-
Weber Built-In LP Gas Grill - page 1
43165 US 01/30/07 LP G AS GRILL B uilt-In LP Gas Grill Installa tio n Guid e #43165 S-440 S-640 YOU MUST READ THIS O WNER’S GUIDE BEF ORE OPERA TING YOUR G A S GRILL DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open fl ames. 3. Open lid. 4. If odor continues, keep away from the appliance and immediately call y ...
-
Weber Built-In LP Gas Grill - page 2
2 WWW . WEBER.COM ® LOC A TING YOUR GRILL When determining a suitable location for your Summit ® gas grill installation, give attention to concerns such as exposure to wind, proximity to traffi c paths, and keeping any gas supply lines as short as possible. Never locate the Summit ® gas grill in a garage, breezeway , shed, under an unprotected ...
-
Weber Built-In LP Gas Grill - page 3
3 WWW . WEBER.COM ® 3 1 6 7 8 5 3 2 4 a c d b 1 1 1 3 2 b GENERAL CONSTRUCTION DET AILS Summit ® Built-In unit and all other accessory units should be on site before construction begins. All dimensions have a tolerance of plus or minus (+/-) 1 / 4 inch (6.35 mm). The grill frame rests directly on the Island Structure top fi nished surface. Make ...
-
Weber Built-In LP Gas Grill - page 4
4 WWW . WEBER.COM ® OR S-440 S-640 Lid - 1 Cookbox - 1 Lid - 1 Cookbox - 1 Front Frame Rail - 1 Rear Frame Rail - 1 Rear Panel Assembly - 1 Bottom Shelf - 1 Left Door - 1 Right Door - 1 W arming Rack - 1 Right Enclosure Panel - 1 Left Enclosure Panel - 1 Front V ent Panel - 1 Rear V ent - 1 P ARTS LIST ...
-
Weber Built-In LP Gas Grill - page 5
5 WWW . WEBER.COM ® 5 S-440 S-640 S-440 S-640 Flavorizer® Bars - 8 - 12 Stainless Steel Cooking Grates - 2 - 3 Collection T ray - 1 Catch-Pan Holder - 1 Catch-Pan - 1 Disposable Drip Pans - 2 Hinge Pin- 2 Hair Pin Cotter- 2 Corrugated gas line - 1 Right Front V ent Clip - 1 Left Front V ent Clip - 1 7/16 inch Wrench - 1 #10 Sheet Metal Screws - 5 ...
-
Weber Built-In LP Gas Grill - page 6
6 WWW . WEBER.COM ® 1 1 2 2 3 1 2 Arrow stickers on Frame Rail (1) and Left Side Panel (2) should point toward each other (shown above). Door Stop Bracket (3) should be positioned as shown (left). ASSEMBL Y ...
-
Weber Built-In LP Gas Grill - page 7
7 WWW . WEBER.COM ® 7 3 A TTENTION! Do not fully tighten screws. Clips should slide freely when installed. 4 ASSEMBL Y ...
-
Weber Built-In LP Gas Grill - page 8
8 WWW . WEBER.COM ® 5 6 Back ASSEMBL Y ...
-
Weber Built-In LP Gas Grill - page 9
9 WWW . WEBER.COM ® 9 7 ASSEMBL Y ...
-
Weber Built-In LP Gas Grill - page 10
10 WWW . WEBER.COM ® CAUTION: Use two people to lift and install the Summit ® Built-In frame assembly . A.) Lift the frame assembly into the “island” structure opening. Make sure the frame is resting level on the fi nished surface of the structure. B.) Adjust the Front V ent to rest squarely on ground. 8 B . A . 1 1 1 1 1 1 a a b CLEARAN ...
-
Weber Built-In LP Gas Grill - page 11
11 WWW . WEBER.COM ® 11 9 10 C . (1) S440 S640 C.) Apply a bead of silicone sealant (1) around the perimeter and front edges of the grill that are in contact with the “island” structure. This will prevent moisture seepage. The sealant you use must have a temperature rating above 120°F (48.8° C). 1/4” (6.35 mm) Drill Bit ASSEMBL Y ...
