-
Extron electronic SCP 150L - page 1
User ’ s Manual Extron Electronics, USA 1230 South Lewis Street Anaheim, CA 92805 USA 714.491.1500 Fax 714.491.1517 Extron Electronics, E urope Beeldschermweg 6C 3821 AH Amersfoort The Netherlands +31.33.453.4040 Fax +31.33.453.4050 Extron Electronics, Asia 135 Joo Seng R oad, #04-01 PM Industrial Building Singapore 368363 +65.6383.4400 Fax +65.6 ...
-
Extron electronic SCP 150L - page 2
Precautions This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the product's enclosure that may present a risk of electric shock. Caution Read In ...
-
Extron electronic SCP 150L - page 3
i SCP 150 • Table of Contents Chapter 1 • Introduction .......................................................... 1- 1 About the SCP 150, SCP 150 AAP , and SCP 150 L . 1-2 Features ...................................................................................... 1- 2 Chapter 2 • Installation and Operation .......................... 2- 1 ...
-
Extron electronic SCP 150L - page 4
ii SCP 150 • Table of Contents T able of Contents, cont’d SCP 150 1 Chapter One Introduction About the SCP 150, SCP 150 AAP, and SCP 150L Features All trademarks mentioned in this manual are the properties of their respective owners. 68-717-01 Rev. A 03 05 Accessories ............................................................................. ...
-
Extron electronic SCP 150L - page 5
SCP 150 • Introduction Introduction SCP 150 2 Chapter T wo Installation and Operation Installation Overview Installing or Replacing Button Labels Mounting Options UL Requirements Preparing the Site Installing the Electrical Box Cabling the Rear Panel Pre-installation Testing/Troubleshooting Mounting the SCP Front Panel Features Resetting to Facto ...
-
Extron electronic SCP 150L - page 6
SCP 150 • Installation and Operation SCP 150 • Installation and Operation Installation and Operation Installation Overview T o install and set up an SCP 150, SCP 150 AAP , or SCP 150L, follow these steps: 1 T urn the equipment off. Make sure that the SCP and the System 5 IP switcher ar e disconnected from the power sour ce. 2 Run cables through ...
-
Extron electronic SCP 150L - page 7
SCP 150 • Installation and Operation SCP 150 • Installation and Operation Installation and Operation, cont’d 2-5 2-4 T o mount the SCP 150 in areas of walls or furniture without studs, use an optional Extron 2-gang mounting bracket, part #70-086-01, -1 1, or -21. For the SCP 150 AAP , use an Extro n 4-gang mounting bracket, part #70-086-03, - ...
-
Extron electronic SCP 150L - page 8
SCP 150 • Installation and Operation SCP 150 • Installation and Operation Installation and Operation, cont’d 2-7 2-6 Cabling the Rear Panel 1 ON 234 J5 2 1 3 1 Panel address DIP switch — If using two SCPs, set DIP switch 1 to assign a unique address to each panel. Set the switch to Off to assign addr ess 00 and On to assign addr ess 01. Swi ...
-
Extron electronic SCP 150L - page 9
SCP 150 • Installation and Operation SCP 150 • Installation and Operation Installation and Operation, cont’d 2-9 Mounting in a rack The SCP 150 L is rack-mountable using the full rack width UCM-RAAP mounting plate. Mount the UCM-RAAP using the rack mounting screws included with the monting plate. Next, mount the SCP 150 L to the UCM-RAAP usin ...
-
Extron electronic SCP 150L - page 10
SCP 150 • Installation and Operation SCP 150 • Installation and Operation Installation and Operation, cont’d 2-10 Front Panel Features The controls on the SCP 150, SCP 150 AAP , and SCP 150 L replicate the System 5 IP’s volume, input switching, and system controls. All the button functions for the System 5 IP and the SCPs are configured via ...
-
Extron electronic SCP 150L - page 11
SCP 150 • Installation and Operation SCP 150 • Installation and Operation Installation and Operation, cont’d 2-12 approximately 30 feet (9.14 meters) within 40 degrees on either side of the axis. See the following illustration. Extron IR VOLUME PROJECTOR ON PROJECTOR OFF FUNCTION BUTTON LIGHTS ON LIGHTS OFF PC INPUT 1 INPUT 2 INPUT 3 INPUT 4 ...
-
Extron electronic SCP 150L - page 12
SCP 150 • Installation and Operation Installation and Operation, cont’d SCP 150 2-14 3 Chapter Thr ee Remote Communication Setting Up RS-232 Communication Using Simple Instruction Set (SIS) Commands Special Function SIS Commands Using the Switch/Function Button Table Updating the Firmware Extron IR VOLUME PROJECT OR T o reset, press these two b ...
