-
Autostart AS-6205 SH - page 1
Notice The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of the product, be that either damage to the vehicle itse lf or to the Unit. This Unit must be installed by a certified technician using all safety devices supplied. Please note that this guide has been written for properly trained A ...
-
Autostart AS-6205 SH - page 2
P.2 Installation Guide AS-6205 SH Table of Contents Introduction ..................................................... 3 Included in the Package ................................. 3 Before You Get Started … ............................... 4 Installation Points To Remember ................... 4 Harness Description .................................. ...
-
Autostart AS-6205 SH - page 3
AS-6205 SH In stallation Guide P.3 Introduction This Guide contains all informatio n pertinent to the in stallation. Most (if not all) feat ures are grouped in the U ser Guide and therefor e, should you need information on a feat ure, you should refer to the User Guide Included in the Package Please review the Installat ion Guide before beginni ng ...
-
Autostart AS-6205 SH - page 4
P.4 Installation Guide AS-6205 SH Before You Get Started … Ƈ On vehicles with a ma nual Transmission, always ensure that all Doors will get the Unit o ut of Ready Mode. Switch the wire used so that it is triggered by all Doors. Ƈ Make sure that the Parking Brake and Door Switch contacts work properly. Ƈ When working on a veh icle, always leave ...
-
Autostart AS-6205 SH - page 5
AS-6205 SH In stallation Guide P.5 6-Pin Main Ignition Harness Wire Description A RED +12 V Battery Connect to the largest 12 V supply wire at the Ignition harness. Ensure that the OEM power wire is fused for mor e than 30 A. NOTE: certain new vehicles have no su itabl e 12 volts source at the IGNITION switch (the 12 Volt wire is too sm all to supp ...
-
Autostart AS-6205 SH - page 6
P.6 Installation Guide AS-6205 SH “under crank”. 3 GRAY (-) Hood Switch input Connect this wire to t he Hood Pin-switch s upp lied. This input will disable or shut down the Remote Starter when the Hood is opened. It is also used for programming and therefore it is essential th at it is installed. 4 ORANGE (+) Brake Switch input This wire must b ...
-
Autostart AS-6205 SH - page 7
AS-6205 SH In stallation Guide P.7 7 WHITE / ORANGE (–) Starter Kill output The unit is equipped wit h a selectable passi ve- or active-arming Starter Kill circuit that will immobilize the vehicle when the system is armed. This wire will provide a constant 500-mA negative out put when the system is armed (locked by remote) or if remote started. T ...
-
Autostart AS-6205 SH - page 8
P.8 Installation Guide AS-6205 SH 12 YELLOW (+) Glow- plug Light input This positive input will monit or the Glow Plug Light in Diesel Mod e: it will wait until the Glow Plug Light goes out to crank the En gine. Connect to the side of the Glow Plug Li ght that is positive when the Light is on. Note : In Diesel Mode there is a 18-s ec. crank timing ...
-
Autostart AS-6205 SH - page 9
AS-6205 SH In stallation Guide P.9 output ON for a 30-second cycle and shuts off automatically unless the user presses LOCK and UNLOCK before the end of that cycle, at which point, the AUX2 output shuts off. x This output can also be us ed as Priority Door Unlock. Car Finder is enabled or disabled in the AUX 2 functi on programming. 2 YELLOW (-) Pa ...
-
Autostart AS-6205 SH - page 10
The Programming Assistance Button (A.k.a. PAB.) The PAB is located on the side of the Mod ule. This push button mimic s the Hood-Pin switch in order to avoid having to get out of the vehicle and pr essing the Hood-Pin switch. The PAB will work only when the Hood is up. How to Program the Transmitter. 1. FLASH the Hood Pin Switch. Before the 20 seco ...
-
Autostart AS-6205 SH - page 11
AS-6205 SH In stallation Guide P.11 The Module can only be programmed Function by Function . After selecting a Mode (from 1 to 3), you will be taken to the first Function of that Mode. After entering an Option number for Function 1, you will be automatically taken to Function 2, and so on; therefore, be ready to re-enter all option n umbers for all ...
