Italiano dropdown-ico

Manuale per l’uso Microsoft LC2000

22 pagine 0.39 mb
Scarica

Vai alla pagina of 22

Summary
  • Microsoft LC2000 - page 1

    Micr osoft Small Business Server 2000 Installation Guide fo r HP NetServers E60, E800, LC2000, and HP Server tc3100, and tc4100 NOT ICE: The inform ation in this document w as last update d for the HP NetServer Navigator CD-ROM ver sion M.04.05. If y ou don't hav e the M.04.05 version C D-ROM and y ou're obta ining this docum ent from the ...

  • Microsoft LC2000 - page 2

    Tip #3. Upgrading Small Business Server 2000 from Uniprocessor HAL to Multiprocessor HAL Tip #4. Small Business Serv er 2000 Driver Signat ures Tip #5. Upgrading D5013B NIC Drivers for Small Business Server 2000 Tip #6. Installation Fails to B oot after First Reboot Tip #7. Small Business Server 2000 Recover y Opt ions Tip #8. Terminal Server Servi ...

  • Microsoft LC2000 - page 3

    · One or more hard drives. · Latest system BIOS update. (http://www.hp.com) · Two or more clients for t e sting purpose. (Optional) · HP Driver's diskette if installing devices that have no drive rs included in the Small Business Server 2000 CD-ROM. Example: HP NetRA I D-4 M, HP Fiber Ch annel adapter (Optional), etc. (This driver's d ...

  • Microsoft LC2000 - page 4

    Computer Name: ______________________ Admin Password: _____________________ Date Time Zone: ______________________ Workgroup or Domain Name: ______________ Registration Key: ____________________________ Installation Methods There are s everal ways of installing Small Busi ness Server 2000. The most popular methods are listed below. Select a method ...

  • Microsoft LC2000 - page 5

    Manual Installation Creating the Driver s Diskette Before y ou be gin, use one of the followin g two methods that can be used to creat e the drivers diskette. One method is to create the drivers di skette using a system booted from the Navigator CD. The other method is to create th e drivers di skette using a system that is running Windows NT, Smal ...

  • Microsoft LC2000 - page 6

    · If you want to start the setup by booting di rectly off the Small Business Server 2000 CD (supported for all NetServers), pro ceed to th e following section "Installing Small Business Server 2000." Creat ing Setup Diskettes If you opt for starting the Small Business Server 2000 installation from Setup Diskettes, do the following: 1. Yo ...

  • Microsoft LC2000 - page 7

    NOTE: If the boot device driver is not included on the Small Business Server 2000 CD- ROM, for exampl e the "HP NetRA ID-4M", then do t he following steps aft er pressing F6 a) Press S to select additional hardware. b) Select Other and press Enter . c) When prompted to insert driver diskette , please i nsert the target ad apter driver &ap ...

  • Microsoft LC2000 - page 8

    15. Note: If you see a dialog box titled "Digital Signature Not Found". Please click "Yes" to continue the installati on and read Tip #4 in the trouble shooting section of this guide . 16. Click Next at the reg ional Settings scre en. 17. At the Personalize You r Softwa re screen, enter a name and organization . Then click Nex t ...

  • Microsoft LC2000 - page 9

    2. Click Prop e rti es . This brings up the "System Properties" panel. 3. Click the Hardw are tab. 4. Click the Device Manag er… button. 5. Verify that no devices have either a yellow ba nd (!) or question mark (? ) symbol next to it. (See followin g note for poin ter to excepti ons) Yellow ( ! ) means that there is a resourc e issue wi ...

  • Microsoft LC2000 - page 10

    1. Click Start | Programs | Administrative Tools | Computer Managemen t . 2. If necessary click the + sign next to Storage to open this folder. 3. Double click Disk Management . 4. The "Write signa ture and Upgrade" wizard will start if you ha ve new hard drives with no signatures on them. 5. Follow the instructions provided by the wiza r ...

  • Microsoft LC2000 - page 11

    10. Open a command prompt window to verif y th e TC P/IP configuration. Enter the command: ipconfig /a ll You should get a display showing the conf iguration information y ou entered above. 11. Test the link by entering the following at the comm and prompt: ping computername Where com puternam e is the server name. You should get four reply's ...

  • Microsoft LC2000 - page 12

    7. Click Next . The system will take a few minutes with the hour clock on th e display before moving to next screen. 8. Click Next at the "Net BIOS Domai n Name" dialo g box to accept d efault " Domain NetB IOS name:" 9. Click Next to accept "Database and Log Locati ons" def ault values: Database Location: C:WINNTNTD ...

  • Microsoft LC2000 - page 13

    Tip #1. Up grading f rom SBS 4.0 t o Small Busi ness Server 2 000 It is possible to upgrade from any edition of NT 4. 0 including Terminal Server to Small Business Server 2000. Please refe r to the readme.doc on th e Small Business Server 2000 CD and the Small Business Server 2000 Setup Guide for in formation on how to perform the upgrades. Tip #2. ...