-
Extron electronic SCP 150L - page 13
SCP 150 • Operation SCP 150 • Operation Remote Communication 3-3 3-2 Setting Up RS-232 Communication The RS-232 interface allows you to obtain information about the SCP and to activate certain SCP functions from a host computer or other device (such as a control system) attached to the rear panel RS-232 port (shown below). J1 Gnd Rx Tx 3-pole c ...
-
Extron electronic SCP 150L - page 14
SCP 150 • Remote Communication SCP 150 • Remote Communication Remote Communication, cont’d 3-4 3-5 ASCII to HEX Con version T able • ASCII to Hex conversion table Symbol definitions = CR/LF (carriage return/line feed) (hex 0D 0A) = Soft carriage return (no line feed) Esc = Escape key • = Space X1 = Firmware number If a command is not case ...
-
Extron electronic SCP 150L - page 15
SCP 150 • Remote Communication SCP 150 • Remote Communication Remote Communication, cont’d 3-6 3-7 Command/response table for SIS commands (continued) Command ASCII (T elnet) Response Additional (host to SCP) (SCP to host) information V olume relative function V olume up +V/v V olUp V olume down -V/v V olDn Upload firmware Upload firmware Esc ...
-
Extron electronic SCP 150L - page 16
SCP 150 • Remote Communication SCP 150 • Remote Communication Remote Communication, cont’d 3-8 3-9 Command/response table for special function SIS commands (continued) C o m m a n d ASCII Command Response X? and Y? values (host to SCP) (SCP to host) and additional descriptions Read FPC lamp Y? * 51# Lmp Y? * X? Indicates the LED color of the ...
-
Extron electronic SCP 150L - page 17
SCP 150 • Remote Communication SCP 150 • Remote Communication Remote Communication, cont’d 3-10 3-11 Using the Switch/Function Button T able Switches are assigned to specific buttons on the SCP , any attached remote control module (IRCM/RCM/ACM), or the IR 402 remote. Each time a button is pressed or released, or a knob is turned on the SCP o ...
-
Extron electronic SCP 150L - page 18
SCP 150 • Remote Communication SCP 150 • Remote Communication Remote Communication, cont’d Updating Firmware If necessary , you can replace the SCP’s firmware without changing firmware chips. This procedure must be performed using a PC on which the Firmware Loader Software has been installed. The PC’s RS-232 port must be directly cabled t ...
-
Extron electronic SCP 150L - page 19
SCP 150 • Remote Communication Remote Communication, cont’d SCP 150 A Appendix A Specifications, Part Numbers, Accessories, and Dimensions Specifications Included Parts Accessories Cables Panel Dimensions Templates The firmware update file must have a filename extension of .bin . If the file does not have that extension, it will not work proper ...
-
Extron electronic SCP 150L - page 20
SCP 150 • Specifications, Parts, Accessories, Dimensions SCP 150 • Specifications, Parts, Accessories, Dimensions Specifications, Parts, Accessories, D i m ensions A-3 A-2 Control/remote — control pad Serial control port ........................ RS-232, via a 3.5 mm captive screw connector, 3 pole Baud rate and protocol ............... 9600 b ...
-
Extron electronic SCP 150L - page 21
Specifications, Part s, Accessories, Dimensions, cont’d SCP 150 • Specifications, Parts, Accessories, Dimensions SCP 150 • Specifications, Parts, Accessories, Dimensions Panel Dimensions SCP 150 R. 070 T OP EDGE ALL AROUND. (.10 THK.) Ø.219 THRU wØ.392 x 82° NEAR SIDE .000 2X .576 2X 1.000 1.563 2X 3.858 4.500 .000 .675 2.360 3.925 4.600 4 ...
-
Extron electronic SCP 150L - page 22
Specifications, Part s, Accessories, Dimensions, cont’d SCP 150 • Specifications, Parts, Accessories, Dimensions SCP 150 • Specifications, Parts, Accessories, Dimensions A-7 T emplates The templates are not to scale and are provided for refer ence only. SCP 150 Cut-Out T emplate for Extron's SCP 150 TEMPLA TE IS NO T FULL SIZE. T o insta ...
-
Extron electronic SCP 150L - page 23
Specifications, Part s, Accessories, Dimensions, cont’d SCP 150 • Specifications, Parts, Accessories, Dimensions SCP 150 • Specifications, Parts, Accessories, Dimensions S CP 150 L 6.5" (16.5 cm) Cut-Out T emplate f or Extron's S CM-150L TEMPLA TE IS NO T FULL SIZE. T o install S CP 150 directly into furniture, cut along this line. ...
Hai una domanda su Extron electronic SCP 150L?
Utilizza il modulo sottostante
Se non hai risolto il problema con Extron electronic SCP 150L con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Extron electronic SCP 150L è probabile che voglia condividere il modo di risolverlo.