-
Baumatic B47 - page 1
1 B47SS/BG60/BG61/B60.1SS/ BT61SS 4 burner gas hob. BG60TC/B60.1TCSS 4 burner gas hob with thermocouples. ...
-
Baumatic B47 - page 2
User Manual for your Baumatic B47SS 4 burner gas hob BG60 4 burner gas hob BG61 4 burner gas hob. B60.1SS 4 burner gas hob. BT61SS 4 burner gas hob BG60TC/B60.1TCSS 4 burner gas hob with thermocouples NOTE : This User Instruction Manual contains imp ortant information, including safety & installation p oints, which will enable you to get the mo ...
-
Baumatic B47 - page 3
3 Contents E n v i r o n m e n t a l n o t e 4 Important safety informa tion 5 – 7 Specifications 8 Product & Aperture dimensions 8 Product specifications 8 Standard accessories 8 O p t i o n a l e x t r a s 8 E l e c t r i c a l d e t a i l s 8 G a s d e t a i l s 9 G a s h o b s u r f a c e l a y o u t 9 Using the gas hob 10 B e f o r e f i ...
-
Baumatic B47 - page 4
Environmental note 4 o Baum atic uses are environmentally friendly and can be recycled. o all packaging mate rial with due regard for the environment. The packaging materials that Please discard ...
-
Baumatic B47 - page 5
5 Important safety information Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If yo are unsure of any of the info rmation contained i booklet, pleas u n this e contact the Baumatic Technical ent. e old use and for o in ient temperature o ...
-
Baumatic B47 - page 6
6 hild Safety o d ny time. During and after use, all surfaces will become hot. o se ensure that they are kept under close supervision at all times. o ld only be allowed to utilise the appliance when supervised. eneral Safety C Baumatic strongly recommend that babies and young children are prevented from being near to the appliance and not allowe to ...
-
Baumatic B47 - page 7
o Great care should be taken whils t using this appliance and when following the cleaning procedure. o You should not use a steam jet or any other high pressure cleaning equipment to clean the appliance. Installation This appliance must be correctly installed by a CORGI registered installer, strictly in accordance with the manufacturer’s instruct ...
-
Baumatic B47 - page 8
Specifications Product dimensions: Aperture dimensions: Height: 500 mm Height: 480 mm Width: 585 mm Width: 560 mm Depth: 35 mm Product specifications: o 1 x 3.00 kW rapid burner (B47, BG60, BG60TC, B60.1TCSS & B60.1SS) o 1 x 3.30 kW wok burner (BG61SS & BT61SS ) o 2 x 1.75 kW semi-rapid burners o 1 x 1.00 kW auxillary burner o Side control ...
-
Baumatic B47 - page 9
Gas details Connection: Rp ½ (ISO R7) Type: Natural Gas (20.9 mbar), alternative LPG G30 (28-30 mbar), town gas G110 – 120 (8 mbar) t o o r d e r . For future reference please record the following information which can be found on the rating plate and the date of purchase which can be found on your sales invoice. The rati ng plate of your hob is ...
-
Baumatic B47 - page 10
Using the gas hob Before first use IMPORTANT: You should clean the hob surface (see “Cleaning and maintenance” section). Turning the hob on The following symbols will appear on the control panel, next to each control knob: Black circle: gas off Large flame: maximum setting Small flame: minimum setting o The minimum setting is at the end of the ...
-
Baumatic B47 - page 11
o In case of power failure, the burners can be lit by carefully using a match. Turning the hob on (BG60TC and B60.1TCSS only) o This particular appliance is fi tted with a thermocouple safety device on each burner, which is de signed to stop the flow of gas to the burner head in the event of the flame going out. o To light a burner, press in and tu ...
-
Baumatic B47 - page 12
o Use flat bottomed pans only o When possible, keep a lid on the pan whilst cooking. o Cook vegetables with as little water as possible, to reduce cooking times. IMPORTANT: Always place pans centrally over the hob burners and position them so that the handles cannot get accidentally caught or knocked off. You should also make su re that the handle ...
-
Baumatic B47 - page 13
Cleaning the hob burners The hob burners should be cleaned on ce a week or more frequently if they get soiled. o IMPORTANT: Make sure that the hob surface, pan supports and hob burners have cooled before you attempt to touch them. o Remove the hob burners by pu lling them upwards and away from the hob top. o Soak them for about ten minutes in hot w ...
