Manuale per l’uso Teac 35XX

24 pagine 1.2 mb
Scarica

Vai alla pagina of 24

Summary
  • Teac 35XX - page 1

    Co v er s All 35xx and 36xx Series R emote Star ter s -The system must be placed into Service Mode before any service work is started on the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts no liability or responsibility for accidental starting of the vehicle. - CARBON MONOXIDE - Neve ...

  • Teac 35XX - page 2

    T a ble of Contents INST ALLATION MANUAL REMOTE V EHICLE ST ARTER Page 2 T able of Content s Page 2 Pre-Inst allation Page 3 Components Feature List Pre-Installation Inst allation Procedures Page 4 Wiring Diagrams Page 5-6 Wire Description Page 7-8 6 Pin Connector 14 Pin Connector Auxiliary Connectors Jumper Positions Quick S t art Inst all Page 9 ...

  • Teac 35XX - page 3

    R ecommended Pr e-Installation Procedur es F ea ture List - Control module - 2way & 1way remote transmitter - Antenna with built in - 6 pin main harness Program Button - 14 pin harness - 4 pin harness - 2 pin Harness - 3 pin keyless entry harness - T emperature Sensor (L T Models) - Hood pin safety switch - Installation and Owner Manuals Remote ...

  • Teac 35XX - page 4

    R ecommended Installation Procedur es Under Hood Connections - Route the hood pin and tach wire through the firewall into the engine compartment. If possible route the wires through a factory rubber grommet. If drilling a hole through the firewall, BE CAREFUL . Always check for obstructions on both sides of the firewall. After drilling, use a snap ...

  • Teac 35XX - page 5

    REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Page 5 W iring Diag r am- 35xx Series T emperature Sensor Input (L T Series) S tarter Output (+) 30amp Output (+) 30amp Output (+) 30amp Input (+) 30amp Input (+) 30amp Output (-)500ma Output (-)500ma Output (-)500ma Output (-)500ma Output (-)500ma Output Negative Input Negative Input Positive Input Pos ...

  • Teac 35XX - page 6

    Page 6 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER Module Side V iew J umper Selections 12 3 The jumpers control the output from the White wire on the 6- pin harness. This is a 30amp relayed output . T o change the output of the wire access the jumpers by sliding the plastic cover of f the top of the case. Move the jumper to one of the following ...

  • Teac 35XX - page 7

    Page 7 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL 6-pin Description T est For Wire 1-Y ellow 30amp S tarter Output This wire will test 0volts in of f, accessory and in the ignition position.12volts during st art only . 2-Green 30amp Heat/Acc Output This wire will test 0volts in the of f position 12- 14volts in the accessory and run positions and ...

  • Teac 35XX - page 8

    Page 8 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER 14 Pin Connector - Continued F r om Pr e vious Page 1-Green Door Lock Door Lock Output - Programmable Menu 1 Setting 3. 2-Red 12vlt Output Output For Door Lock Module Only! 3-Blue Door Unlock Door Unlock Output - Programmable Menu 1 Setting 3. 4-Pink 2nd Unlock Output when Unlock button is press ...

  • Teac 35XX - page 9

    Page 9 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Step 1 - Connect All Of the F ollowing W ir es 6 Pin P ow er Connector Y ellow 30amp S t arter Output 12volts during st art position only . Green 30amp Heater Output 12volt s in the accessory position off during start and 12volts during run. Red 30amp Power Input Constant 12volt power at ignition ...

  • Teac 35XX - page 10

    Page 10 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER Manual T r ansmission “M” Models Never install an automatic transmission remote starter into a manual transmission vehicle!!! Doing so may result in serious injury or death. Do not install remote starters in convertible vehicles! The following wires must be connected In addition to the basic ...

  • Teac 35XX - page 11

    Page 1 1 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Auto T ac h Lear n 1) T urn the ignition key to the “ON” position. (The park light s will turn on*). 2) S tart the vehicle with the key , The LEDs on the antenna will turn on if a proper t ach signal is detected**, then after 30-35 seconds the p ark lights will flash and the horn (Optional) ...

  • Teac 35XX - page 12

    Page 12 INST ALLATION MANUAL REMOTE V EHICLE S T ARTER Impor tant T ac h Notes T ach Learning the remote st arter is one of the most important step s in the installation process. Do not tach learn vehicle while the engine is in high idle. T o ensure the best possible tach setting, ensure that the vehicle is at low idle/ normal operating RPM. V ehic ...

  • Teac 35XX - page 13

    Page 13 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Entering Pr og r am Mode 1) With the ignition in the OFF position, turn the ignition key from “Of f” to “On” 3 times, ON-OFF-ON-OFF-ON within three seconds. (Leave the key in the ON position) 2) Press and release the Program Button located on the antenna. The park light s will flash and ...

  • Teac 35XX - page 14

    Page 14 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER System R eset Quic k View Pr og r amming * See the following p ages for more det ailed programming instructions. Menu 1 -Press Lock 1 Flash 2 Flashes 3 Flashes 1 Ignition Lock Enabled Lock Only Disabled 2 Horn Honk T ype 1 T ype 2 All Honks 3 Lock&Unlock Double Unlock 3 second .75 second 4 U ...

