rapid 3 85 45 800 218 214 Triple cro ...
-
Smeg JGB92XD1W - page 10
Instruction for the installer 34 3.4 Arrangement of burners on cooking hob BURNERS 1. Auxiliary 2. Semi-rapid 3. Rapid (60 X 60) 4. Triple crown 5. Rapid (60 X 50) 3.5 Arrangement of burners on cooking hob BURNERS 1. Auxiliary 2. Semi-rapid 3. Rapid 4. Triple crown 5. Large electric hob (1500W) 6. Small electric hob (1000W) 7. Fish pan 8. Triple cr ...
-
Smeg JGB92XD1W - page 11
Instruction for the installer 35 3.6 Adjustment of the oven burne r (only for gas oven models) To adjust the oven burners follow the p rocedure described be low from inside the oven: • Open the oven door; • Remove the oven dish and shelf. • Lift up the oven floor and remove. 3.6.1 Replacement of the oven burner nozzle • Loosen the fixing sc ...
-
Smeg JGB92XD1W - page 12
Instruction for the installer 36 4 FINAL OPERATIONS After replacing the nozzles, reposition th e flame- spreader crown s, the burner caps and the grids. Following adjustment to a gas othe r than the preset one, replace the gas adjustment label fixed to th e appliance with the one correspondi ng to the new gas. This label is in the packet together w ...
-
Smeg JGB92XD1W - page 13
Instruction for the user 37 5 DESCRIPTION OF FRONT PANEL CONTROLS All the oven controls are groupe d together on t he front panel. The table below provide s a description of the symbols used. FRONT RIGHT BURNER GAS OVEN THERMOSTAT KNOB BACK RIGHT BURNER OVEN LIGHT / ROTISSERIE / GRILL SWITCH BACK LEFT BURNER BURNER IGNITION BUTTON FRONT LEFT BURNER ...
-
Smeg JGB92XD1W - page 14
Instruction for the user 38 OVEN LIGHT SWITCH (CERTAIN MODELS ONLY) This switch allows the light inside the oven to be switched on at any moment. Tramite questo tasto è anche possibile far pa rtire il motorino girarrosto.. MINUTE COUNTER K NOB (CERTAIN MODELS ONLY) Turn clockwise to wind up the alarm and set to the desired time. Time is expressed ...
-
Smeg JGB92XD1W - page 15
Instruction for the user 39 6 USE OF THE COOKING HOB 6.1 Lighting of the cooking hob burners Before lighting the hob burners check that the flam e caps are in the correct position and that thei r burner caps are in place, making sure that the holes A in the flame caps correspond to the spark plug s and thermocouples. Before lighting the burners lif ...
-
Smeg JGB92XD1W - page 16
Instruction for the user 40 6.3 Diameter of containers (60 cm. models) BURNERS (60 X 50) 1. Auxiliary 2. Semi-rapid 5. Rapid Ø min. and max. (in cm. ) 12 – 14 16 – 22 18 – 24 BURNERS (60 X 60) 1. Auxiliary 2. Semi-rapid 3. Rapi d 4. Triple crown Ø min. and max. (in cm. ) 12 – 14 16 – 24 18 – 26 18 – 26 6.4 Diameter of containers (90 ...
-
Smeg JGB92XD1W - page 17
Instruction for the user 41 6.5 Switching on the electric hob 6.5.1 Switching on the electric hobs The cookers are equipped with hob s of different di ameters. These are controlled by a switch and are turned on by turning the knob to the desired positi on. On the front panel above each knob a small drawing shows whi ch hob corresponds to each knob ...
-
Smeg JGB92XD1W - page 18
Instruction for the user 42 7 USE OF THE OVEN For those models with electronic programmer, before using the ove n make sure that th e display shows the symbol . For those models with analogue clock and timer, place on the symbol . 7.1 Warnings and general advice Using the oven and the grill for the first time , heat them to the maximum temperature ...
-
Smeg JGB92XD1W - page 19
Instruction for the user 43 7.4 Use of the electric grill 7.4.1 Using the grill in cookers with electric oven Having opened the o ven door, press the knob and turn it clockwise to the grill position, placing a lit match to the burner on the roof of the oven. Once the burner is lit, hold the knob down for about 10 seco nds. If the burner does not st ...
-
Smeg JGB92XD1W - page 20
Instruction for the user 44 How to use the grill Once the grill is lit, the red wa rni ng light will come on. Leave th e oven to heat up for five minutes before placing the food inside. Food should be flavoured and ba sted with oil or melted butter before cooking. An oven dish should be used to contain the sauces. The food should be placed on the o ...
-
Smeg JGB92XD1W - page 21
Instruction for the user 45 7.5 Use of the gas grill 7.5.1 Manual lighting of the gas grill burner Having opened the o ven door, press the knob and turn it clockwise to the grill position, placing a lit match to the burner on the roof of the oven. Once the burner is lit, hold the knob down for about 10 se co nds. If the burner does not stay lit aft ...
-
Smeg JGB92XD1W - page 22
Instruction for the user 46 8 ELECTRONIC PROGRAMMER (ONL Y ON EQUIPPED MODELS) LIST OF FUNCTIONS MINUTE-COUNTER KEY COOKING TIME KEY END-OF-COOKING KEY DECREASE TIME KEY INCREASE TIME KEY 8.1 Clock adjustment When using the oven for the first tim e, or after a power failure, the di splay flashes re gularly and indicates . P ress the keys and at the ...
-
Smeg JGB92XD1W - page 23
Instruction for the user 47 8.4 End of cooking When cooking is over, the oven w ill automatically swit ch off and, at the same time, an intermittent alarm will sound. After swit ching off the alarm, the display will once again show the rig ht time together with the symbol , indicating that the oven has returned to manual operation mode. 8.5 Minute ...
-
Smeg JGB92XD1W - page 24
Instruction for the user 48 9 DIGITAL TIMER (CERTAIN MODELS ONLY) This component allows an on -off beeper to be set to indicate the end of the cooking time. It is therefore just a timer, wi th no programming functions. LIST OF FUNCTIONS TIME-SETTING BUTTON VALUE DECREASE BUTTON VALUE INCREASE BUTTON 9.1.1 Setting the time When the oven is used for ...
-
Smeg JGB92XD1W - page 25
Instruction for the user 49 11 CLEANING AND MAINTENANCE 11.1 Cleaning stainless steel and enamelled versions To maintain stainless steel in good condition it must be cleaned regularly a fter each use, once it ha s cooled down. 11.1.1 Ordinary Daily Cleaning To clean and preserve the stainle ss steel surface s, always use only specific p roducts tha ...
-
Smeg JGB92XD1W - page 26
Instruction for the user 50 11.2.2 Grids Remove the grids and clean them in warm water with a non-abrasive dete rgent, taking care to remove any incrustations. Replace them on the cooking ho b. Continuous contact of the grids with the flame can cause the paint near the hot areas to be altered. This is completely natural and does not compromise the ...
-
Smeg JGB92XD1W - page 27
Instruction for the user 51 12 EXTRAORDINARY MAINTENANCE The oven may req uire extraordinary maintena nce or replacement of parts subject to wear such as seals, bulbs, and so on. The following i nstructions describe how to carry out these minor maintenance operations. Before any intervention, disconnect the power supply of the device. 12.1 Lubricat ...
Hai una domanda su Smeg JGB92XD1W?
Utilizza il modulo sottostante
Se non hai risolto il problema con Smeg JGB92XD1W con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Smeg JGB92XD1W è probabile che voglia condividere il modo di risolverlo.