-
Baumatic B47 - page 14
Positioning The adjacent furniture must be able to withstand a minimum temperature rise of 85°C above the ambient temperature of the room it is located in, during periods of use. o This appliance can be located in a kitchen, a kitchen diner or a bed sitting room. IMPORTANT : The appliance must not be installed in a bathroom or shower room. This ap ...
-
Baumatic B47 - page 15
Unpacking the appliance When unpacking the appliance please check that the following items are contained within the packaging: 1 x Baumatic hob 2 x Pan supports 4 x Burner assemblies 1 x Installation and instruction manual 1 x Baumatic guarantee card 4 x Fixing screws 4 x Clamps 1 x Sealing strip 4 x LPG jets 1 x Self-adhesive label for amending th ...
-
Baumatic B47 - page 16
o Carefully turn the hob upside do wn and place it on a cushioned mat. o Apply the sealing strip (A) provided around the edge of the appliance. o The protective covering must be removed from both sides. o Do not leave a gap in the sealing agent or overlap the thickness. o IMPORTANT: Do not use a silicon sealan t to seal the appliance against the ap ...
-
Baumatic B47 - page 17
o Place the clamp (B) over the holes that match the size of the screws. There are one set of screw holes in each corner of the hob. Slightly tighten a screw (C) through the clamp (B) so that the clamp is attached to the hob, but so that you can still adjust the position of it. o Carefully turn the hob back over an d then gently lower it into the ap ...
-
Baumatic B47 - page 18
18 Ventilation requirements o The room containing the cooker should have an air supply in accordance with the current ed ition of BS 5440: Part 2: o The room must have opening windows or equivalent; some rooms may also require a permanent vent. o If the room has a volume between 5 and 10m³, it will require an air vent of 50cm² (effective area). U ...
-
Baumatic B47 - page 19
Gas Safety (Installation and Use) Regulations IMPORTANT: The appliance MUST be connected to the gas supply by use of a ½ BSP Elbo w, seal, copper pipe and an isolation tap fitted in an easily accessible position. o It is the law that all gas appliances are installed by competent persons in accordance with the current edition of the Gas Safety Inst ...
-
Baumatic B47 - page 20
Gas adjustment (Conversion to LPG) All work must be carried out by a CORGI registered engineer. IMPORTANT: Always isolate the cooker from the electricity supply before changing the in jectors and/or adjusting the minimum flow of the burners. o Remove the pan-stands, burners and flame spreaders (A) . o Unscrew the injector (B) and replace it with th ...
-
Baumatic B47 - page 21
Minimum flow adjustment for hob gas taps. All work must be carried out by a CORGI registered engineer. IMPORTANT: Always isolate the hob from the electricity supply before changing the injectors and/or adjusting the minimum flow of the burners. o Switch the burner on and set the knob at the minimum position. o Remove the knob from the tap and place ...
-
Baumatic B47 - page 22
Gas tap maintenance These maintenance operations MUST ONLY be carried out by a CORGI registered engineer. IMPORTANT: Before carrying out any maintenance operations, disconnect the appliance from th e gas and electricity supplies. If a gas tap becomes stiff to oper ate, then you should proceed as follows: o Remove the control knobs, pan supports, bu ...
-
Baumatic B47 - page 23
Electrical connection This appliance must be installed by a qualified person in accordance with the latest edition of the I.E.E. Regulations and in compliance with Baumatic’s instructions. Before connecting the appliance, ma ke sure that the supply voltage marked on the rating plate corresponds with your mains supply voltage. o Cable type: H05 RR ...
-
Baumatic B47 - page 24
My appliance isn’t working correctly IMPORTANT: If your appliance appears not to be operating correctly, then yo u should disconnect it from your mains supply and then contact the Baumatic Service Department on telephone number (0118) 933 6911. DO NOT ATTEMPT TO REPAIR THE APPLIANCE YOURSELF. Please note that if an engineer is asked to attend whi ...
-
Baumatic B47 - page 25
25 United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Sales Telephone (0118) 933 6900 Sales Fax (0118) 931 0035 Service Telephone (0118) 933 6911 Service Fax (0118) 986 9124 Spares Telephone (01235) 4372 44 Technical Advice Telephone (0118) 933 6933 E-mail: sales@baumatic.co.u k technical@baum ...
-
Baumatic B47 - page 26
26 ...
-
Baumatic B47 - page 27
27 ...
-
Baumatic B47 - page 28
28 ...
Hai una domanda su Baumatic B47?
Utilizza il modulo sottostante
Se non hai risolto il problema con Baumatic B47 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Baumatic B47 è probabile che voglia condividere il modo di risolverlo.