  • Teac 35XX - page 15

    Page 15 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Ignition ON-OFF-ON-OFF-ON Press & Release Program Button Press Lock Button Setting 1 Ignition Auto Lock 1) Ignition Lock & Unlock Enable 1 Flash/Honk Doors Lock/Unlock with Ignition key . 2) Ignition Lock Only 2 Flashes/Honks Doors Lock when ignition is turned ON only . *3) Ignition Auto ...

  • Teac 35XX - page 16

    Page 16 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER Menu 2- Additional Settings Ignition ON-OFF-ON-OFF-ON Press & Release Program Button Press Unlock Setting 1 Secure V alet Mode - Length of time required to set the system into Service Mode 1) Secure V alet 1 Flash/Honk Hold the Program Button for 15 seconds *2) Normal V alet 2 Flashes/Honks ...

  • Teac 35XX - page 17

    Page 17 REMOTE V EHICLE S T ARTER INST ALLATION MANUAL Menu 3- Star ter Settings Ignition ON-OFF-ON-OFF-ON Press & Release Program Button Press S t art Button Setting 1 S pecial Door Lock/Unlock Operations (Factory Alarm Rearm) . 1) T ype 1 1 Flash/Honk Unlock pulse before start. Lock pulse af ter start and on shut down. 2) T ype 2 2 Flashes/Ho ...

  • Teac 35XX - page 18

    Page 18 INST ALLATION MANUAL REMOTE V EHICLE S T ARTER Menu 3- Star ter Settings - Continued F r om Pr e vious Page Setting 5 Maximum Crank T ime 1) 10 Seconds 1 Flash/Honk 10 sec max time that the st arter will st ay engaged. 2) 3 Seconds 2 Flashes/Honks 3 sec max time that the st arter will st ay engaged. *3) 5 Seconds 3 Flashes/Honks 5 sec max t ...

  • Teac 35XX - page 19

    Page 19 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Menu 4- T ach Settings Setting 1 Auto T ac h Lear n. 1) Perform a System Reset. See p age 15. 2) T urn the ignition key on. (Park lights will turn on). 3) S tart the vehicle, the LEDs on the antenna will come on when a proper tach signal is detected*. 4) After approximately 30-35 seconds the p a ...

  • Teac 35XX - page 20

    Page 20 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER A TTENTION: TO A VOID SERIOUS INJUR Y , this remote st art system must be set into Service Mode before any under hood servicing is st arted. Service Mode will prevent the vehicle from st arting while the vehicle is being serviced. It is the sole responsibility of the vehicle’ s owner to place ...

  • Teac 35XX - page 21

    Page 21 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL T r ansmitter Pr og r amming Ste p 1 - Within 3 seconds turn the ignition ON-OFF-ON-OFF-ON - Leaving Key ON Ste p 2 - Press and hold the Program Button - The park light s will turn ON and the siren will chirp once.* Continue to hold the Program Button , the park light s will turn off and the sir ...

  • Teac 35XX - page 22

    87 86 85 87a 30 87 86 85 87a 30 Lock Un lock V ehicle Lock/Unlock Switch T o Control Relay or Actuator Green Fused +12V Blue Ground Ne gativ e T ype Door Locks 250ma Ne gativ e Door Loc ks (Mor e T han 250ma) P ositiv e Type Door Loc ks Note: When installing relays always use a fused power source. Blue Green Lock Un lock V ehicle Lock/Unlock Switch ...

  • Teac 35XX - page 23

    87 86 85 87a 30 87 86 85 87a 30 Blue Green Lock Un lock Ve hicle Lock/Unlock Switch T o Actuator Fused +12V x x Cut Cut 87 86 85 87a 30 Ground DIA GNOSTICS 13 87 86 85 87a 30 87 86 85 87a 30 Blue Green Lock Un lock T o V acuum Pump Fused +12V x Cut Ground Page 23 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL 5 W ir e / R e v er se Polarity T ype Do ...

  • Teac 35XX - page 24

    DIA GNOSTICS If the remote starter does not activate when the st art button is pressed the park light s will flash a diagnostic to indicate what shutdown input has been triggered. For example when the start button is pressed the p ark lights flash 3 times slowly . Looking at the chart below this would indicate that the system is in Service Mode, si ...

Fabbricante Teac Categoria Remote Starter

I documenti che otteniamo dal fabbricante del dispositivoTeac 35XX possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Teac
- manuali per l’uso 35XX
- schede prodotto Teac
- opuscoli
- o etichette energetiche Teac 35XX
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Teac 35XX.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Teac 35XX, manuali di manutenzione, brevi manuali o manuali utente Teac 35XX. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Teac 35XX.

Manuali per l’uso simili

Manuale completo del dispositivo Teac 35XX, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Teac 35XX dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Teac 35XX.

Il manuale per l’uso completo Teac, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Teac 35XX - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Teac 35XX, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Teac 35XX che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Teac 35XX - che ci dovrebbe aiutare nei primi passi durante l'uso Teac 35XX
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Teac 35XX
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Teac 35XX in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Teac 35XX?

Utilizza il modulo sottostante

Se non hai risolto il problema con Teac 35XX con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Teac 35XX è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Commenti (0)