-
Autostart AS-6205 SH - page 12
P.12 Installation Guide AS-6205 SH x All Doors unlock upon the 2 nd , 4 th , 6 th … pressing of the UNLOCK button. Mode 2 *indicates default setting Function 1 – Home Valet Mode OPTION 1 Home Valet enabled OPTION 2* Home Valet disabled OPTION 3 Home Valet disabled Function 2 – Safe Start OPTION 1 Safe Start enabled OPTION 2* Safe Start disabl ...
-
Autostart AS-6205 SH - page 13
AS-6205 SH In stallation Guide P.13 OPTION 2* Ignition Valet - ENABLED OPTION 3 Ignition Valet - ENABLED Horn Honk / Siren Timing (Optional) 1. Make sure that Mode 3 Function 4 Option1 or Option 3 is activated. 2. FLASH the Hood Pin Switch Before the 20 seconds have passed, 3. Press and hold the Brake Pedal. x Press the START and UNLOCK buttons sim ...
-
Autostart AS-6205 SH - page 14
P.14 Installation Guide AS-6205 SH Table 5 Multi-Speed Tach Progra mming No manual adjustments ar e necessary. However, you should go through the Tach programming pr ocedure every time a new Uni t is installed. 1. FLASH the Hood Pin Switch . 2. Press and hold the Brake Pedal. x Press the LOCK and UNLOCK buttons simultaneously on the Transmitter. x ...
-
Autostart AS-6205 SH - page 15
AS-6205 SH In stallation Guide P.15 Away. A medium “tap” should trigger the Warn Away. A hard “tap” should trigger the Alarm. x All vehicles are different and th erefore tra nsmit shock level diff erently, if you are unable to set b oth zones to your satisfaction, referrer to p.12 ( Function 4 – Shock Sense / Warn Away x ) to disable the ...
-
Autostart AS-6205 SH - page 16
Caution! Do not use mor e than one of t he three sets of jumper pins simultaneously. The relay output rating on this Un it is 25A max output. Defective OEM solenoid switches can sometimes draw up to 50 or 60A, caus ing the 30A fuse to blow. Using a digital voltm eter, check the Starter wire for amperage when vehicle is crank ing. Ignition-Controlle ...
-
Autostart AS-6205 SH - page 17
AS-6205 SH In stallation Guide P.17 Safe Start (Child Safety Mode) ( OFF by default.) Requires the user presses the S TART button on the Tr ansmitter twice within 3 seconds in order to start the vehicle. If the Special Safe Start Mode is select ed (SWAP Start): x To start the vehicle, press the LOCK and UNLOCK butt ons simultaneously. x Pressing th ...
-
Autostart AS-6205 SH - page 18
P.18 Installation Guide AS-6205 SH Disarmed Notification This feature will notify the user whe n the vehicle is left disarmed after Ig nition is turned off, or when the Module i s disarmed after being prev iously armed, the opening or closing of a Door will cause the Horn or the Siren to sound on ce after 10 sec. to warn the user that the vehicle w ...
-
Autostart AS-6205 SH - page 19
AS-6205 SH In stallation Guide P.19 10 x = Alarm condition Intrusion Codes 1 x = Power-up Reset: Battery disconnected / reconnected or dead… 2 x = Doors intrusion 3 x = Shock Sense 4 x = Hood 5 x = Panic 6 x = Ignition Note: “x” stands for one flash of the Parking Lights Intrusion Codes via LED light If there has been an intrusion in th e veh ...
-
Autostart AS-6205 SH - page 20
P.20 Installation Guide AS-6205 SH Diagnostics - Parking Lights Flash Rate Flashes Description 1 x Doors locked, Starter Kill armed. x End of Run Time. x TRUNK button pressed x START signal received by the Module. x Cold Weather Mode cancelled. x Cannot start after maximum number of attempts is reached. 2 x Run Time cancelled. x Remote start att em ...
Hai una domanda su Autostart AS-6205 SH?
Utilizza il modulo sottostante
Se non hai risolto il problema con Autostart AS-6205 SH con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Autostart AS-6205 SH è probabile che voglia condividere il modo di risolverlo.