  • Microsoft LC2000 - page 14

    5. Click "Display a list of known drivers for this device", and then click "Sho w all hardware of this device cl ass". 6. Click the appropr iate computer t y pe (one that matches your curr ent t ype , except for multiple CPUs), click Next , and then click Fin is h . Tip #4. Small B usiness Server 2000 Dr iver Signatures Small Bu ...

  • Microsoft LC2000 - page 15

    5. At the prompt "What do y o u want the wizard to do?", select the "Sea rch for a suitable driver for my device" radio button, and click Next . 6. Select the appropriate me dia checkbox and click nex t. 7. Select the "Install one of the othe r drivers" check box and click Nex t. 8. Select the driver on the fl oppy dri ...

  • Microsoft LC2000 - page 16

    2. Networking disab led. Includes networks services and drivers. 3. Directory se rvices restore mode. Brings system up with director y servi ces disabled with the intent of recovering activ e directory. Safe mode boot is guided by the registry key hklmCurrentControlSetControl Safe Boot w ith the use of the Minimal and Network subkeys. The IOMang ...

  • Microsoft LC2000 - page 17

    8. Type exit when done troubleshooting. Installing RC 1. Insert Small Business Server 2000 CD-ROM. If CD-ROM auto-start is enabled, click exit to close the applet. 2. Open a command prompt and type D:I386WINNT32 /CMDCONS and press Enter . (Where D: is the CD-ROM drive le tter.) 3. Follow the screen instructions to complete the RC installation. Bo ...

  • Microsoft LC2000 - page 18

    Answer: Table 6, provid ed in the appendix of this document provides a list of Disk Arra y BIOS/Firmware versions used to test with Small Business Server 2000. HP recommends that you use the version indicated in this table or a later rele ase. Question: Where do I get the driver's required to run Small Business Server 2000? Answer: The initial ...

  • Microsoft LC2000 - page 19

    E60 Yes Yes Yes E800 Yes Yes Yes LC2000 Yes Yes Yes tc3100 Yes Yes Yes tc4100 Yes Yes Yes Table #2 List of embedded SCSI chip set for each NetServ er. (Note: See "Table #6" fo r a list of tested a nd supported s y st em under Small Business Server 2000) Model SCSI Adapter Ultra SC SI/ Channel A,B E60 Adaptec 7895 (Wide)/A,B E800 Symbios 8 ...

  • Microsoft LC2000 - page 20

    * The driver is not provided b y Hewlett-Packard. Users should use the dri ver bundled with Windows NT CD-ROM. Note: Video adapters wit h 1M can be upgraded to 2M. Table #4 This table provides a list of CD -ROM type for eac h NetServer. ( Note: See "Table #6" fo r a list of tested a nd supported s y st em under Small Business Server 2000) ...

  • Microsoft LC2000 - page 21

    III (1.2- 1.4 GHz) tc4100 N/A Dual Pentium III (1.2- 1.4 GHz) 4G ATIRage XL PCI TBD Yes TBD Table #6A This table provides a list of Disk Array Adap ters tested with Sm all Business Server 2000. Adapter P/N BIOS Firmware Win 2K Support Max Boot Drive Si ze (1) NetRaid-4M D9161A V2.4-0 N/A Yes N/A NetRaid-2M P3411A G.01.02 H.01.07 Yes N/A NetRaid-1M ...

  • Microsoft LC2000 - page 22

    tc3100 No No No No Yes Yes No tc4100 No No No No Yes Yes Yes Table #6C List of NeRAID-4M, 2M and 1M adapters supported with Small Business Server 2000. Model Max 4Ms Support ed Max 2Ms Support ed Max 1Ms Support ed Slotting preferen ces E60 None 3 6 N/A E800 None 3 6 N/A LC2000 2 3 6 Slots 5-6 because 5- 6 are 64 bit slots, 1-4 are 32 bit slots, an ...

Fabbricante Microsoft Categoria Server

I documenti che otteniamo dal fabbricante del dispositivoMicrosoft LC2000 possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Microsoft
- manuali per l’uso LC2000
- schede prodotto Microsoft
- opuscoli
- o etichette energetiche Microsoft LC2000
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Microsoft LC2000.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Microsoft LC2000, manuali di manutenzione, brevi manuali o manuali utente Microsoft LC2000. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Microsoft LC2000.

Manuali per l’uso simili

Manuale completo del dispositivo Microsoft LC2000, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Microsoft LC2000 dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Microsoft LC2000.

Il manuale per l’uso completo Microsoft, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Microsoft LC2000 - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Microsoft LC2000, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Microsoft LC2000 che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Microsoft LC2000 - che ci dovrebbe aiutare nei primi passi durante l'uso Microsoft LC2000
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Microsoft LC2000
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Microsoft LC2000 in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Microsoft LC2000?

Utilizza il modulo sottostante

Se non hai risolto il problema con Microsoft LC2000 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Microsoft LC2000 è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Captcha
Nuova immagine

Commenti (0)