-
JVC UX-T550 - page 1
Enter belo w the Model No . and Serial No . which are located either on the rea r, bot- tom or side of the cabine t. Retain this information for future ref erence. VICTOR COMPANY OF JAPAN, LIMITED UX-T550 MICRO COMPONENT SYSTEM UX-T151/T150 MICRO COMPONENT SYSTEM INSTRUCTIONS Printed in China 1000MZMCREJSC NEDERLANDS ESPAÑOL DEUTSCH ENGLISH GNT000 ...
-
JVC UX-T550 - page 2
G-1 IMPORTANT (In the United Kingdom) Mains Supply (AC 230 V Ó , 50 Hz only) DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace t ...
-
JVC UX-T550 - page 3
G-2 SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been disigned and manuf actured to meet international safety standards b ut, lik e any electrical equipment, care must be tak en if you are to obtain the best results and saf ety is to be assured. Do read the operating instructions before y ou attemp ...
-
JVC UX-T550 - page 4
1 Thank you for purchasing this JVC product. Please read these instructions carefully before starting operation to be sure to obtain optimum performance and a longer service life from the unit. CONTENTS Features ..................................................................... 1 Handling precautions ............................................. ...
-
JVC UX-T550 - page 5
2 CONNECTIONS ● Do not switch the power on until all connections are completed. Antenna connection and adjustment ● AM (MW/L W) loop antenna adjustment ● Keep the loop antenna away from the unit and install it so that the best reception is obtained. (Do not leave the antenna wire in a bundle.) Ó AC IN RIGHT R L LEFT DC IN 12V — FM AM LOOP ...
-
JVC UX-T550 - page 6
3 ● Attaching the speaker g rille Notes: ● The polarity of the two connected speakers will be the same if the blac k speaker cords are connected to the · terminals. If the speak- ers are connected with polarities rev ersed, stereo eff ect and tone will be degraded. ● The speakers of this unit are not magnetically shielded. When they are plac ...
-
JVC UX-T550 - page 7
4 PO WER SUPPL Y A. Connection of AC po wer cord ● Connect the AC po wer cord after all other connections hav e been made. CA UTIONS: 1. ONL Y USE WITH JVC POWER CORD PRO VIDED WITH THIS UNIT TO A VOID MALFUNCTION OR D AMAGE T O THE UNIT . 2. BE SURE T O UNPLUG THE PO WER CORD FROM THE OUT - LET WHEN GOING OUT OR WHEN THE UNIT IS NO T IN USE FOR ...
-
JVC UX-T550 - page 8
5 NAMES OF P ARTS AND THEIR FUNCTIONS CD player/General section ~ button and po wer ST ANDBY indicator Ÿ AUX button ! Remote sensor section ⁄ Display window 1 Function/T rac k number display 2 Play time display 3 Music calendar display 4 Program mode indicator (PROGRAM) 5 RANDOM play indicator 6 Repeat pla y indicator ( ALL) 7 OVER indicator @ V ...
-
JVC UX-T550 - page 9
6 REMO TE CONTROL UNIT Preparation before use ● Installing batteries in the remote control unit 1. Remove the battery cover from the back of the remote control unit. 2. Insert two “R6/AA (15F)” size batteries. ● Inser t the batteries with the ª and · ter minals matching the indication inside the battery compar tment. 3. Replace the cov er ...
-
JVC UX-T550 - page 10
7 One touch operation (COMPU PLA Y) Even when the po wer is set to ST ANDBY , pressing the b utton shown below s witches on the power and selects the source. V OLUME buttons + : Use to increase the volume. – : Use to decrease the volume. (Control range from VOLUME 0 to VOLUME 50.) BASS/TREBLE b uttons (using the remote control unit) T o set the b ...
-
JVC UX-T550 - page 11
8 Skip play ● During play , it is possible to skip f orward to the beginning of the ne xt track or back to the beginning of the track being played or the previ- ous track; when the beginning of the required track has been located, play starts automatically . T o listen to the ne xt track... Press the ¢ button once to skip to the beginning of the ...