-
Weber Built-In LP Gas Grill - page 12
12 WWW . WEBER.COM ® F)'# S440 11 (1) (3) (2) 12 ASSEMBL Y ...
-
Weber Built-In LP Gas Grill - page 13
13 WWW . WEBER.COM ® 13 S640 S440 13 14 (1) (2) S640 S440 ASSEMBL Y ...
-
Weber Built-In LP Gas Grill - page 14
14 WWW . WEBER.COM ® S640 S440 a b c 15 Match Holder ASSEMBL Y ...
-
Weber Built-In LP Gas Grill - page 15
15 WWW . WEBER.COM ® 15 S640 S440 16 17 1/4” (6.35 mm) Drill Bit ASSEMBL Y ...
-
Weber Built-In LP Gas Grill - page 16
16 WWW . WEBER.COM ® S640 S440 18 19 20 S440 S640 S640 S440 ASSEMBL Y ...
-
Weber Built-In LP Gas Grill - page 17
17 WWW . WEBER.COM ® 17 ASSEMBL Y 21 S640 S440 ...
-
Weber Built-In LP Gas Grill - page 18
18 WWW . WEBER.COM ® (1) (2) (3) 22 S-440 S-640 ASSEMBL Y ...
-
Weber Built-In LP Gas Grill - page 19
19 WWW . WEBER.COM ® 19 + AAA + AAA + AAA a 23 - 1 S-440 S-640 - 2 - 2 S-440 S-640 - 4 S-640 The Weber Grill Out ™ Handle Light has a “T ilt Sensor”: Lid up - ON / Lid Closed - OFF . The power button (a) activates or deactivates the “T ilt Sensor .” For daytime use, deactivate the sensor by pressing power button (a) . ASSEMBL Y ...
-
Weber Built-In LP Gas Grill - page 20
20 WWW . WEBER.COM ® T able 10-1 Maximum Capacity of Pipe in Cubic Feet of Gas per Hour for Gas Pressures of 0.5 psi or Less and a Pressure Drop of 0.3 Inch W ater Column. (Based on a 0.60 Specifi c Gravity Gas) Nominal Iron Pipe Size (Inches) Internal Diameter (Inches) Length of Pipe (Feet) 10 20 30 40 50 60 70 80 90 100 125 150 175 200 1/4 .364 ...
-
Weber Built-In LP Gas Grill - page 21
21 WWW . WEBER.COM ® 21 GAS LINE PIPING • Refer to the piping chart at the bottom of previous page. • The corrugated gas line from the manifold is 58 inches (1,473.2 mm) long. Do not extend the gas line. • We have provided the means to make an SAE 45° fl are connection. Do not use pipe sealant on this connection. • If the length of line ...
-
Weber Built-In LP Gas Grill - page 22
22 WWW . WEBER.COM ® OPERA TING W ARNING: Only use the Weber ® T ank Enclosure Kit outdoors in a well-ventilated area. Do not use in a garage, building, breezeway or any other enclosed area. W ARNING: Y our Weber ® T ank Enclosure Kit shall not be used under an unprotected combustible roof or overhang. W ARNING: Y our Weber ® T ank ...
-
Weber Built-In LP Gas Grill - page 23
23 WWW . WEBER.COM ® 23 LOC A TING YOUR LP T ANK ENCL OSURE KIT When determining a suitable location for your LP T ank Enclosure Kit installation, give attention to concerns such as proximity to traffi c paths, and keeping any gas supply lines as short as possible. Never locate the Summit ® LP T ank Enclosure Kit in a garage, breezeway , shed, u ...
-
Weber Built-In LP Gas Grill - page 24
24 WWW . WEBER.COM ® 4 8 4 1 2 4 2 2 P ARTS LIST 2 Hose and regulator - 1 T ank stand - 1 T ank stand base - 1 T ank Scale - 1 1/4-20 nut - 6 Nylon washer - 12 1/4-20 x 1/2” bolt - 6 Cylinder glide - 2 1/2” Flare Gasket - 2 3/8” Flare Gasket - 2 P ARTS LIST / ASSEMBL Y ...
-
Weber Built-In LP Gas Grill - page 25
25 WWW . WEBER.COM ® 25 MOUNTING THE LP T ANK BRACKET Mount the LP tank bracket to the right hand side of the enclosure opening using non corrosive hardware. Mounting holes are provided on the sides and bottom of your LP tank bracket. Be sure to mount the bracket securley to the enclosure before use. MOUNTING HARDW ARE NOT INCL UDED. MOUNTING THE ...
-
Weber Built-In LP Gas Grill - page 26
26 WWW . WEBER.COM ® A B C D E i ii iii iv v CONNEC T GAS SUPPL Y A 58 inch (1,473.2 mm) corrugated gas line is supplied with the grill. This line needs to pass through the gas inlet opening to the main gas supply . 1) Connect the corrugated gas line to the manifold located on the right hand side of grill under the control panel. Use the 1/2” ? ...
-
Weber Built-In LP Gas Grill - page 27
27 WWW . WEBER.COM ® 27 VENTILA TION W ARNING: Air holes must be provided in the structure at the top and bottom to provide ventilation in the event of a gas leak. Air holes can be located in a low visibility area and should be protected by screening material to prevent rodents and insects from entering the structure. Air holes will also help ...
-
Weber Built-In LP Gas Grill - page 28
©2007 The following trademarks are registered in the name of W eber-Stephen Products Co., an Illinois corporation, located at 200 East Daniels Road, Palatine, Illinois 60067 U.S.A. Australia; Smokey Joe, Weber , Kettle Silhouette ® , Genesis, Austria; Kettle Silhouette ® , Smokey Joe, Weber , Benelux; Kettle Silhouette ® , Smokey Joe, Weber , C ...
Hai una domanda su Weber Built-In LP Gas Grill?
Utilizza il modulo sottostante
Se non hai risolto il problema con Weber Built-In LP Gas Grill con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Weber Built-In LP Gas Grill è probabile che voglia condividere il modo di risolverlo.