-
JVC UX-T550 - page 12
9 Programmed pla y (using the remote control unit) ● Up to 20 trac ks can be programmed to be play ed in any required order . The total playing time of programmed tracks is displayed (up to 99 minutes, 59 seconds). (Example: When programming the 2nd track to be played first, and the 6th track next, then the 12th track, etc.) ~ Press the CD 3 / 8 ...
-
JVC UX-T550 - page 13
10 COMPACT DIGITAL AUDIO BAND ONE TOUCH REC TAPE OPEN CD TUNER TIMER/SNOOZE STANDBY AUX MICRO COMPONENT SYSTEM UX-T550 VOLUME M U L T I J O G ACTIVE HYPER BASS PRO SLEEP 12 3 4 7 10 8 +10 AUX 9 6 5 AUTO PRESET DISPLAY PROGRAM RANDOM REPEAT BEAT CUT REVERSE MODE STEREO AUTO/MONO MULTI CONTROL BASS AHB.PRO TREBLE REW FF VOLUME TAPE TUNER BAND C D CLO ...
-
JVC UX-T550 - page 14
11 Operate in the order sho wn RADIO RECEPTION ~ Press the TUNER/BAND button. ● The power is switched on and a band and radio frequency will be shown in the displa y . Ÿ Select the band. ! T une to the required station. ⁄ Adjust. STEREO A UT O/MONO button (using the remote control unit) Notes: ● When seek tuning to the required station is no ...
-
JVC UX-T550 - page 15
12 ~ Load a cassette with side A f acing out. (Wind past the tape leader before starting recording.) Ÿ Load a CD and close the CD holder . ! Set to the CD mode. ⁄ Press the 7 button to set stop mode. @ Select the required reverse mode ( or ). ● When programmed play is required, program the required tracks using the remote control. (See page 9. ...
-
JVC UX-T550 - page 16
13 CLOCK ADJUSTMENT Names of parts in the clock/timer section, and their functions: ~ Timer mode indicator Ÿ Timer indicator (ON/OFF) ! CLOCK indicator ⁄ SLEEP indicator @ Time display ¤ CLOCK button # TIMER/SNOOZE button ‹ MUL TI JOG dial It is used to set the current time and perf or m timer setting. BEA T CUT button (using the remote contr ...
-
JVC UX-T550 - page 17
14 TIMER OPERA TIONS Setting the timer ● The current time must be set before the timer can be used. ~ Press the TIMER/SNOOZE button f or 2 seconds or more. Ÿ Set the start time. (Example: T o set the timer to 12: 15.) ! Set the stop time. (Example: T o set the timer stop timer to 13: 15.) ⁄ Select the TIMER mode ● The selected TIMER mode is ...
-
JVC UX-T550 - page 18
15 Timer recording of br oadcast ● The current time must be set bef ore the timer can be used. ● Make sure that the saf ety tabs of the cassette hav e not been broken off. Operations ~ Set the button to ON. Ÿ Load a cassette. ● Inser t the cassette with the side to be recorded f acing out. ● Select the required re verse mode. ( or ) ! Set ...
-
JVC UX-T550 - page 19
16 SLEEP ● Sleep time settings of 30, 60, 90 or 120 minutes can be set. When you release the SLEEP button, the source is displayed after 5 sec. ● The sleep timer operation will start and the power will be switched off after the specified time. ● Checking the sleep time When the SLEEP button is pressed, the remaining sleep time is dis- played. ...
-
JVC UX-T550 - page 20
Enter belo w the Model No . and Serial No . which are located either on the rea r, bot- tom or side of the cabine t. Retain this information for future ref erence. VICTOR COMPANY OF JAPAN, LIMITED UX-T550 MICRO COMPONENT SYSTEM UX-T151/T150 MICRO COMPONENT SYSTEM INSTRUCTIONS Printed in China 1000MZMCREJSC NEDERLANDS ESPAÑOL DEUTSCH ENGLISH GNT000 ...
Hai una domanda su JVC UX-T550?
Utilizza il modulo sottostante
Se non hai risolto il problema con JVC UX-T550 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con JVC UX-T550 è probabile che voglia condividere il modo di risolverlo.